iHome iDM12
Contents
1. battery Leakage or deterioration of the battery may occur if this warning is not heeded Never expose the battery to any liquid e Never expose the battery to excessive heat such as direct sunlight or fire Never use the battery pack in an unventilated vehicle where excessive internal temperatures may be encountered e Always keep the battery out of the reach of infants and small children p Consumer Product Safety Guide IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner this unit has been designed and manufactured to ensure your personal safety However improper use can result in potential electrical shock or fire hazards Please read all safety and operating instructions carefully before installation and use and keep these instructions handy for future reference Take special note of all warnings listed in these instructions and on the unit 1 Water and Moisture The unit should not be used near water For example near a bathtub washbowl kitchen sink laundry tub swimming pool or in a wet basement 2 Ventilation The unit should be situated so that its location or position does not interfere with its proper ventilation For example it should not be situated on a bed sofa rug or similar surface that may block ventilation openings Also it should not be placed in a builtin installation such as a bookcase or cabinet which may impede the flow of air through the ventilation openings2. 3 Heat The unit should be situated away from heat sources such as radiators heat registers stoves or other appliances including amplifiers that produce heat 4 Power Sources The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance 5 Power Cable Protection Power supply cables should be routed so that they are not likely to b walked on or pinched by items placed upon or against them It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket 6 Cleaning The unit should be cleaned only using a warm damp cloth Do not use solvents etc 7 Objects and Liquid Entry Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product 8 10 11 12 13 Att Lig achments Do not use attachments not recommended by the product manufacturer htning and Power Surge Protection Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time This will prevent damage to the product due to lightning and powerline surges Overloading Do not overload wall sockets extension cords or integral convenience receptacles as Da A B C D E his can result in a risk of fire or electric shock mag
3. e Requiring Service The unit should be serviced by qualified service personnel when he power supply cable or plug has been damaged objects have fallen into or liquid has been spilled into the enclosure he unit has been exposed to rain he unit has been dropped or the enclosure damaged he unit exhibits a marked change in performance or does not operate normally Periods of Nonuse If the unit is to be left unused for an extended period of time such as a month or onger the power cable should be unplugged from the unit to prevent damage or corrosion Servicing The user should not attempt to service the unit beyond those methods described in th user s operating instructions Service methods not covered in the operating instructions should be referred to qualified service personnel Questions Visit www ihomeintl com Troubleshooting Unit doesn t respond no power Make sure unit is completely charged Check that all connections are correct and properly plugged in Make sure your device is properly paired with the IDM 12 Trouble pairing device computer with iDM 12 Bluetooth implementation varies depending on your computers hardware and operating system Please see our website for updates on pairing e Make sure you have the latest firmware for your iPad iPhone or iPod update via iTunes if needed e Make sure your device is working properly Check your device s manual for detail
4. een light flashes while the unit is charging and glows steadily when unit is fully charged If unit is not powered on when micro USB plug is connected the green light flashes once to indicate unit is charging Using the iDM12 NOTE When unit is on and not connected to power source flashing green light indicates battery needs charging Using the iDM12 Using Bluetooth Pairing Your Device NOTE See the iDM12 Bluetooth Connection Guide for complete pairing details 1 Move the Bluetooth Aux Switch to the Bluetooth position left 2 Press and hold the Power Button to turn on the unit release when green light appears 3 Turn on Bluetooth capability on your device and make it discoverable see your device s instructions to add or setup a Bluetooth device 4 Press and hold the Play Pause Pairing Button on the iDM12 until an amber light flashes on front of the unit and it beeps twice to indicate pairing attempt The amber light will flash while the unit attempts to pair If your device asks for a password enter 1234 on he keyboard of your device lf no device is paired within 3 minutes he unit will power off If this occurs retry steps 2 4 5 Once paired with a device the amber light will glow steadily then urn green There should be an indication on your device that pairing is complete On some devices you must then select use as a stereo audio device or similiar on the device s Bluetooth menu Once pa
5. es an internal rechargeable lithium ion battery that should last the lifetime of the device If you suspect your battery may be dead try charging it several times If the battery does not recharge please contact us for repair information WARNING DISPOSAL OF UNIT Please do NOT attempt to change the battery yourself If the battery has died and you do not want us to replace your battery you should follow the disposal instructions below e Never dispose of used batteries electronics with ordinary solid wastes since they contain toxic substances e Always dispose of used batteries electronics in accordance with the prevailing community regulations that apply to the disposal of batteries electronics If there are no local regulations concerning battery electronics disposal please dispose of the device in a waste bin for electronic devices e Many electronics retailers now recycle batteries and other electronic components at no charge Check to see which ones in your area do so CAUTION The battery used in this device may present a risk of fire explosion or chemical burn if mistreated e Never use or charge the battery if it appears to be leaking discolored deformed or in any way abnormal e Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other electrolytic substance Always confirm that the temperature is 5 C 35 C 41 95 Fahrenheit before you charge the
6. hazardous substances Table of Contents Mee OUR iDM Dern unaa leds E EAA R 1 2 AGE se 3 Using Bluetooth Pairing Your Device nnee ennen 4 Playing ha Ge eg dele 10106 ERE EE asen 5 Playing Audio A EE 6 Internal Rechargeable Lithium ion Battery nnee p Consumer Product Safety Guide nnee eenen ennen 8 9 TR tbe 10 Meet Your iDM1 2 DM12 Volume Down Button Power Top Front Button Play Pause Pairing Button Power Charging Pairing Indicator Light Rear Bluetooth Aux Switch Micro USB Charging Port Fold out speaker stand pull out to keep unit upright Included e iDM12 e Magnetic cover foldout iPad stand e Micro USB to USB 3 5 mm audio cable system gp 38 The un it includes a magnetic travel cover that doubles as an use as out the bottom iPad stand To a stand fold feet on its For travel fold up feet and place cover on the front o the unit iDM12 Place stand on a flat stable surface Dock iPad into groove iPad should no ski sta lan gt be in a case or n For best bility dock iPad in dscape mode Charging the Unit 1 Connect the micro USB plug to the micro USB charging port on the back of the unit 2 Connect the standard USB plug end of the cable to a power USB port on a computer or other USB charging device For first time use charge unit for about 8 hours 3 A gr
7. iDM12 portable rechargeable Bluetooth stereo speaker iHome instruction manual iDM12 Introduction Thank you for purchasing the iHome iDM12 This product is designed to provide high quality wireless sound for your iPad iPhone iPod computer PDA or other Bluetooth audio device Along with the included Quick Bluetooth Connection Guide this instruction booklet explains the basic operation and care of the unit Please read them carefully and keep for future reference Maintenance e Place the unit on a level surface away from sources of direct sunlight or excessive heat e Protect your furniture when placing your unit on a natural wood and lacquered finish A cloth or other protective material should be placed between it and the furniture e Clean your unit with a soft cloth moistened only with mild soap and water Stronger cleaning agents such as Benzene thinner or similar materials can damage the surface of the unit iDM12 This product bears the selective sorting symbol for waste electrical and electronic equipment WEEE This means that this product must be handled pursuant to European Directive 2002 96 EC in order to be recycled or dismantled to minimize its impact on the environment For further information please contact your local or regional authorities Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of
8. ired your device should link to the iDM1 2 whenever within range Using the iDM12 Playing Audio Via Bluetooth 1 Move the Bluetooth Aux Switch to the Bluetooth position to listen to audio streamed wirelessly from your paired iPad iPhone iPod or other Bluetooth device 2 Press and hold the Power Button to turn on the unit The amber light will flash as the unit searches for a previously paired device and then turn green when a previously paired device is detected 3 Press the Play Pause Pairing Button to play or pause audio from your Bluetooth device NOTE Play Pause only works in Bluetooth mode It does not control aux line in devices 4 Use the Volume Buttons to adjust volume 5 When done listening press the Power Button to turn the unit off Using the iDM12 Playing Audio via Aux 1 Move the Bluetooth Aux switch to the Aux position to listen to audio via aux in 2 Connect the micro USB plug to the micro USB charging port on the back of the unit and connect the 3 5 mm audio plug to the headphone or line out jack on your audio device 3 Press and hold the Power Button to turn on the unit release when green light appears 4 Use the Volume Buttons to adjust volume You may wish to adjust the volume on your audio device too 5 When done listening press the Power Button to turn the unit off Remember to turn off your audio device too Internal Rechargeable Lithium ion Battery This device us
9. s on Bluetooth pairing and linking For further information and to see the latest instructions visit www ihomeaudio com support iDM1203071 1 UK ENG A Printed in China
Download Pdf Manuals
Related Search