Pyle PHCT55 cable network tester
Contents
1. PHCT55 INTRODUCTION This Cable Tracker is designed to identify and trace wires or cables within a group without damaging the insulation For telephone line it can identify some states in the line Owning this instrument it is more convenient to install debug and maintain telephone line There are a Sender and a Receiver included in the Cable Tracker FUNCTIONS 1 Judge continuity of the cables or wires 2 Track the cables or wires and diagnose the break point 3 Receive the tone signal on the cables or wires telephone line IDENTIFY THE STATE OF WORKING TELEPHONE LINE USE SENDER SWITCH TO OFF 1 Identify TIP amp RING Connect the red test lead to the side of one line and the black test lead to the side of another line a CONT indicator light is green when you connect the red test lead to the Ring side b CONT indicator light is red when you connect the red test lead to the TIP side 2 Identify CLEAR RINGING BUSY state on the working telephone line Connect the red test lead to the RING side black test lead to the TIP side or connect RJ11 into the RJ11 socket on telephone a CONT indicator light is green indicates a CLEAR line If CONT indicator light is red it means the polarities were reversed 4 Identify the state in the working telephone line clear ring busy 5 Send a single solid tone or dual alternating tone to the object cables or wires STRUCTURE tip rota2. e cable has continuity see figure NOTE 1 If you don t use the Cable Tracker set the switches to OFF If you don t use the Cable Tracker for a long time take out all the batteries 2 Keep away from moisture 3 Do not use Cable Tracker under high voltage environment 4 Always follow this users manual Otherwise it may cause the damage to the tester or personal injury DISPOSAL OF THIS ARTICLE Dear Customer Please help avoiding refuse If you at some point intend to dispose of this article then please keep in mind that many of its components consist of valuable materials which can be recycled Please do not discharge it in the garbage bin but check with your local council for recycling facilities in your area NOTE Don t connect to any active AC or DC circuit for measuring continuity TRACK CABLE OR WIRES USE SENDER SWITCH TO TONE AND RECEIVER Connect the test leads to the pair or attach one test lead to ground and another test lead to either side of the line Move the Receiver close to and along the pair or the line Reception of the tone indicates the track NOTE Do not connect to any active circuit in this mode PYLE www PyleAudio com
3. ry switch button battery cover earphone jack Receiver test lead switch Sender b CONT indicator does not glow or glow faintly indicates a BUSY line c CONT indicator light brightly flickering YELLOW indicates a RINGING line Switch to CONT will terminate the call on the line BATTERY REPLACEMENT 1 Sender Battery replacement Remove the screw on the back case remove the back case replace the exhausted battery with a new one of 9V 6F22 Rejoin the back case and install the screw Receiver Battery replacement Remove the screw on the battery compartment remove the battery cover replace the exhausted battery with a new one of 9V 6F22 Rejoin the cover and install the screw OPERATION INSTRUCTION TEST CONTINUITY 1 Use the Sender switch to CONT Connect the test leads to the object pair use CONT postion The bright green of CONT indicates the continuity line resistance not exceeding 10kQ Use the Sender switch to TONE a Connect the test leads to a pair of cables touch Receiver to the cables If the two cables give larger and same tones it means both of them have continuity Otherwise the cable which gives lower tone doesn t have continuity Connect one test lead to one cable among a group of cables connect another test lead and the other cables to earth ground Touch the tip of Receiver to another end of the cable mentioned above Reception of tone means that th
Download Pdf Manuals
Related Search