Pyle PCO800 surge protector
Contents
1. o pm Controls functions and connections FRONT PANEL PCO 800 Outlet switch with 1 LED indicator activates protection and filtration to all back panel outlets To tum the unit ON press the upper or lower portion of this button 2 2 RETRACTABLE RACK LIGHTS 3 LIGHT SWITCH Activates rack illumination 4 DIMMER CONTROL 5 DIGITAL VOLTMETER READOUT 6 LED METER separate green and red LEDs monitor the Incoming voltage range The green LED Indicates voltage In nomal operating range The red LED lights when the voltage exceeds 25 Indicating that the power ls out of range for nomial operation REAR PANEL M MIC MIL 1 1 p x 7 POWER CORD Heavy duty 14 guage power cord for connection to AC power mains 115 60 2 8 CIRCUIT BREAKER Resettable 15 amp circuit breaker 9 8 REAR PANEL OUTLETS EMI RFI filtered splke surge protected and switched Installation and operation The PCL Senes conditioners are perfect accessores for any rack mount system Install In the top siot of a standard 19 inch rack and the 8 switched AC outlets on rear panel will provide full safety protection to all your rack equipment These conditioners protect your delicate electronic equipment by combining a high voltage2. ventilation The product should be located away from heat sources such as radiators heat vents or other devices including amplifiers that produce heat The product should be connected to power supply only of the type described in the operating instructions or as marked on the product The power supply cord should 1 be undamaged 2 never share an outlet or extension cord with other devices so that the outlet s or extension cord s power rating is exceeded and 3 be left plugged into the outlet when left unused for a long period of time 9 Care should be taken so that objects do not fall into and liquids are not spilled through the enclosure s openings 10 The product should be serviced by qualified service personnel when The r supply cord or the plug has been damaged or B Objects have fallen into or liquid has been spilled onto the product or The product has been exposed to rain or D The product does not appear to operate normally or exhibits a marked change in performance or E The product has been dropped or the enclosure damaged 11 Do not attempt to service the product beyond what is described in the user maintenance instructions All other servicing should be referred to qualified service personnel 12 Do not defeat the safety purpose of the grounding type plug which features a third grounding prong If this provided plug does not fit into your outlet consult an electrician for replacement of the obsolete outlet
3. HT Installation and operatlon M specifications 7 An equilateral tangle enclosing lightening flash arrowhead symbol is Intended to alert the user to the presence of uninsulated voltage within the product s enclosure which may be of sufficient magnitude to constitute a risk of electro shock equilateral triangle enclosing an exclamation point is intended to alert the user to the presence of Important operating and service instructions In the Iharsture with this unit IMPORTANT SAFETY INSTRUCTIONS WARNING When using electric products basic precautions should always be followed including the T Read all the instructions before using the product 5 Do not use this product near water near bathtub washbowl kitchen sink in wet basement or near a swimming pool etc 3 This product should be used only with a cart or stand that will keep it level and stable and prevent wobbling 4 This product in combination with amplifiers headphones or speakers may be capable of producing sound levels that could cause permanent hearing loss Do not operate for a long period of time at a high volume level or at a level that is uncomfortable If you experience any hearing loss or ringing in the ears you should consult aaudiologist The product should be located so that its location or position does not interfere with its proper
4. aker tip cutting off power to all connected equipment in your rack If this happens reduce the load by unplugging one or more units from the power conditioner and push the circult breaker fo reset If see fig 2 below fia fici 2 Specifications RFI EMI Interference filtration POWER CONSUMPTION Maximum 1800W 15A load POWER SOURCE 1 20VAC 60 Hz CIRCUIT BREAKER 15A themnal type LAMPS 820 SW two DIMENSIONS 19 X 1 75 X 7 3 48 2x21 6x4 5cm 1U rack helght WEIGHT 800 2 35 Kg PCO 820 2 7 Kg PCO800 PCO820 Instruction Manual www pyleaudio com Em m mmm ev IMPORTANT PACK CAREFULLY IN ORIGINAL CARTON IF POSSIBLE WE ARE NOT RESPONSIBLE FOR DAMAGE INCURRED IN RETURNING TEMS FOR REPAIR A LETTER EE REAT ETRE ADORN DATNME PHONE NUMBER OF THE ORIGINAL RECEIPT A SPROOF OF DATE OF PURCHASE PYLE SERVICE CENTER BROOKLYN NY 11204 1 800 444 5671
5. varlstor surge and transient suppressor with an RFI EMI interference filter The filter helps prevent noise From fluorescent lights motors and similar sources of electronic pollution from contaminating the AC feed to Plug Power Cord 7 Into standard grounded 115V outlet Plug sensttive electronic equipment into the 8 Rear Panel Outlets 9 Tum outlet power swltch 1 to OM poston Lift LED Indicates condltloned power to the connected equipment For discreet illumination of your rack equipment stage In studios and In other dark locations PCL 810 815 only pull the 2 Retractable Rack Lights 2 out and adjust the Dirnmer Control 4 for the lamp brightness desired see fig below The lights swivel and can be adjusted to proper angle for your appli slve reduce the setting of the Dimmer Control or substitute lesser wattage bulbs You can easily replace the bulbs without removing the unit from the rack by unscrewing cap on the end of each light tube Note Be careful not to push tubes In while the caps are unscrewed The Digital Voltmeter Readout 5 PCO 820 only calibrated to nominal 117 at the factory The Digital Volimeter Readout 5 automatically displays Incoming voltage when the Power Cord 7 16 connected MAXIMUM LOAD The PCL Series Power 8 Rear Panel Outlets are rated at 15 amps total load or 1800W at 120VAC If this mcximum load is exceeded the Circuit Bre
6. z z POWER CONDITIONERS eED 500 800 Feo WER GONETTIONGES Congratulations You have purchased on of the finest professional power conditioners on the market today This unit was developed using the expertise of professional sound engineers and working musicians You will find your new unit has superior performance and greater flexibility than any other power conditioner Its price range Read this manual carefully to get the most out of your new unit Thanks for selecting pyle audio for your zholce In power condltloners Date of Pulchase dealer s Name state Models Serials FEATURES CON TENTS For advanced RF EMI nolse filtering and the quietest operation of your equipment Triple mode varlstor surge and splke protection Elght rear outlets with room for 4 wall warts 15 amp ratingi 1800W with rear panel breaker UL Two added front panel silde out awivellng lights for rack Illumination and dimmer controls to adjust amp brightness PCO 820 and PCO 800 Large LED numeric metre that displays Incoming line voltage and 2 voltage condition Indicators standard voltage and over voltage PCO 820 only Rugged single rack space metal housing for maximum tll eee 2 Lp 3 Controls functions and HI P M
Download Pdf Manuals
Related Search