Chief SLB243 mounting kit
Contents
1. obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document PN Chief Manufacturing a products division of Milestone AV Technologies 8802 002010 Rev01 iC ae l f 8401 Eagle Creek Parkway Savage MN 55378 2009 Milestone AV Technologies e P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 a Duchossois Group a Our Mounts Your Vision2. proceed to step 2 1 Screw thumb screws onto 10 24 x 5 8 Phillips pan head screws DO NOT fully tighten thumb screws at this time 2 Turn projector upside down on a flat surface 3 Place nylon spacer over the threaded insert at the back of projector 4 Place the interface bracket onto the bottom of the projector and spacer and align the mounting holes in the bracket with the threaded inserts in the bottom of the projector 5 Position M4 x 10mm mounting screws with M4 flat washers into the threaded inserts on bracket side tabs Place the M4 x 16mm screw through the nylon spacer and into the threaded insert at the back of projector Tighten all fasteners at this time securing the bracket to the projector NOTE Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the All Points Security Kit O gt Chief is a registered trademark of Milestone AV Technologies All rights reserved w KN o CONSUMER Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or
3. INSTALLATION INSTRUCTIONS SSB 243 SSM 243 SLB 243 and SLM 243 Interface Brackets SSB 243 SSM 243 SLB 243 and SLM 243 Interface Brackets are designed for use with Chief Series Projector Mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 2 Screw Phillips Pan Head Machine M4 x 10mm 4 10 24 Thumb Nuts 1 Screw Phillips Flat Head Machine M4 x 16mm 1 All Points Security Kit 2 Washer M4 1 5 32 Security Hex Key 1 Spacer Nylon 1 2 x 194 x 3 8 Lets front of Towards front of projector projector SLB 243 SLM 243 Note SSB style interface bracket connections Note SSM style interface bracket connections are encircled are encircled Only used when installing SLB SSB interface brackets Installation Instructions WARNING OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT over tighten screws when installing interface brackets NOTE Step 1 is only required when installing an SLB SSB interface bracket If an SLM SSM bracket is being installed
Download Pdf Manuals
Related Search