Chief RSMA237 project mount
Contents
1. INSTALLATION INSTRUCTIONS SSB 237 SSM 237 SLB 237 and SLM 237 Interface Brackets SSB 237 SSM 237 SLB 237 and SLM 237 Interface Brackets are designed for use with Chief Series Projector Mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 3 Screw Phillips Pan Head Machine M4 x 8mm 4 10 24 Thumb Nuts 3 Washer M4 1 All Points Security Kit 1 5 32 Security Hex Key S SLB 237 Towards front of Towards front of projector projector Note SSB style interface bracket connections Note SSM style interface bracket connections are encircled are encircled Only used when installing SLB SSB interface brackets NOTE Specific to SSB style and SSM style interface bracket installation all appropriate screws come pre installed as reflected in the encircled locations above DO NOT attempt to substitute and USE ONLY this pre installed hardware for SSB style and SSM style interface bracket installation Installation Instructions WARNING OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS2. PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT over tighten screws when installing interface brackets NOTE Step 1 is only required when installing an SLB SSB interface bracket If an SLM SSM bracket is being installed proceed to step 2 1 Screw thumb screws onto 10 24 x 5 8 Phillips pan head screws DO NOT fully tighten thumb screws at this time 2 Turn projector upside down on a flat surface 3 Place the interface bracket onto the bottom of the projector and align the mounting holes in the bracket with the threaded inserts in the bottom of the projector 4 Position M4 mounting screws with M4 washers into the threaded inserts in bottom of projector Tighten all fasteners at this time securing the bracket to the projector NOTE Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation Ay instructions in the All Points Security Kit Q D Chief is a registered trademark of Milestone AV Technologies All rights reserved s Ch consumer Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without not
3. ice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document EN o Chief Manufacturing a products division of Milestone AV Technologies 8802 002003 Rev01 ICJ ll E 8401 Eagle Creek Parkway Savage MN 55378 2009 Milestone AV Technologies e P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 a Duchossois Group adr Our Mounts Your Vision
Download Pdf Manuals
Related Search