Antec Rockus 3D 2.1
Contents
1. INPUT y AUX O TO SPEAKER 6 o Dai cS O ox OPT 0 POWER a 3 Sall Mode Button O d MAX POW ER Tar en stbgver 100 Volume Control Subwoofer Back Panel Remote Control Troubleshooting If there is no sound coming from the speakers check the following e Verify the power switch on the back of the subwoofer is in the on position and that the plug is plugged into a functioning power outlet e Make sure your audio source is not muted and the volume is set to an audible level e Make sure both input and speaker cables are firmly connected at both sides e Check the status LEDs on the front of the remote to see if the mute light is lit If it is press down on the top of the remote to unmute the system If you cannot hear a connected optical device e Check the status LEDs on the front of the remote control and verify that the optical signal light is lit e Verify that optical output is enabled on your audio source e Make sure both sides of the audio cable are securely fastened For additional information and product support please visit us at www soundscienceaudio com English2. for three seconds when the system is powered on 5 Plug the power cable that is hard wired into the subwoofer into a power outlet 100 240V 50 60 Hz Note Although you can use multiple devices for analog input RCA 3 5 mm when two devices are connected and playing both will be heard simultaneously However the volume of either device will be cut in half when both are connecting even if only one device is outputting sound English How to Use the soundscience rockus Speaker System e To turn on the system flip the power switch on the back of the subwoofer to the on position e To adjust the strength of the bass use the switch on the back of the subwoofer labeled bass level By default rockus is set to bass level 1 low e To mute the sound press down on the volume knob on the top of the remote control e To switch between 3D mode and music mode press the gray mode button on the front of the remote control To enable disable optical input press and hold the mode button for three seconds e To adjust the volume turn the knob on the top of the remote control e The LED lights on the front of the remote indicate the status of the rockus system according to the following scheme Green optical input active Blue music mode enabled White 3D mode enabled Red mute On Off Switch Bass Level Switch Mute Button
3. SOUNCsScience soundscience rockus speakers Parts and Components 8 pin to 8 pin RCA to open ended RCA to open ended red white soundscience rockus speakers 1 x subwoofer 1 x remote control 2 x satellite speakers RCA to 3 5 mm 3 5 mm to 3 5 mm How to Configure and Connect the soundscience rockus Speaker System 1 Carefully remove the two satellite speakers subwoofer four sets of cables and remote from the box 2 Connect the remote to the subwoofer using the supplied 8 pin to 8 pin cable Ensure that the pins are correctly aligned on both ends of the cable before plugging them in 3 Connect the satellite speakers to the subwoofer using the supplied RCA to open ended speaker cables Pay attention to which speakers are left right and position the speakers accordingly 4 Connect the subwoofer to your sound source using one of the following methods a RCA to 3 5 mm cable Plug the RCA red amp white end into subwoofer and plug the other end into your sound source i e computer mp3 player etc b 3 5mm to 3 5 mm cable Plug one end into the subwoofer and the other end into your sound source i e computer mp3 player etc c Optical cable not included Plug one end into the subwoofer and the other end into your sound source i e computer DVD player etc To enable disable optical input press and hold the gray mode button on the front of the remote control
Download Pdf Manuals
Related Search