Chief RPA204 project mount
Contents
1. Place the interface bracket onto the bottom of the projector lining up the four holes in the bracket with the four threaded inserts in the bottom of the projector 4 Using the four M6 X 12mm mounting screws and washers start them into the mounting holes by hand and secure all four fasteners at this time NOTE Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the All Points Security Kit CSAV Inc and its affiliated corporations and subsidiaries collectively CSAV intend to make this manual accurate and complete However CSAV makes no claim that the infor mation contained herein covers all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind CSAV makes no representation of warranty expressed or implied regarding the information contained herein CSAV assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document EN o 2007 Chief Manufacturing 8401 Eagle Creek Parkway Savage MN 55378 8802 000271 iC CH I E F P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 9 10 072. INSTALLATION INSTRUCTIONS SLB 204 and SLM 204 Interface Brackets for Christie LX650 EIKI LC X80 SANYO PLC XP100L SLB and SLM series Interface brackets are designed for use with Chief RPA RPM and Smart Lift series projector mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative by calling 1 800 582 6480 WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 4 Washer Flat M6 6 10 24 Thumb Nuts 4 SCREW Pan head M6 x 12mm 1 All Points Security Kit Towards front of Projector Towards front of Projector SLB 204 SLM 204 Only used when installing SLB Interface brackets Installation WARNING OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUPIMENT DO NOT over tighten screws when installing interface brackets NOTE Step 1 is only required when installing an SLB Interface bracket If an SLM bracket is being installed proceed to step 2 Screw six thumb screws onto six 10 24 x 5 8 Philips pan head screws DO NOT fully tighten thumb screws at this time Turn projector upside down on a flat surface o N
Download Pdf Manuals
Related Search