Metra 99-7896 mounting kit
Contents
1. Mount the factory brackets to the back of the dash trim bezel with 4 Phillips screws previously removed in step 3 Mount the climate control pod to the dash trim bezel with 3 screws previously removed in step 2 A Strip wire ends back 7 B Twist ends together C Solder D Tape Locate the factory wiring harness in the Re connect the battery terminal and test the unit dash Metra recommends using the for proper operation Slide the head unit kit proper mating adaptor and making assembly into the sub dash and mount with 4 connections as shown Isolate and Phillips screws previously removed in step 1 individually tape off the ends of any unused wires to prevent electrical short circuit 3 rev 250701 KIT FEATURES Mela Pa Metra Division of METRACORP me Shalt and DIN unit provisions 99 78 6 oe INSTALLATION INSTRUCTIONS APPLICATIONS KIT COMPONENTS OR PAGE E HONDA ES Civie 1999 00 1 3 TOOLS REQUIRED _ Phillips screwdriver es Cutting tool fy 1 800 221 0932 www metraonline com Panel removal tool COPYRIGHT 2001 METRA ELECTRONICS CORPORATION Disconnect the negative battery terminal to prevent an accidental short circuit Remove 2 Phillips screws from the bottom edge of the glove box door and remove the door Remove 3 Phillips screws from the lower steering column panel Pull straight down on the lower steer2. ing column panel and remove the panel Remove 2 Phillips screws under the climate controls Remove 4 Phillips screws from the lower dash location Remove 4 Phillips screws securing the bottom of the dash trim bezel nead unit assembly and pull the assembly out as far as possible Cut the zip ties securing the head unit and climate control wires slide the dash trim bezel head unit assembly from the dash cavity and disconnect the wiring Remove 3 screws securing the climate Remove 4 Phillips screws securing the control pod to the dash trim bezel and head unit assembly to the back of the dash remove the pod trim bezel Remove 4 Phillips screws securing the factory brackets to the head unit assembly and slide the assembly out the front of the dash trim bezel 2 SHAFT HEAD UNITS Slide the aftermarket head unit into the Radio Housing and secure with shaft nuts see Fig A DIN HEAD UNITS Cut and remove the shaft supports from the Radio Housing Slide the DIN cage into the kit and secure by bending the metal locking tabs down Slide the aftermarket head unitinto the cage until secure see Fig B Cut and remove all mounting clips on the Radio Housing EXCEPT clips C The mounting clips can be identified by the stamped letter on each clip Snap the head unit kit assembly into the radio trim bezel
Download Pdf Manuals
Related Search