Metra 99-7425 mounting kit
Contents
1. MENT S INSTALLATION INSTRUCTIONS FOR PART 99 7425 APPLICATIONS Nissan Rogue 2008 10 KIT FEATURES DIN Radio Provision with Pocket ISO Mount Radio Provision with Pocket KIT COMPONENTS A Radio Housing B Trim Plate C ISO Brackets Hamess amp Antenna Connections sod separately 70 7552 Nissan Hamess 07 up 40 NIT2 Nissan Antenna Adapter 07 up TA 1 800 221 0932 LJ www metraonline com COPYRIGHT 2010 METRA ELECTRONICS CORPORATION prem e TABLE OF CONTENTS Dash Disassembly Nissan Rogue 2008 10 12 Kit Assembly DIN Radio Provision with Pocket ISO MOUNT Radio Provision with Pocke Final Assembly 4 5 Note Refer also to the instructions included with the aftermarket radio a LC 99 7425 nasu nisassemeLY SAN Rogue 2008 10 1 Disconnect the negative battery ter minal to prevent an accidental short circuit 2 If equipped with center speaker Unclip and remove the grille Figure A Remove 4 Phillips screws securing the speaker Unplug and remove the speaker Figure B Unclip the panel above the radio including the a c vents then unplug hazard switch and remove Figure C Note If not equipped with center speaker skip step number 2 Continued on page 2 m ZZ EEE NISSAN Rogue 2008 10 3 Unclip the panel below the radio including the climate2. controls Unplug climate controls and remove the panel Figure D 4 Remove 4 Phillips screws securing the radio unplug and remove radio Figure E Continue to kit assembly m LEZ 99 7425 ASSEMBLY DIN RADIO PROVISION WITH POCKET Note Refer also to the instructions included with the aftermarket radio 1 Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs outward Figure A 2 Slide the aftermarket radio into the cage until it snaps into place Figure B Continue to final assembly m7 99 7425 KIT ASSEMBLY 150 MOUNT RADIO PROVISION WITH POCKET Note Refer also to the instructions included with the aftermarket radio A 1 Mount the ISO Brackets to the radio with the screws supplied with the radio Figure A 2 Slide the radio into the radio housing until it snaps into place Figure B 3 Snap the trim plate onto the front of the Radio Housing Figure B Continue to final assembly L ASSEMBLY A uz A Strip wire ends back 1 2 LES B Twist ends together Solder c rA D Tape Tee Vc 1 Locate the factory wiring harness in the dash Metra recommends using the proper mating adapter and making connections as shown isolate and individ ually tape off the ends of any unused wires to prevent electrical s
3. hort circuit 2 Re connect the negative battery terminal and test the unit for proper operation 3 Reassemble in reverse order of disassembly FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit Metra recommends making connections as shown below Strip Splice Solder Tape Isolate and individually tape off ends of any unused wires to prevent electrical short circuit METRA EIA WIRING CODE 12V nition Ace Red Right Front Gray 12V Batt Memory Yelow Right Front Gray Black Ground Back Left Front White Power Arte Ble Left Font White Back Amp Tum On Blue White Right Rear Violet Amp Ground Black White Right Rear Violet Black lluminction se Orange Left Rear Green Dimmer Orange White Left Rear Green Black NOTE When a Black wire is not present ground radio to vehicle chassis AI colors may not be present on al eads due to manufacturers specifications 1 800 221 0932 a www metraonline com REV 04 29 10 COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST99 7425
Download Pdf Manuals
Related Search