Liebherr FKvsl 3612 Premium
Contents
1. Does the appliance cause nearby items of furniture or objects to vibrate Please note that noises caused by the refrigerant circuit cannot be avoided The temperature is not low enough Is the temperature setting correct see Setting the tempera ture Have excessive amounts of fresh food been placed in the appli ance Does the separately installed thermometer show the correct read ing Is the ventilation system working properly Is the appliance set up too close to a heat source If none of the above causes apply and you realy HN the fault yourself contact the fim mm no nearest customer service H department stating the type of appliance service number and appliance number as indicated on the type plate The type plate is located in the refrigerator compartment on the left hand side kg 24h 80 R600a Hg lw Ba ac h i v Seria Nr Shutting your appliance down If your appliance is to be shut down for any length of time switch it off and disconnect the plug or remove the fuse Clean the appliance and leave the door open in order to prevent unpleasant smells The appliance complies with the relevant safety regulations and EC directives 2004 108 EC and 2006 95 EC Changing over door hinges 1 Pull out the circlip from the lower hinge bracket 2 Remove cover plate 3 Un2. Remove the food from the appliance and store a cool place Leave the door of the appliance open while defrosting After defrosting mop up the remaining water and clean the appliance Do not use any mechanical devices or other artificial aids for defrosting other than those recommended by the manufacturer Cleaning Before cleaning always switch off the appliance Pull out the mains plug or remove unscrew the fuse Clean the inside equipment parts and outer walls with lukewarm water and a little detergent Do not use abrasive or acid cleaners or chemical solvents Do not use steam cleaners because of the risk of injury and damage Ensure that no cleaning water penetrates into the electrical com ponents or ventilation grille The dust should be removed from the refrigeration unit and heat exchanger metal grid at the back of the appliance once a year Clean the drain hole in the refrigerator compartment with a thin object e g cotton swab or the like Do not damage or remove the type plate on the inside of the ap pliance It is very important for servicing purposes Malfunctions You may be able to rectify the following faults by checking the possible causes yourself Appliance does not function Is the appliance switched on Is the plug correctly fitted in the mains socket Is the socket fuse intact Loud running noise Is the appliance set up firmly on the floor
3. of the light cover Push buttons on the back of the cover Detach the cover at the back and remove Change the fluorescent tube Insertthe cover atthe frontand Click into place at the back e Screw the screw into the cover Temperature display The thermometer is located in the upper part of the door The temperature display is powered by a battery which is available from your spe cialist dealer Changing the battery Open the door Detach cover A Pull out thermometer e Open the battery com partment using a small screwdriver Replace the battery Close the battery compartment Re install all parts If Er or HH appears in the display the ap pliance has a fault Consult the customer service department indicating the fault number displayed Safety lock The lock in the appliance door is equipped with a safety mechanism Locking the appliance e Insert the key as shown by arrow 1 Turn the key 90 anticlock wise To unlock the appliance the same procedure must be repeated in the same order Turn the key clockwise Defrosting The refrigerator compartment defrosts automatically When operating at the coldest thermostat setting the interior rear wall may however ice up In this case the appliance must be defrosted manually Switch the appliance off to defrost Pull out the mains plug or set the temperature control to 0
4. Operating instructions Pages KAJ Commercial refrigerator ol o ol EO 7080 031 00 FKv 26 36 41 54 1108 D Disposal notes Keep packaging materials away from children polythene sheets and bags can cause suffocation Please return the packaging to an official collection point Your old appliance This contains some reusable materials and should be disposed of properly not simply with unsorted household refuse Discarded appliances should be disabled Remove the plug cut through the connection cable and render the catch unusable so that children cannotbecome trapped inside Ensure that the refrigerant circuit is not damaged when the appliance that is no longer needed is taken away for disposal Details of the refrigerant can be found on the type plate Appliances which are no longer needed must be disposed of ina professional and appropriate way in accordance with the current local regulations and laws Range of appliance use The appliance is suited only for cooling food In the case of com mercial food cooling the pertinent statutory regulations have to be observed The appliance is not suited forstoring andcooling pharmaceuticals blood plasma laboratory preparations or similar substances a
5. accessible Connect the appliance with a properly earthed fused plug and socket only The wires in the mains lead are coloured in accordance with the following code green yellow earth blue neutral brown live Warning This appliance must be earthed Switching the appliance on and off You are recommended to clean the appliance before switching it on for the first time see Cleaning To switch the appliance on Connect the appliance to the mains the appliance is switched on To switch the appliance off Pull out the mains plug or set the temperature control to Setting the temperature Using a coin turn the arrow on the temperature control to a setting between und max The nearer the temperature control is to the max setting the colder the interior temperature Cooling This appliance can be used for chilling all types of drinks and food The grid shelves can be moved to accommodate different height bottles or packages To remove the shelves the door must be opened wider than 90 High percentage alcohols should be tightly sealed and stored upright The ventilation slots on the inside must not be covered GB Interior light in appliances with glass door The interior light is fitted on the inside at the top It can be switched on and off by pressing the switch Light To change the tube Pull out the mains plug or remove unscrew the fuse Undo the screw on the back
6. lated Do not stand on the plinth drawers or doors or use them to sup port anything else This appliance is not intended for use by persons including chil dren with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance Avoid prolonged skin contact with cold surfaces or chilled frozen food This could cause pain numbness and frostbite In the case of prolonged skin contact protective measures should be taken e g gloves should be worn Do not consume food which has been stored for too long as it could cause food poisoning Do not store explosives or sprays using combustible propellants suchas butane propane pentane etc inthe appliance Electrical components might cause leaking gas to ignite You may identify such sprays by the printed contents or a flame symbol Do not use electrical appliances inside the appliance If you have a lockable appliance do not keep the key near the appliance or within reach of children Climate rating The appliance is set to operate within specific ambient temperature limits according to its climate rating These temperature limits should not be exceeded The correct climate rating for your appliance is indicated on the type plate Climate rating Ambie
7. nd products subject to the Medical Devices Directive 2007 47 EC Any misuse of the appliance may result in damage to or spoilage of the stored goods Furthermore the appliance is unsuited for use in areas exposed to an explosion hazard Description of appliance and equipment Temperature control amp _ a G Grid shelves Adjustable height feet Safety instructions and warnings To prevent injury or damage to the unit the appliance should be unpacked and set up by two people In the event that the appliance is damaged on delivery contact the supplier immediately before connecting to the mains To guarantee safe operation ensure that the appliance is set up and connected as described in these operating instructions Disconnect the appliance from the mains if any fault occurs Pull out the plug switch off or remove the fuse When disconnecting the appliance pull on the plug not on the cable Any repairs and work on the appliance should only be carried out by the customer service department as unauthorised work could prove highly dangerous for the user The same applies to changing the mains power cable Do not allow naked flames or ignition sources to enter the appli ance When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged In the event of damage make sure that there are no ignition sources nearby and keep the room well venti
8. nt temperature SN 10 C to 32 C N 16 C to 32 C ST 16 C to 38 C T 16 C to 43 C Setting up Avoid positioning the appliance in direct sunlight or near cookers radiators and similar sources of heat The floor on which the appliance stands should be horizontal and level Compensate for uneven floors with the adjustable feet Always ensure that there is good ventilation and that the outward flowing air is able to escape Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 per 8 g of R 600a refrigerant used in the appliance so as to avoid the formation of inflammable gas air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance Do not connect the appliance to the supply with other equipment using an extension cable risk of overheating Dimensions Height Width Depth FRV 26 1250 600 610 FKV 1640 600 610 FKV 41 1800 600 610 1640 750 730 Connecting the mains Power supply a c and voltage at the operating point must comply with the details on the type plate The socket must be fused with a 10 A fuse or higher it must be away from the rear of the appliance and must be easily
9. screw the hinge pin from the upper hinge bracket 4 Remove the door 5 Transfer clamping plate 6 Transfer hinge components and cover plates to the op posite side 7 Transfer lower hinge bracket and cover plate to the op posite side 8 Transferlock andcover plates to the opposite side of the door GB 9 Transfer handle and plugs to the opposite side of the door 10 Pull out the torque rod from the right hand door mount ing The bar is approx 1130 mm long 11 Turn the torque rod through 180 horizontally and insert into the left hand door mounting 12 Place the door on the lower hinge bracket 13 Screw in the hinge pin 14 Align the door at the side and tighten the hinge pin 15 Replace cover plate 16 Tighten the torque rod with the open ended spanner provided gt 60 The hexagon of the torque rod will lock into the lower hinge bracket 17 Fit the circlip on the lower hinge bracket
Download Pdf Manuals
Related Search