Chief SLB6000 mounting kit
Contents
1. INSTALLATION INSTRUCTIONS SSB 6000 SSM 6000 SLB 6000 and SLM 6000 Interface Brackets SSB 6000 SSM 6000 SLB 6000 and SLM 6000 Interface Brackets are designed for use with Chief Series Projector Mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 3 Screw Phillips Pan Head Machine M4 x 10mm 6 10 24 Thumb Nuts 1 Screw Phillips Pan Head Machine M4 x 20mm 1 All Points Security Kit 4 Washer Flat M4 1 1 2 x 194 x 1 2 Round Spacer Towards front of Towards front of projector projector SLB 6000 SLM 6000 Note SSB style interface bracket connections Note SSM style interface bracket connections are encircled are encircled Only used when installing SLB SSB interface brackets Used when mounting surface of projector is recessed NOTE Specific to SSB style and SSM style interface bracket installation all appropriate screws come pre installed as reflected in the encircled locations above DO NOT attempt to substitute and USE ONLY this pre installed hardware for SSB style and SSM styl2. e interface bracket installation Installation Instructions WARNING OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT over tighten screws when installing interface bracket NOTE Step 1 is only required when installing an SLB SSB interface bracket If an SLM SSM bracket is being installed proceed to step 2 p a Screw thumb screws onto 10 24 x 5 8 Phillips pan head screws DO NOT fully tighten thumb screws at this time Place 1 2 spacer over threaded insert in center bottom of projector Place interface bracket onto bottom of projector and align spacers with mounting holes in bracket Using M4 x 10mm Phillips pan head screws and M4 x 20mm Phillips pan head screws with flat washers secure bracket to projector and tighten all fasteners at this time NOTE Security Screws can be substituted when mounting interface bracket to projector by using the parts and installation Chief is a registered trademark of Milestone AV Technologies All rights reserved Ye instructions in the All Points Security Kit PAD 2 amp Cp lt O o S7 CoysuneR E Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions or variations nor does it provide for every possible conti
3. ngency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document AN Chief Manufacturing a products division of Milestone AV Technologies 8850 000185 Rev01 iC C ae l f 8401 Eagle Creek Parkway Savage MN 55378 2009 Milestone AV Technologies Our Mounts Your Vision e P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 a Duchossois Group a
Download Pdf Manuals
Related Search