Atdec SD-DO-42-BK flat panel desk mount
Contents
1. Slide the Quickshift Donut into the desired position If necessary adjust the tension between the Quickshift Donut and the Pole using the 5mm Allen Key supplied TIGHTEN LOOSEN WARNING Be careful not to overtighten Once in place close the lever to lock the Quickshift Donut in the desired position Step 2 Remove VESA plate from Quickshift Donut Press and hold the Release Buttons one on either side Whilst holding the Release Buttons remove the VESA Plate Y 7 Release Buttons Step 3 Attach the VESA plate to your Display There are two mounting hole configurations e 75x 5mm l e 100 x 100mm Mounting Screws x4 Choose appropriate Mounting Screws VESA Hale from the Hardware supplied to suit your Display Top of Display Back of Display Step 4 Attach your Display to the Quickshift Donut Hook the top of the VESA plate onto Gently push the bottom of the Display Insert the Security Screw and tighten the Quickshift Mount into the Mount until it CLICKS using the 2mm Allen Key S VESA plate 8 a o N AS TIGHTEN 7 Ri atdec com S y SI an ZIN CLICK Back of Display Step 5 Adjusting the VESA Ball Mount Position your Display to the desired viewing angle using the 40 angular movement allowed by the VESA Ball Mount Loosen Kg Depending on the weight of the display it may be necessary to make adjustments2. to the VESA Ball Mount If the display does not hold its Lew Tension position or is too resistant adjust the Tension Plate located at the j rear of the VESA Ball Mount see diagram right To make any adjustments use the Tightening Tool supplied Tightening Check the display and then adjust again if necessary Toal Tighten Kg Installation Complete SON atdec No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd Due to continuing product development the manufacturer reserves the right to alter specifications without notice Published 18 05 09
3. Installation Instructions dec Display Quickshift Donut The Spacedec Display Quickshift Donut is to be used on 42mm and 50mm diameter poles only The Manufacturer accepts no responsibility for incorrect installation SD DO Component Checklist Check you have received all parts against this Component Checklist prior to installation Hardware Mounting ae Security Screws Quickshift 42mm Front D Screw x1 M4x1 Omm Donut x1 Donut Insert x1 2mm Allen Screw x4 Visidec Groove Key oe M4x12mm Lock x1 Smm Allen Yy Screw x4 Key x1 42mm Rear M4xl6mm Donut Insert x1 Tightening Screw x4 Tool x1 Step 1 Install Quickshift Donut Select your correct product configuration A B or C A Use this configuration with a standard 50mm pole C No inserts required ardoet B Use this configuration with a Visidec 42mm extrusion S amp S pole Rear Donut Front Donut Insert Insert Groove Insert t s to top surface Front Donut Note Ensure inserts are fitted in correct orientation C Use this configuration with a standard 42mm pole Q Rear Donut Insert Insert Arrows point lt ae Slide the Quickshitt Donut onto the pole with the lever open removing the End Cap if necessary Rear groove insert must align with slot in the Pole Groove Insert af Visidec 42mm pole shown
Download Pdf Manuals
Related Search