Home

Lenco SCD-24

image

Contents

1. MIN VOLUME MAX LISTENING TO THE RADIO 1 Setto RADIO 2 Select a MODE FUNCTION MODE RADIO FM MONO FM ST Iu L 4 Adjust the sound VOLUME TUNING Ip MAX MIN 4 VOLUME GB2 3 Tune in to a station e SR24CD ENG FM LENCO TCDOSAS indd4 4 2009 4 16 FOR BETTER RECEPTION ex FM NOTE 1 FM stereo LED indicator lights if receive FM stereo broardcast and the MODE switch set on FM STEREO 2 When too much noise is heard during FM STEREO reception set MODE switch to FM mono AFTER LISTENING Set the FUNCTION selector to OFF COMPA SC PLAYBACK 1 Setto CD FUNCTION 3 Insert a disc with the label side facing up I CD 4 Close the CD door a L The disc will rotate and the total tracks of the disc will show on the display 2 Open the CD door by pushing 5 Press the Play Pause gt button CD Door Open Close button Track number 1 will be shown CD display TO INTERRUPT PLAYBACK TO STOP PLAYBACK Press the Play Pause WII button Press the STOP button and the display shows the total Press the button again to resume playback tracks of the disc je CD display TO SKIP TO THE BEGINNING OF A TRACK Press either one of the 4 P skip buttons according to the desired skip direction Play back resumes from the selected track When the 64 button is pressed once during play the previous track starts again When the gt gt butt
2. of the appliance can cause discoloring to furniture surfaces If necessary place the appliance on a non slide surface If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice Waste Electrical and Electronic Equipment Directive For information and support www lenco eu SR24CD ENG FM LENCO TCDOBAS indd8 8 GB6 e 2009 4 16 04 50 25
3. e Lenco STEREO FM RADIO WITH CD PLAYER SCD 24 INSTRUCTION MANUAL C For information and support www lenco eu e SR24CD ENG FM LENCO TCDOSAS indd1 1 2009 4 16 04 50 18 CLASS 1 LASER PRODUCT CLASS 1 LASER PRODUCT APPAREIL A LASER DE CLASSE 1 CAUTION PRODUCTO LASER DE CLASE 1 DEFEATED AVOID EXPOSURE TO BEAM This product contains a low power laser device Warning Do not touch the lens DO NOT THROW BATTERIES IN FIRE PRECAUTIONS Follow the advice below for safe and appropriate operations ON PLACEMENT Do not use the unit in places which are extremely hot cold dusty or humid Place the unit flat and even surface Do not restrict the air flow of the unit by placing it in a place with poor air flow by covering it with a cloth or by placing it on a carpet ON SAFETY INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS When connecting and disconnecting the AC cord grip the plug and not the cord itself Pulling the cord may damage it and create hazard When you are not going to use the unit for a long period of time disconnect the AC power cord ON AC VOLTAGE Before use check that the rated voltage of your unit matches your local voltage ON CONDENSATION When left in a heated room where it is warm and damp water droplets or condensation may form inside the CD player tee table cloths curtains etc eR ox ow W
4. hen there is condensation inside the unit the unit may not function normally Let it stand for 1 to 2 hours before turning the power on or gradually heat the room up and dry the unit before use Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation Ensure that the ventilation is not impeded by covering the ventilation openings with items such as newspapers Do not place naked flame sources such as lighted candles on the apparatus Take attention to the environmental aspects of battery disposal Use the apparatus only in moderate climates not in tropical climates Do not expose the apparatus to dripping or splashing Do not place objects filled with liquids such as vases on the apparatus Should any trouble occur disconnect the AC power cord and refer servicing to qualified personnel The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of dangerous voltage inside the unit In case of malfunction due to electrostatic discharge the apparatus has to be reset by disconnecting it from mains supply SR24CD ENG FM LENCO TCDOSAS indd2 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION To reduce the risk of electric shock do not remove the cover There are no user serviceable parts inside the unit Refer all servicing to qualified personnel e 2 The exclamation point within the triangle is a warning sign alerting the user of important inst
5. ks of disc are possible when playback is stopped Up to 20 tracks can be stored in the memory in any order In stop mode press PROG button the 0 and the PROGRAM indicator will be flashing on and off on the display Press CD SKIP SEARCH FORWARD button to select the first desired track to be programmed Press PROG button to enter The display changes to show 0 and it will be flashing Repeat steps 2 amp 3 to store other desired tracks until all tracks are programmed Press PLAY PAUSE button to start playback from the first programmed track Press STOP button to stop program playback Note Program function can only be done stop mode To Erase the Memory Program To clear the program you may have two ways 1 Press STOP button when the disc is stopped 2 Open the CD compartment lid program will be erased PROGRAM DB SES CD display MAINTENAN CLEANING A CD CLEANING THE UNIT If the CD skips or will not play the disc may need cleaning Do not use volatile chemicals on this unit Clean by lightly Before playing wipe the disc from the centre out with a wiping with a soft cloth cleaning cloth After playing store the disc in its case IMPORTANT NOTE If an abnormal display indication or an operating problem occurs disconnect the AC power cord and remove the batteries Wait at least 5 seconds then reconnect the AC power cord or reinstall the batteries WARNING Should the CD door be
6. on is pressed once during play the next track plays SEARCHING FOR A PASSAGE WITHIN A TRACK Keep the lt button pressed during playback and release the button as soon as you recognise the desired passage Then normal CD playback will resume from this point GB3 e SR24CD ENG FM LENCO TCDOBAS indd5 5 2009 4 16 04 50 22 EPEAT This function allows single track all tracks disc to be played repeatedly TO REPEAT THE SAME TRACK TO REPEAT THE WHOLE DISC Press the REPEAT button once during playback Repeat Press the REPEAT button twice until repeat indicator indicator will illuminate and keep flashing will lighten TO CANCEL REPEAT PLAYBACK FUNCTION Press the REPEAT button again until repeat indicator off Note on CD R RW discs Because of non standardized format definition production of CD R RW playback quality and performance are not guaranteed Manufacturer is not responsible for the playability of CD R RW due to recording conditions such as PC performance writing software media ability etc Donot attach a seal or label to either side of the CD R RW disc It may cause a malfunction Itis recommended to record only audio files on CD R RW discs for easy reading BASS BOOST 3 o To enjoy a BASS BOOST sound effect press BBS button GB4 e SR24CD ENG FM LENCO TCDOBAS indd6 6 2009 4 16 04 50 24 ROGRAM PLAYBA PROGRAM TRACKS Programming trac
7. opened before the reading of the CD is completed a jamming noise may occur This is resolved CLEANING THE CD LENS by closing the CD door If the CD lens is dusty clean it with a brush blower Blow several times on the lens and remove the dust with the brush Finger prints may be removed with a cotton swab moistened with alcohol GB5 e SR24CD ENG FM LENCO TCDOBAS indd7 7 2009 4 16 04 50 25 e SPECIFICATIONS CD SECTION Channels S N ratio Wow amp Flutter Sampling frequency Quantization Pick up light source Pick up wave length RADIO SECTION Tuning ranges Antennas GENERAL Output power Power consumption Speaker Phones jack Power source Dimensions Weight 2 channels 60 dB undetectable 44 1 kHz 8 x over sampling 1 bit DA converter Semi conductor laser 790 nm FM 87 5 108 MHz FM Rod antenna 1W 1W RMS 13 5W 3 8 3 5 AC 230V 50Hz DC 9V 6 x 1 5V LR14 C UM2 224 L x 234 D x 126 H mm 24KGS Due to continuing improvement the features and the design are subject to change without notice Where to place the item Today s furniture is coated with a wide variety of lacquers and synthetic coatings that are treated with an extensive range of cleaning products Therefore the possibility that some of these substances contain components that react adversely to e the rubber feet of the item and soften them cannot be completely excluded The rubber feet
8. ructions accompanying the product 2009 4 16 04 50 19 LOCATION OF CONTROLS o C 1 PROGRAM BUTTON 13 CD NEXT BUTTON PP 2 REPEAT BUTTON 14 CD PLAY PAUSE BUTTON PI 3 BBS BUTTON 15 CD BACK BUTTON 4 4 REPEAT INDICATOR 16 CD STOP BUTTON 5 POWER INDICATOR 17 DIALSCALE 6 CD DISPLAY 18 MODE SWITCH 7 SPEAKER 19 TUNING CONTROL 8 CD DOOR 20 AC SOCKET 9 TELESCOPIC ANTENNA 21 CARRYING HANDLE 10 OPEN CLOSE CD BUTTON 22 VOLUME CONTROL 11 FM STEREO INDICATOR 23 FUNCTION SWITCH 12 PROGRAM INDICATOR 24 PHONES JACK 25 BATTERY COMPARTMENT GB1 e SR24CD ENG FM LENCO TCDOBAS indd3 3 2009 4 16 04 50 19 POWER SUPPLY USING HOUSE CURRENT Before use check that the rated voltage of your unit matches your local voltage USING BATTERIES Disconnect the AC power cord from the AC inlet of the unit Battery power is cut automatically by the cord while it is connected a When the volume decrease or the sound distorts replace all of the batteries with new ones v Insert 6 UM 2 L size C batteries battery door ADJUSTING THE SOUND TO ADJUST THE VOLUME VOLUME FOR PRIVATE LISTENING Plug in headphones 23 5 mm stereo mini plug to the e PHONES jack When headphones are plugged in the speakers are automatically disconnected

Download Pdf Manuals

image

Related Search

Related Contents

Téléchargez le mode d`emploi - Alcatel  Bosch KIR21AF30G refrigerator  SWS-200 User Manual  Port-A-Cool LOUVER-KIT-16 Use and Care Manual  Siemens EMOTION 16-Jun User's Manual  TB-100 - Lojas Colombo  Triplett Fox 2 & Hound 3 Probe Kit  User's manual FLIR BuildIR  据付工事説明書    

Copyright © All rights reserved.
DMCA: DMCA_mwitty#outlook.com.