Atdec VF-WD flat panel wall mount
Contents
1. IMPORTANT Ensure you have received all parts against the component checklist prior to installing Wall Direct Assembly OPI ea Step 1 Using the supplied Allen Key remove the bottom screw Tip Use a Spirit Level to ensure this surface is horizontal 50mm Screw Wall Plug N 5mm Allen Key 50mm Screw x2 Wall Plug x2 Mounting Fasteners b y M4xlOmm Screw x4 t a M4xl2mm Screw x4 b a M4xl mm Screw x4 Step 2 Separate the two components Visidec Focus Wall Direct supports a maximum weight of 8kgs 17 5lbs TOOLS REQUIRED Power Drill 5 5mm 1 4 Drill Bit 8mm 5 16 Drill Bit Phillips Head Screwdriver NOTE This product is designed to support a flat panel monitor in a noninteractive environment i e It should not be used in a situation where the display s position will be frequently changed Timber Stud Wall Tip Use a Spirit Level to ensure this surface is horizontal Attach Head to Display M4 screw ras e ae 0 J v Vay 75x75mm VESA g _ AN Step 1 Step 2 Position the Close the two halves of the Bracket Display amp Bracket around the Base by firstly positioning over the Base the top half and then the bottom half Reassemble the Wall Direct Assembly ensuring the weight of the display is supported until the screw is tightened WARNING Tip This step can be made Do not easier by using two people overtighten F Adjust2. Display Position Step 1 Step 2 Adjust the display to Adjust the display s the desired viewing angle then lock it in landscape and portrait place by tightening The display can rotate the tilt screw in the through 95 direction shown WARNING NOTE Tighten Do not Screen does not overtighten rotate 360 position between No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd Due to continuing product development the manufacturer reserves the right to alter specifications without notice Published 18 01 08
Download Pdf Manuals
Related Search