Philips Curling iron HP4683
Contents
1. heat of the curler causes moisture that is naturally present in the surrounding air to evaporate My hair is not The appliance has not yet heated curled when up to the set temperature setting remove the styler from my hain You have used the appliance at a temperature setting that is too low for you hair type The word The appliance has not yet heated READY does up to the set temperature setting not appear on the display The tip of the You did not wind the tip of the hair is bent lock in the required direction in the wrong when you wound the lock around direction the barrel PHILIPS IX 100 recycled paper A100 papier recycl 4222 002 707 1 1 Solution Never put styling products in your hair before you use the curler Always use the appliance at a emperature setting that is suitable or your hair type This is normal and harmless Make sure you use a temperature setting hat is suitable for your hair type You can reduce the temperature setting if his setting still produces the desired curling result Let the appliance heat up until the word READY appears on the display Do not touch the barrel as you could burn yourself on them even if the appliance has not reached the set temperature setting yet Always use the appliance at a temperature setting that is suitable for your hair type Wait a few more minutes until the word READY appears on the display Make2. similarly qualified persons in order to avoid a hazard This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and nowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance eep the appliance away from non heat resistant surfaces and never cover the appliance with anything e g a towel or clothing when it is hot eep the appliance away from flammable items ever leave the appliance unattended when it is connected to the mains Caution For additional protection we advise you to install a residual current device RCD in the electrical circuit that supplies the bathroom This RCD must have a rated residual operating current not higher than 30mA Ask your installer for advice The barrel and the clip become hot during use Prevent the hot surfaces of the appliance from coming into contact with your skin The maximum temperature occurs just after heating up The actual temperature during use may be lower Always unplug the appliance after use For safety reasons the appliance automatically switches off after having been on for 1 hour Wait until the appliance has cooled down before you store it Always switch off the appliance before you put it down ev
3. Never wind the mains cord round the appliance Switch off the appliance and unplug it Let the appliance cool down completely on a heat resistant surface Store the appliance in a safe and dry place You can also store the appliance by hanging it from its hanging loop Bs Environment Do not throw away the appliance with the normal household waste at the end of its life but hand it in at an official collection point for recycling By doing this you help to preserve the environment Fig 14 mee Guarantee amp service EEE If you need service or information or if you have a problem please visit the Philips website at www philips com or contact the Philips Consumer Care Centre in your country you find its phone number in the worldwide guarantee leaflet If there is no Consumer Care Centre in your country go to your local Philips dealer mm Troubleshootin g mam This chapter summarises the most common problems you could encounter with the appliance If you are unable to solve the problem with the information below contact the Customer Care Centre in your country Problem Possible cause Solution The appliance does not work There is a power failure or the socket to which the appliance is connected is not live Check if the power supply works If it does plug in another appliance to check whether the socket is live Set the on off slide to I to switch on the appliance You have not switched on the applian
4. Release the lever and slide the barrel to the end of the lock of hair Fig 9 Take the cool tip between your fingertips and wind the lock of hair around the barrel until you have almost reached your scalp Make sure the end of the lock of hair is wound in the required direction Fig 10 Hold the curler in this position for 10 seconds Unwind the lock of hair until you can open the clip again with the lever Fig 11 Note Do not pull at the curler when you unwind the lock otherwise you would straighten the curl Let your hair cool down Do not comb or brush it before it has cooled down as this would ruin the hairstyle you have just created To switch off the appliance set the on off slide to 0 Temperature lock This appliance has a locking function to fix the selected temperature setting for the duration of the curling session To activate the temperature lock press and hold the temperature decrease lock button for a few seconds Fig 12 D The lock symbol appears on the display Fig 13 To deactivate the temperature lock press and hold the temperature decrease lock button again for a few seconds D The lock symbol disappears from the display m Cleaning Never immerse the appliance in water or any other liquid nor rinse it under the tap E Switch off the appliance and unplug it Let the appliance cool down completely on a heat resistant surface Clean the appliance with a damp cloth ma Sto rage
5. ce Set the on off slide to 0 and then to l again to switch the appliance off and on again The appliance switched off automatically after having been on for 1 hour The appliance is not suitable for the voltage to which it is connected The mains cord of the appliance is damaged The You have activated the temperature temperature lock cannot be set In some climates and surroundings the air contains Smoke escapes when open the clip Make sure that the voltage indicated on the appliance corresponds to the local mains voltage If the mains cord is damaged you must have it replaced by Philips a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard Press and hold the temperature decrease lock button for a few seconds until the lock symbol disappears from the display This is normal and harmless more moisture than in others The heat of the curler causes moisture that is naturally present in the surrounding air to evapor rate TRESemme USED BY PROFESSIONALS HP4684 07 HP4683 07 www philips com Problem Possible cause Smoke escapes from the hair or You have put styling products in your hair e g mousse spray from the curler or gel during use You have used the appliance at a temperature setting that is too high for you hair type In some climates and surroundings the air contains more moisture than in others The
6. en if it is only for a moment Do not leave the barrel in your hair for more than a few seconds at a time to prevent damage to your hair Do not wind the mains cord round the appliance Only use the appliance on dry hair Do not use the appliance on artificial hair Do not use the appliance for any other purpose than described in this manual eep the barrel and the clip clean and free of dust dirt and styling products such as mousse spray and gel Dust dirt and styling products may cause damage to he ceramic coating The barrel and the clip have a ceramic coating This coating slowly wears away over time This does not affect the performance of the appliance Ifyou use the appliance on colourtreated hair the barrel may stain Electromagnetic fields EMF This Philips appliance complies with all standards regarding electromagnetic fields EMF If handled properly and according to the instructions in this user manual the appliance is safe to use based on scientific evidence available today ma Using the appliance REE Curlers are powerful styling tools and must always be used with care As with all curlers that reach salon high temperatures do not use the appliance frequently to avoid damage to the hair If you use the curler incorrectly or if you use it at the wrong temperature setting you could overheat your hair or even burn it Curling Put the plug in the wall socket Set the o
7. k your way up to the crown ake the lock of hair you want to curl and comb it first to get rid o EJ Take the lock of hair y l and comb it fi get rid of tangles Fig 7 Press the lever to open the clip Place the lock of hair between the barrel and P P the clip Fig 8
8. n off slide to I to switch on the appliance Fig 2 D The default temperature setting of 120 appears on the display Fig 3 DAs soon as the appliance has heated up to this setting the word READY appears on the display Never leave the appliance unattended when it is plugged in Always put the appliance on a heat resistant surface when it is heating up and when it is hot Select a temperature setting that is suitable for your hair type Always select a low setting when you use the curler for the first time For thick or coarse hair select a medium to high setting 170 and up For fine or normal hair select a medium to low setting 160 and below Take extra care with pale blonde bleached or colour treated hair since it is susceptible to damage at high temperature settings Press the button to increase the temperature setting or the button to decrease the temperature setting Fig 4 D The display shows the selected temperature setting DAs soon as the appliance has heated up to the set temperature setting the word READY appears on the display Fig 5 If you want to lock the set temperature setting press and hold the temperature decrease lock button for a few seconds see section Temperature lock Fl Divide your hair into locks and put them aside with clips Fig 6 Note The thinner the lock of hair the tighter the curl becomes Start curling at the lower part of your head and wor
9. sure you wind the tip of the lock in the required direction when you wind the lock around the barrel ENGLISH gee ntroductio n EE Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your product at www philips com welcome This TRESemm Philips appliance is designed and created to give you the salon styles you want in a quick and easy way We hope you enjoy using this TRESemm Philips styler mm General description Fig 1 SS Cool tip Clip Lever andle anging loop Barrel Support Display Temperature decrease lock button Temperature increase button On off slide A IaAT TM OONAD A mM portant Read this user manual carefully before you use the appliance and save it for future reference Danger Keep the appliance away from water Do not use it near or over water contained in baths washbasins sinks etc When you use the appliance in a bathroom unplug it after use The proximity of water presents a risk even when the appliance is switched off Warning Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance Check the condition of the mains cord regularly Do not use the appliance if the plug the mains cord or the appliance itself is damaged _ If the mains cord is damaged you must have it replaced by Philips a service centre authorised by Philips or
Download Pdf Manuals
Related Search