Philips AZ1122 CD Soundmachine
Contents
1. WARNING Always check you have completely switched off the set before you change or disconnect power supply Check if the power voltage as shown on 1 the type plate located on the bottom of the set corresponds to your 2 local power supply If it does not consult your dealer or service center If your set is equipped with a voltage selec tor adjust the selector so that it matches with the local power supply Connect the power cord to the AC MAINS inlet and the wall socket The set is now connected and ready for use 1 To switch the set off completely withdraw the power cord from the wall socket 2 Install the unit near the AC outlet and where the AC power plug can be easily reached Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms The type plate is located on the bottom of the set Helpful hints To avoid unnecessary energy consumption always adjust the Source selector to OFF after using the set General Operation Tuner General operation Switching on and off and selecting the function To select your sound source adjust the Source selector to CD FM or MW To switch off the set adjust the Source selector to OFF position Adjusting volume Adjust the sound with the VOLUME control Radio reception Adjust the Source selector to FM or MW to select your desiredwaveband Turn TUNING to tune to a station Helpful hints To improve radio re2. lens steamed up e Wait until lens has cleared CD R CD RW is blank or not finalized Use a finalized CD R CD RW or suitable CD Audio disc only Note Make sure the CD is not encoded with Copyright protection technologies as some do not conform to the Compact Disc stan dard The CD skips tracks CD damaged or dirty Replace or clean CD Program Shuffle is active Quit program shuffle mode Note A CD badly scratch or dirty may result in improper operation
3. with PROGRAM REP plays the current track continuously REP ALL repeats the entire CD program To select play mode press REPEAT once or more gt The display shows REP or REP ALL Press PII to start playback if in the stop pause position To return to normal playback press REPEAT repeatedly until the modes are no longer displayed You can also press M to cancel your play mode SHUFFLE You can play all the tracks in random order In the stop position press SHUFFLE to switch on shuffle play 3 Display shows SHUF To switch off shuffle play press lll Helpful hints During the shuffle play when REP function is selected it will play the current shuffled track repeatedly or when the REP ALL function is selected it will repeat the shuffle play of the entire CD Shuffle play is not available in the program mode Maintenance amp Safety See CD player and CD handling If the CD player cannot read CDs correctly use a cleaning CD to clean the lens before aking the set to repair The lens ofthe CD player should never be ouched Sudden changes in the surrounding emperature can cause condensation on the ens of your CD player Playing a CD is then not possible Do not attempt to clean the ens but leave the set in a warm environment until the moisture evaporates Always close the CD tape door to avoid dust on the lens To clean the CD wipe in a st
4. you recognize the passage you want release is or pel to resume normal playback Helpful hints When your searching reaches the end of the last track the CD goes to stop mode Programming track num bers You may store up to 20 tracks in the desired sequence If you like store any track more than once In the stop position press PROG to activate programming Display PROG and 3 flash See 4 Press is or to select your desired track number Press PROG to store the desired track number 3 Display PROG and program the next track flash for you to Repeat steps 2 to 3 to select and store all desired tracks in this way 3 If you attempt to store more than 20 tracks no track can be selected and the display shows flashing To play your program press PII Helpful hints When playback of your program comes to the stop position your set will return to normal playback To re enter program mode press PROG in the stop position CD Player Reviewing the program In the stop position press PROG repeatedly to see your stored tracks Erasing a program You can erase the contents of the memory by in the stop position press PROG to enter program mode and then press W selecting FM MW or OFF opening the CD door Different play modes REPEAT and SHUFFLE See 5 6 REPEAT You can play the current track or the whole disc repeatedly and combine REPEAT modes
5. Meet Philips at the Internet CD Soundmachine AZ1122 http www philips com AZ1123 User Manual Manual del usario Manual do usu rio CLASS 1 LASER PRODUCT AZ 1122 AZ 1123 PHILIPS p LI PS Printed in China JH 0603 gt DA 25 oe Mexico NOM 5 Es necesario que lea cuidadosamente su instructivo de manejo PRECAUCI N ADVERTENCIA No abrir riesgo de choque el ctrico ATENCI N Verifique que el voltaje de alimentaci n sea el requerido para su aparato Para evitar el riesgo de choque el ctrico no quite la tapa En caso de requerir servicio dirijase al personal calificado Descripci n Radio MW FM con reproductor de CD Modelo AZ1123 78 Alimentaci n 110 127 220 240 V 50 60 Hz Consumo 18 W Importador Philips Mexicana S A de C V Domicilio Av La palma No 6 Col San Fernando la Herradura Huixquilucan Localidad y Telefono Edo de M xico C P 52784 Tel 52 69 90 00 Exportador Philips Electronics Hong Kong Ltd Pa s de Origen China N de Serie LEA CUIDADOSAMENTE ESTE INSTRUCTIVO ANTES DE USAR SU APARATO a D AVISO IMPORTANTE Philips Mexicana S A de C V no se hace responsable por da os o desperfectos causados por Maltrato des
6. ception For FM extend incline and turn the telescop ic antenna for best reception Reduce its length if the signal is too strong For MW the set uses a built in antenna Direct this antenna for best reception by turning the whole set CD Player Playing a CD This CD player plays Audio Discs including CD Recordables CD R and CD Rewritables 1 CD RW MP3 CD ROM CD CDV VCD DVD or computer CDs are not possible for playback 2 IMPORTANT CDs encoded with copyright protection technologies by some record companies may be unplayable by this product 1 Adjust the Source selector to CD 2 Open the CD door 3 Insert a CD with the printed side facing up then press the CD door gently to close gt Display shows and later the total number of tracks See 2 4 Press PII to start playback 1 5 To pause playback press PH 3 Display flashes See 3 6 To resume press PII again 7 To stop CD playback press El Helpful hints CD play will also stop when you open the CD door you select FMMW or OFF the CD has reached the end Selecting a different track e Press lt pi once or repeatedly until the desired track number appears in the display e In the pause stop position press Pto start _ playback Finding a passage within a track During playback press and hold i or pi 3 The CD is played at high speed and with reduced volume When
7. cket Helpful hints The speakers will be muted when headphones are connected to the set AC MAINS inlet for power cord Voltage selector not for all versions adjust to match the local voltage 110 220V before plugging in the set Controls Power Supply CAUTION Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation Power Supply Whenever convenient use the power supply cord if you want to conserve battery life Make sure you remove the plug from the set and wall outlet before inserting batteries Batteries not included Open the battery door and insert 6 batteries type R 14 UM 2 or C cells preferably 4 alkaline with the correct polarity as indicated by the and symbols inside the com 5 partment See 1 Replace the battery door making sure the bat teries are firmly and correctly in place The set is now ready to operate Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst Do not mix battery types e g alkaline with car bon zinc Only use batteries of the same type for the set When inserting new batteries do not try to mix old batteries with the new ones Remove the batteries f the set is not to be used for a long time Batteries contain chemical substances so they should be disposed of properly Power Supply Using AC power
8. cuido o mal uso presencia de insectos o roedores cucarachas ratones etc Cuando el aparato no haya sido operarado de acuerdo con el instructivo del uso fuera de los valores nominales y tolerancias de las tensiones voltaje frecuencia ciclaje de alimentaci n el ctrica y las caracter sticas que deben reunir las instalaciones auxiliares Por fen menos naturales tales como temblores inundaciones incendios descargas el ctricas rayos etc o delitos causados por a terceros choques asaltos rifias etc a English Supplied Accessories AC power cord Top front panels See 1 1 Source selector CD FM MW or OFF selects CD or radio FM MW source of sound power off switch 2 PI starts or pauses CD playback Di 44 selects the next previous track fast searches forwards backwards press and hold the button PROG programs tracks and reviews the program E stops CD playback erases a CD program Display shows the CD functions REPEAT repeats a track CD program entire CD SHUFFLE plays all tracks in random order OPEN CLOSE opens closes the CD door TUNING tunes to radio stations VOLUME adjusts volume level OQ 0606 00 Back bottom panels See 1 Telescopic antenna improves FM reception Battery door open to insert 6 x 1 5V R 14 UM 2 C cells GD M 3 5 mm stereo headphone so
9. raight line from the center towards the edge using a soft lint free cloth Do not use cleaning agents as they may damage the disc Never write on a CD or attach any stickers to it Safety information Place the set on a flat hard and stable surface so that the system does not tilt Do not expose the set batteries CDs to humidity rain sand or excessive heat caused by heating equipment or direct sunlight The apparatus shall not be exposed to drip ping or splashing Adequate ventilation with a minimum gap of 15cm 6 inches between the ventilation holes and surrounding surfaces is necessary o prevent heat build up Do not cover the ventilation openings with items such as newspapers table cloths cur ains etc No objects filled with liquids such as vases shall be placed on the apparatus No naked flame sources such as lighted can dles should be placed on the apparatus The mechanical parts of the set contain self lubricating bearings and must not be oiled or lubricated To clean the set use a dry cloth Do not use any cleaning agents containing alcohol ammonia benzene or abrasives as these may harm the housing Environmental information All unnecessary packaging material has been omitted The packaging can be easily separated into three materials cardboard polystyrene and plastic Your set consists of materials which can be recycled if disassembled by a specialized compan
10. y Please observe the local regulations regarding the disposal of packaging dead batteries and old equipment Troubleshooting If a fault occurs first check the points listed below before taking the set for repair If you are unable to remedy a problem by following these hints consult your dealer or service centre WARN I N G Do not open the set as there is a risk of electric shock Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee Problem Possible cause Remedy No hay sonido energia Volume not adjusted Adjust the VOLUME Power cord not securely connected Connect the AC power cord properly Batteries dead incorrectly inserted Insert fresh batteries correctly Headphones connected to the set Disconnect headphones CD contains non audio files Press iss ppl once or more to skip to a CD audio track instead of the data file Display does not function properly No reaction to operation of any of the controls Electrostatic discharge Switch off and unplug the set Reconnect after a few seconds Severe radio hum or noise Electrical interference set too close to TV VCR or computer Increase the distance Poor radio reception Weak radio signal FM Adjust the FM telescopic aerial indication No CD inserted Insert a CD CD badly scratched or dirty Replace clean CD see Maintenance Laser
Download Pdf Manuals
Related Search