Sun Fire V100 Server Product Notes
Contents
1. 3 Ram test 2048 bytes OK Initialising i2c bus OK Searching for EEPROMs 50 cfg I2c eeprom 50 OK i2c bus speed code 01 OK Probing for Im80s none Probing for lm75s 48 Initialising 1lm75 48 OK System functions PSUs fans breakers rails gpio temps host CLI ebus clock Unexpected reset LOMlite console lom gt LOM event 0h0m0s LOM FAULT unexpected reset lom gt LOM event 0h0m0s host power on If your system hangs when you have disconnected power and then restored it within 10 seconds of the disconnection do either of the following m Type a carriage return and then type the LOM escape sequence a hash character followed by a dot At the LOM prompt type poweroff At the next LOM prompt type poweron The system will power on m Hold the rocker switch in the OFF position until the console reports the time stamped host power off LOM event then put the rocker switch into the ON position The system will then power on If you have the NVRAM diag switch parameter set to true by default it is set to false and the console output is as shown above the system will provide additional Open Boot PROM output during the boot process In this case if you restore power within 10 seconds of removing it the system hangs after reporting the following message Sun Fire V100 Server Product Notes May 2002 Probing pci 1f 0 Device a usb To restore power use either of the two met2. Sun Microsystems Inc 901 San Antonio Road Palo Alto CA 94303 4900 U S A 650 960 1300 Part No 816 2754 13 May 2002 Revision A Send comments about this document to docfeedback sun com S amp SUN microsystems Sun Fire V100 Server Product Notes Copyright 2002 Sun Microsystems Inc 901 San Antonio Road Palo Alto CA 94303 4900 U S A All rights reserved This product or document is distributed under licenses restricting its use copying distribution and decompilation No part of this product or document may be reproduced in any form by any means without prior written authorization of Sun and its licensors if any Third party software including font technology is copyrighted and licensed from Sun suppliers Parts of the product may be derived from Berkeley BSD systems licensed from the University of California UNIX is a registered trademark in the U S and other countries exclusively licensed through X Open Company Ltd Sun Sun Microsystems the Sun logo AnswerBook2 docs sun com Netra and Solaris are trademarks registered trademarks or service marks of Sun Microsystems Inc in the U S and other countries All SPARC trademarks are used under license and are trademarks or registered trademarks of SPARC International Inc in the U S and other countries Products bearing SPARC trademarks are based upon an architecture developed by Sun Microsystems Inc The OPEN LOOK and Sun Graphical User Interface was dev
3. TIONS ET GARANTIES EXPRESSES OU TACITES SONT FORMELLEMENT EXCLUES DANS LA MESURE AUTORISEE PAR LA LOI APPLICABLE Y COMPRIS NOTAMMENT TOUTE GARANTIE IMPLICITE RELATIVE A LA QUALITE MARCHANDE A L APTITUDE A UNE UTILISATION PARTICULIERE OU A L ABSENCE DE CONTREFA ON Od ro Ca Adobe PostScript Introduction This document provides information that became available after the Sun FireTM V100 Server User s Guide went to print The document contains the following sections Available Online Documentation on page 4 System Software Requirements on page 4 Reinstalling the Solaris Operating Environment on page 4 Using the Solaris Network Cache and Accelerator SNCA on page 4 Front Bezel on page 5 Precautions for Using the System Configuration Card on page 6 Open Issues on page 6 Optional Components on page 9 Hardware Configurations on page 9 Operating Power Statistics on page 10 Available Online Documentation Online documentation is available at the following URL http www sun com products n solutions hardware docs Check this site periodically for the latest versions of the product documentation System Software Requirements The Sun Fire V100 server requires the Solaris 8 2 02 Operating Environment or later The server is supplied with this software preinstalled Reinstalling the Solaris Operating Environment The earliest version of the Solaris opera
4. ar des fournisseurs de Sun Des parties de ce produit pourront tre d riv es des syst mes Berkeley BSD licenci s par l Universit de Californie UNIX est une marque d pos e aux Etats Unis et dans d autres pays et licenci e exclusivement par X Open Company Ltd Sun Sun Microsystems le logo Sun AnswerBook2 docs sun com Netra et Solaris sont des marques de fabrique ou des marques d pos es ou marques de service de Sun Microsystems Inc aux Etats Unis et dans d autres pays Toutes les marques SPARC sont utilis es sous licence et sont des marques de fabrique ou des marques d pos es de SPARC International Inc aux Etats Unis et dans d autres pays Les produits portant les marques SPARC sont bas s sur une architecture d velopp e par Sun Microsystems Inc L interface d utilisation graphique OPEN LOOK et Sun a t d velopp e par Sun Microsystems Inc pour ses utilisateurs et licenci s Sun reconna t les efforts de pionniers de Xerox pour la recherche et le d veloppement du concept des interfaces d utilisation visuelle ou graphique pour l industrie de l informatique Sun d tient une licence non exclusive de Xerox sur l interface d utilisation graphique Xerox cette licence couvrant galement les licenci s de Sun qui mettent en place l interface d utilisation graphique OPEN LOOK et qui en outre se conforment aux licences crites de Sun LA DOCUMENTATION EST FOURNIE EN L ETAT ET TOUTES AUTRES CONDITIONS DECLARA
5. bout transferring the system configuration card from one server to another refer to the Sun Fire V100 Server User s Guide 816 2756 10 Open Issues The following sections cover some open issues with the Sun Fire V100 server 64 Bit Support When installing a system ensure that the selected install option supports the 64 bit kernel Note The install option that takes up the least disk space labelled Core System Support supports 32 bit operation only and is not compatible with the Sun Fire V100 server 6 Sun Fire V100 Server Product Notes May 2002 Sending Break During Boot Process Can Result In Failure To See Disk On Reset If a break is sent to the system console while the system is booting there is a small chance of a subsequent failure to detect the boot disk The prom may report Boot device disk File and args Bad checksum in disk label Can t open disk label package Evaluating boot Can t open boot device To recover power the system off for 1 minute and then power it back on 8 No Auto Power On When Power is Removed and Restored Within 10 Seconds If you disconnect the server from its power source while it is powered on and then reconnect it within 10 seconds of the disconnection the server automatically attempts to power on However it does not reinitialize successfully and hangs after giving the following console output LOMlite starting up CPU type H8 3437S mode
6. eloped by Sun Microsystems Inc for its users and licensees Sun acknowledges the pioneering efforts of Xerox in researching and developing the concept of visual or graphical user interfaces for the computer industry Sun holds a non exclusive license from Xerox to the Xerox Graphical User Interface which license also covers Sun s licensees who implement OPEN LOOK GUIs and otherwise comply with Sun s written license agreements Federal Acquisitions Commercial Software Government Users Subject to Standard License Terms and Conditions DOCUMENTATION IS PROVIDED AS IS AND ALL EXPRESS OR IMPLIED CONDITIONS REPRESENTATIONS AND WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY FITNESS FOR A PARTICULAR PURPOSE OR NON INFRINGEMENT ARE DISCLAIMED EXCEPT TO THE EXTENT THAT SUCH DISCLAIMERS ARE HELD TO BE LEGALLY INVALID Copyright 2002 Sun Microsystems Inc 901 San Antonio Road Palo Alto CA 94303 4900 Etats Unis Tous droits r serv s Ce produit ou document est distribu avec des licences qui en restreignent l utilisation la copie la distribution et la d compilation Aucune partie de ce produit ou document ne peut tre reproduite sous aucune forme par quelque moyen que ce soit sans l autorisation pr alable et crite de Sun et de ses bailleurs de licence s il y en a Le logiciel d tenu par des tiers et qui comprend la technologie relative aux polices de caract res est prot g par un copyright et licenci p
7. hods described above Note Any interruption and subsequent restoration of mains power within 10 seconds could cause this fault to occur Optional Components There is an error on page 4 of the Sun Fire V100 Server User s Guide The part number for the 512 Mbyte DIMM is incorrectly given as X7084A The correct part number is X7092A Hardware Configurations This section contains additional information to that contained in the table on page 108 of the Sun Fire V100 Server User s Guide 816 2756 10 The table below gives the configuration information for servers containing the 550 MHz and 650 MHz processor Processor RAM Hard Disk Drive Sun Part Number 550 MHz 256 MB 1 256 MB 1 40 GB 7200 rpm 600 7995 xx 550 MHZ 512 MB 2 256 MB 1 40 GB 7200 rpm 600 7996 xx 650 MHz 1 GB 4 256 MB 2 40 GB 7200 rpm 600 7997 xx 650 MHz 2 GB 4 512 MB 2 40 GB 7200 rpm 600 7998 xx Operating Power Statistics This section contains additional information to that given in the table on page 117 of the Sun Fire V100 Server User s Guide 816 2756 10 The BTU hr figure for servers containing the 550 MHz and 650 MHz processor is given below a 500 550 650 MHz processor 148 min 280 max 10 Sun Fire V100 Server Product Notes May 2002
8. rt 80 family nca security off acceptorthreads 1 gt The server must be listening on port 80 for this to work Restart the server The changes you have just made will not take effect until the server is rebooted For more information go to the URL below m http docs iplanet com docs manuals enterprise 50 tuning conte nts htm Front Bezel There is a blank nameplate built into the bezel just below the Sun Fire V100 badge This allows you to easily attach a unique identifier to the server Precautions for Using the System Configuration Card The Sun Fire V100 server contains a memory card located on the back panel called the system configuration card This card contains the system s MAC address serial number and other configuration settings It is designed to be removable so that if you ever need to replace an entire server you can transfer the host ID and configuration data onto the new server This makes the replacement of the server transparent to your network Caution Never remove the system configuration card when the server is booting or running Solaris Power the server off or down to standby mode before removing or inserting the system configuration card it to another system If you need to handle it for this reason avoid contact with the A Caution Do not handle the system configuration card unless you need to transfer gold terminals on the underside of the card For information a
9. ting environment supported on the Sun Fire V100 server is Solaris 8 2 02 To reinstall the Solaris operating environment onto a Sun Fire V100 server refer to the Solaris Installation Guide 806 0955 10 and the Solaris Advanced Installation Guide 806 0957 10 Using the Solaris Network Cache and Accelerator SNCA The Solaris Network Cache and Accelerator SNCA is a caching server which provides improved web performance to the Solaris Operating Environment It is available on Solaris 8 07 01 or later The steps below tell you how to enable SNCA to work with iPlanet Web Server 4 Sun Fire V100 Server Product Notes May 2002 Note Ensure you have the required NCA specific software patches installed on the server before you continue with this procedure In the Solaris operating environment edit the configuration interface file etc nca nca if and add to the first non comment line This enables SNCA for all network interfaces Make the following changes to the etc nca ncakmod conf file m set the status field to enabled m set the ncad_status field to enabled Make the following change to the etc nca ncalogd conf file m set the status field to enabled Reboot the server The changes you have just made will not take effect until the server is rebooted In the iPlanet Web Server server xml file ensure the listen socket on port 80 includes family nca as shown below lt LS id ls1 ip 0 0 0 0 po
Download Pdf Manuals
Related Search