S2500THS Quick Guide v3
Contents
1. Status Indicator LED s Press ON OFF button to turn printer on Three LED indicators located on the top of the printer indicate various printer functions LED will indicate function as described below Status Green If the LED s Color is Green it indicates that Power is ON and that the printer is in RS232 or IrDA mode If the LED is Purple it indicates that the printer s Oanas Purcis power is low in BT mode and if it is Orange it 9 p indicates that the printer s battery is low when the printer is in RS232 mode LED 1 BI If the LED s Color is Blue it indicates that Power is ON ai and that the printer is in Bluetooth mode The battery charger is charging the battery at a fast rate If the battery is below 5V the battery is being LED 2 Yellow trickle charged until the battery voltage reaches 5V and then the fast charge rate is started The LED will turn off when the battery is fully charged Indicates that MCR is ready to accept data Green Indicates that SCR is ready to accept data Indicates a fault condition or a printer error The printer is not ready to accept data Red Printer is out of paper Note Refer to the troubleshooting guide to determine error or fault condition LED 3 LED 1 LED 2 LED 3 Performing Self Test 1 Turn off printer 2 Press and Hold Paper Feed Button 3 While holding Paper Feed Button press On Off Button Copyright 2007 E2. tor 2 Plug battery charger adaptor into the appropriate AC line voltage socket 3 LED will illuminate indicating that the battery is being charged 4 The battery will be fast charged and after 180 minutes the LED will turn off Installing the Paper Roll 1 Press Paper Door Release button The door will open slightly Open rest of the way as shown Note Paper Door Release button must be depressed when opening and closing paper door 2 Install Paper Roll Sx Note Pull Paper Roll Leader Out of Printer Note Direction of Paper Travel 3 While pressing Paper Door Release button close paper door 4 Press paper door down and let go of Paper Door Release button 5 Turn on the printer by pressing Power button and test the paper advance function by pressing the Paper Feed button Verify that paper advances correctly Tearing Paper The printer s paper door acts as tear bar To tear paper pull one edge of the paper against the tear bar as shown then tear down and across against the tear bar to tear the paper Note Pulling paper up and or sideways without using the tear bar can cause a paper jam due to paper misalignment in printhead mechanism
3. xtech Instruments Corporation All rights reserved including the right of reproduction in whole or in part in any form Extech Instruments Corporation 285 Bear Hill Rd Waltham MA 02451 1064 062707 R2 Phone 1 781 890 7440 Fax 781 890 7864 WEB www extech com printers Model S2500THS EX TECH Mobile Printer INSTRUMENTS Quick Start Guide This guide provides a reference illustration of the initial steps to quickly get your Model S2500THS up and running Refer to the User s Guide for more detailed information on the operation and use of Model S2500THS A copy of User s Guide can be downloaded from www extech com printers S2500THS Overview ON Paper Door Roller Release Button Paper Compartment MCR Slot EXTECH INSTRUMENTS On Off Paper Feed Button Button IrDA na N Belt Clip AC Adaptor Serial Window Port Port Installing the Battery 1 Unlock the battery door by sliding the locking tab down 2 Open the battery door to an angle of about 90 degrees Do not force open Li lon grr Battery Battery Door Tab Note Ensure that battery side with 2 contact terminals are facing down to make contact with the spring probes inside the battery compartment 3 Insert battery as shown non contact end first and let the contact end drop into place 4 Close the battery door by sliding the locking tab up Charging the Battery 1 Plug battery charger adaptor output cable into the battery charger connec
Download Pdf Manuals
Related Search