Manual - Crestron
Contents
1. and Radiocommunications Compliance Labelling CE 2 e Interface Module TPMC L IMC Return and Warranty Policies Merchandise Returns Repair Service 1 No merchandise may be returned for credit exchange or service without prior authorization from CRESTRON To obtain warranty service for CRESTRON products contact the factory and request an RMA Return Merchandise Authorization number Enclose a note specifying the nature of the problem name and phone number of contact person RMA number and return address 2 Products may be returned for credit exchange or service with a CRESTRON Return Merchandise Authorization RMA number Authorized returns must be shipped freight prepaid to CRESTRON 6 Volvo Drive Rockleigh N J or its authorized subsidiaries with RMA number clearly marked on the outside of all cartons Shipments arriving freight collect or without an RMA number shall be subject to refusal CRESTRON reserves the right in its sole and absolute discretion to charge a 15 restocking fee plus shipping costs on any products returned with an RMA 3 Return freight charges following repair of items under warranty shall be paid by CRESTRON shipping by standard ground carrier In the event repairs are found to be non warranty return freight costs shall be paid by the purchaser CRESTRON Limited Warranty CRESTRON ELECTRONICS Inc warrants its products to be free from manufacturing defects in materials and workmanshi2. IBLE CORRECTIVE CAUSE S ACTION PWR LED TPMC L IMC Verify that the does not is not TPMC L IMC is illuminate receiving properly connected power to the power supply Fuse is blown Remove wires that connect to the touchpanel Using a Phillips tip screwdriver remove the enclosure cover and replace the fuse with an 8A 250V 1 x Time Lag fuse Replace the cover and reconnect the wires to the touchpanel PWR LED Incorrect Verify that the extinguishes wiring polarity between after between TPMC L IMC and connecting TPMC L IMC the touchpanel is to and correct to and touchpanel touchpanel to Check the wiring between the TPMC L IMC and the touchpanel for shorts Further Inquiries If you cannot locate specific information or have questions after reviewing this sheet please take advantage of Crestron s award winning customer service team by calling the Crestron corporate headquarters at 1 888 CRESTRON 1 888 273 7876 For assistance in your local time zone refer to the Crestron website www crestron com for a listing of Crestron worldwide offices You can also log onto the online help section of the Crestron website to ask questions about Crestron products First time users will need to establish a user account to fully benefit from all available features As of the date of manufacture the TPMC L IMC has been tested and found to comply with specifications for CE marking and standards per EMC
3. Z CRESTRON Interface Module TPMC L IMC Description The TPMC L IMC interface module is included with the TPMC 15 CH L TPMC 15 QM L TPMC 17 CH L and TPMC 17 QM L touchpanels The TPMC L IMC is used to deliver power from a power supply to a remotely located wall mount touchpanel The TPMC L IMC converts the cable used by the touchpanel s included power supply to two wires see chart in following column which allows a wall mount touchpanel to be installed up to 60 feet from its power supply The wire runs are terminated on the rear of the TPMC 15 17 wall mount touchpanel where they are converted to the cable type required by the touchpanel An LED indicates when power is supplied to the TPMC L IMC The TPMC L IMC has a mounting flange to secure the unit to a mounting surface or the rear of a rack as shown in the following diagram The TPMC L IMC should be installed near the power supply Physical Views of the TPMC L IMC 2 14 in 5 42 cm i l 2 53 in 3 43 in mG 6 42 cm 8 70 cm l gt p Jo k z 1 1 05 in 1 jeer em 1 97 in 5 00 cm 2 23 in 5 66 cm Installation CAUTION Ensure that the power is disconnected during installation CAUTION Only the included Crestron power supply should be used Crestron Electronics Inc 15 Volvo Drive Rockleigh NJ 07647 Tel 888 CRESTRON Fax 201 767 7576 1 As shown in the following diagram connect the power wires from the TPMC L IMC to the r
4. ear of the touchpanel using the supplied connectors Crestron recommends using two 60 foot runs or less of 14 gauge stranded wire between the touchpanel and the TPMC L IMC Hardware Hookup CABLE CONNECTED TO PWR PORT ON BOTTOM OF TOUCHPANEL TIN TO TOUCHPANEL 60 ft MAX 14 GAUGE x2 A OBSERVE POLARITY to and to PWR IN FROM EXTERNAL POWER SUPPLY Alternatively a single wire can be run over a shorter distance Smaller gauge wires can be used for shorter runs as well Refer to the following table for wiring alternatives Recommended Wire Lengths Between TPMC L IMC and Touchpanel WIRE SINGLE WIRE DOUBLE WIRE GAUGE FEET FEET 14 AWG 30 60 2 5 mm 16 AWG 20 40 1 5 mm NOTE If running a single wire either PWR OUT connector can be used Observe polarity when terminating wire to and to 2 Connect the power cable from the external power supply to the PWR IN port of the TPMC L IMC The PWR LED will illuminate Data Sheet DOC 6385 2013189 07 05 Specifications subject to change without notice www crestron com Interface Module TPMC L IMC Z CRESTRON Problem Solving Troubleshooting The table after this paragraph provides corrective action for possible trouble situations If further assistance is required please contact a Crestron customer service representative TPMC L IMC Troubleshooting TROUBLE POSS
5. p under normal use for a period of three 3 years from the date of purchase from CRESTRON with the following exceptions disk drives and any other moving or rotating mechanical parts pan tilt heads and power supplies are covered for a period of one 1 year touchscreen display and overlay components are covered for 90 days batteries and incandescent lamps are not covered This warranty extends to products purchased directly from CRESTRON or an authorized CRESTRON dealer Purchasers should inquire of the dealer regarding the nature and extent of the dealer s warranty if any CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any application other than that for which it was intended or if it has been subjected to misuse accidental damage modification or improper installation procedures Furthermore this warranty does not cover any product that has had the serial number altered defaced or removed This warranty shall be the sole and exclusive remedy to the original purchaser In no event shall CRESTRON be liable for incidental or consequential damages of any kind property or economic damages inclusive arising from the sale or use of this equipment CRESTRON is not liable for any claim made by a third party or made by the purchaser for a third party CRESTRON shall at its option repair or replace any product found defective without charge for parts or labor Repaired or replaced equi
6. pment and parts supplied under this warranty shall be covered only by the unexpired portion of the warranty Except as expressly set forth in this warranty CRESTRON makes no other warranties expressed or implied nor authorizes any other party to offer any warranty including any implied warranties of merchantability or fitness for a particular purpose Any implied warranties that may be imposed by law are limited to the terms of this limited warranty This warranty statement supercedes all previous warranties Trademark Information All brand names product names and trademarks are the sole property of their respective owners Windows is a registered trademark of Microsoft Corporation Windows95 98 Me XP and WindowsNT 2000 are trademarks of Microsoft Corporation Data Sheet DOC 6385
Download Pdf Manuals
Related Search