Heart Rate Receiver Installation on a Model E
Contents
1. INSTALLING THE POLAR HEART RATE INTERFACE ON THE MODEL E INDOOR ROWER KO concept 2z INDOOR ROWER mmm J clips concept2 com Y Flywheel Flywheel j Vf Pickup Pickup 4 Cable Flywheel Pickup Cable 0209 Page 1 Continued on other side HR receiver Note for Storage Before disconnecting monorail from front end remove receiver from VELCRO patch HOW TO WEAR POLAR OR POLAR COMPATIBLE HEART RATE MONITOR 1 WET THE ELECTRODE AREAS OF ELASTIC CHEST BELT Wet the electrode area the two rectangular areas on the underside of the chest belt thoroughly under running water 2 ATTACH THE CONNECTOR TO THE ELASTIC CHEST BELT Position the letter L on the connector next to the word LEFT on the chest belt and snap the fastener 3 SECURE THE ELASTIC CHEST BELT Center the chest belt flat against your skin as high under the pectoral muscles breasts as is comfortable The logo should be right side up Snap the second fastener The chest belt should fit snugly and comfortably and allow for normal breathing 4 ROW Your heart rate will be displayed in the center right display in all display modes See photo at right m lt Read heart l rate here NOTE It sometimes takes a few minutes of exercise to achieve a consistent heart rate signal PM4 Precautions e Thoroughly wipe your Polar elastic chest2. belt and connector dry after each use e Do not store in a non breathable or plastic bag where moisture may become trapped Store in a warm dry place e Do not expose your heart rate monitor to direct sunlight extreme heat above 50 Celsius 122 Fahrenheit or extreme cold below 10 Celsius 14 Fahrenheit e Do not bend or stretch the electrode strips on your chest belt especially when storing Troubleshooting Check the connection where the receiver cable plugs What if the heart rate reading is erratic or totally absent into the underside of the monitor Check the connection NOTE Occasionally the heart rate monitor will pick up between the cable and the receiver bad data for a number of reasons When the monitor If you are exercising within range of strong recognizes bad data the display will go blank rather electromagnetic signals the heart rate readings may than show the bad data It will take five seconds or elevate to abnormal levels Common sources of longer to re establish and display accurate readings electromagnetic signals are televisions computers cars 1 Repeat the electrode wetting procedure as described TV antennas high voltage power lines and motor driven above The electrodes must be wet to pick up exercise equipment accurate heart rate readings Signals from more than one HR monitor within the _ Make sure the connector is centered with electrodes transmission range 1 meter 3 feet may also cause fla
3. t against your skin as high under the pectoral incorrect readings Check your surroundings and move muscles as is comfortable away from the source of interference if possible Wash your elastic chest belt with mild soap and NOTE Two indoor rowers with heart rate hardware water if you have not been doing so regularly must be at least four feet 1 22 meters apart to avoid itemelemecs Make sure your receiver is within the proper range to receive transmission 1 meter 3 feet from your chest If further troubleshooting assistance is belt needed call Concept2 at 1 800 245 5676 Installing the Polar Heart Rate Interface on a Model E Indoor Rower Page 2
Download Pdf Manuals
Related Search