InSTEP EZ Strider Double EZ275 Jogger Stroller - C:\Documents and Settings\Iris\My Documents\InStep_EZ_Single_Double_manual
Contents
1. insteP Keep this manual for future reference If you sell this stroller or give it away make sure you give this manual to the new owner Ask them to read instructions completely Z Strider STROLLER Operating Instructions for Single and Double models Important Read and follow these Safety Rules and Assembly Instructions before operating stroller If you have any questions concerning the safe use of this product contact INSTEP LLC at 1 800 242 6110 M F 8 00 a m 5 00 p m CST or visit our web site at www instep net or E mail us at info instep net before using Safety Rules A PPE SSE EE PPS WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING WARNING Failure to follow these warnings and assembly instructions could result in serious injury or death Immediately discard any plastic wrapping Never allow children to fold assemble or disassemble the stroller Maximum weight capacity for the Single stroller is 50 lbs or 22 7 kg Double 85 Ibs or 38 6 kg Never place child in stroller on their back with their head forward and feet rearward Avoid serious injury from falling or sliding out Always use seat belt Never leave child unattended Never use this stroller with roller skates or in line skates Never allow stroller to be used as a toy or allow children to giv2. is down on the ground and the front fork is up Attach the front wheel by loosening the exterior lock nut on each side of the front wheel far enough to allow the axle and tab washer to slide into the front fork The tab washer s tab should be inserted into the small hole on the outside of the front fork Figure C Center the wheel between the front fork Tighten the nuts with an adjustable wrench IMPORTANT The alignment of the front wheel determines if the stroller will roll straight or pull to the right or left during use In the event you notice the stroller pulling to one direction loosen front axle nuts point the front wheel in the opposite direction the stroller is pulling ensure the tab washers are seated in the holes and tighten the nuts If you need help making this adjustment please call our Customer Service department for assistance A WARNING The interior jam nuts are factory installed and do not need adjustment Step 4 Front Fender Assembly Insert the 8 11 2 screws into the holes located on the front support between the front forks Align the 2 holes on the bottom side of the fender with the screws and tighten with a Phillips screwdriver Note The Double EZStrider has 4 screws Figure D Step 5 Canopy Positioning The canopy has adjustable positions Pull the canopy down to the desired position Step 6 To Attach Wrist Strap Place strap on top of handle bar The wrist strap has different sized l
3. at the tab washers are inserted in the holes of the front fork Point the front wheel forward or in the opposite direction the stroller is pulling then tighten the nuts with an adjustable wrench NOTE Sometimes it is a very slight adjustment to eliminate the pulling and this step may need to be repeated To clean seat and canopy If light cleaning is required use a soft cloth with warm water and mild soap then air dry Do not put into washing machine Do not put in dryer DO NOT BLEACH To clean frame Wipe using a soft cloth with warm water and mild soap Air dry DO NOT USE polish or abrasives A WARNING If you have any questions concerning the safe use of this product please contact INSTEP LLC before using 1 800 242 6110 InSTEP InSTEP LLC 2425 Enterprise Drive Suite 900 Mendota Heights MN 55120
4. ave any questions concerning the safe use of this product Please contact us 1 800 242 6110 press 1 for customer service and then 2 to speak to a representative or E mail us at info instep net or visit our web site at www instep net EZStrider Assembly Instructions Parts List Description Qty Description Qty Frame Assembly w seat Rear Wheel Assembly w nuts 2 canopy basket and wrist strap 1 Front Fender 1 Front Wheel Assembly w nuts 8 1 Phillips head screws 2 Double and tab washers 1 has 4 Tools Required Phillips screw driver Adjustable wrench Stroller Assembly Instructions Step 1 Unfold Stroller Grasp handle with one hand and pull up on the front axle mount with your other hand Lock both plastic latches onto the lower frame Figures A1 and A2 A2 Latches Latches Seat Back Rest i i l s a l eee q i i 2 a a d gt DNA oe B H z f E d r j 9 j iy Front gt Fork Handle Step 2 Rear Wheel Assembly Remove the rear wheel lock nut from the rear wheel axle Mount rear wheel to the rear wheel bracket by inserting the axle through the hole in the bracket Attach the lock nut and tighten completely using an adjustable wrench Repeat for other side Figure B WARNING The interior jam nuts are factory installed and do not need adjustment Step 3 Front Wheel Assembly Turn stroller upright onto its rear wheels then tip stroller back so the handlebar
5. e rides to others Never use stroller if it becomes damaged Always be aware of traffic around you when walking or jogging Always engage brakes when you stop or when you let go of handle Always use an approved bicycle helmet on child Always use wrist strap Accessories or parcels placed in or on the stroller may cause it to become unstable Maximum weight for objects in back pouch is 2 2 lbs or 1 kg Double 2 2 Ibs or 1 kg in each back pouch Excessive weight may cause a hazardous unstable condition Child may slip into leg openings and strangle Never use in a reclined carriage position unless T shield and shoulder strap placement has been readjusted to the seat s new position IMPORTANT Tires are shipped deflated DO NOT OVERINFLATE Please inflate slowly with short bursts to 20 25 PSI maximum 25 PSI will provide a comfortable ride for your child We appreciate your purchase of one of our many fine products We are sure that you will be satisfied with your selection We regret that although great care and effort have been taken occasionally problems may occur PLEASE DO NOT RETURN PRODUCT TO THE STORE To ensure prompt and correct handling of problems or to answer questions please contact us at either our Toll Free Customer Service Number or E mail us at our number listed below Service will be quicker if you have your model number found on the product and box along with this instruction sheet ready when calling If you h
6. epeat on other side To release brake lift levers using your toe until cogs disengage Figure G Proper use of seat belts amp shoulder straps A WARNING Avoid Serious Injury Always use seat belts 1 Place child in seat Make sure T shield Is between the child s legs 2 When child is seated place shoulder straps over the child s shoulders 3 Slide waist straps through lower loops of shoul Lder straps bring lap belt ends together and clip into place around child s waist Adjust waist and shoulder straps for snug fit Figure H To recline seat To fully recline unhook buckle on back of the seat Figure I To place seat in upright position push seat forward and reconnect buckle located on back of seat To adjust the recline position adjust the slide on the strap A WARNING Child may slip into leg openings and strangle Never use in a reclined carriage posi tion unless T shield and shoulder strap have been readjusted to the new seat position Brakes Shoulder Straps nee oR Shoulder Stra _ Adjustment Slides WE T Shield Buckle Adjustment Care and Maintenance Check fasteners After one hour of use check all fasteners to make sure they are secure Adjust if necessary Periodically check the stroller to ensure that it is in good operating condition To adjust the stroller from pulling to the left or right not rolling straight Loosen the front axle nuts and check to see th
7. oops The large loop will go on your wrist the small loop will be on handlebar Slide end with large loop through the small loop then grasp the end with the large loop and pull strap to tighten on handlebar Locknut Tab Washer Adjustment Hole for Tab Washer Double has 4 Holes Screws A WARNING Whenever child is in stroller always use the wrist strap Before you remove the wrist strap from your wrist make sure you first engage the rear brakes Congratulations assembly is now complete Use Instructions Pull Seat Forward To close fold stroller When Folding A WARNING Always remove child from stroller before folding Pull the seat seats forward locate the plastic latches on the side of the stroller frame Using one hand on each lever pull the levers from the lower bar The stroller will automatically begin to fold the front wheel will fold under frame and the handle will fold backwards Figure E NOTE The stroller will be easier to fold if the seats are not in the recline position If the seats are in the recline position please pull forward on Both Sides To open stroller Grasp handle with one hand and pull up on the front axle mount with your other hand Lock both plastic latches onto the lower frame Figure F Single EZ Strider Double EZ Strider To engage rear brakes Step lightly on the levers next to the rear wheels until the cogs of the brakes engage the cogs of the wheel R
Download Pdf Manuals
Related Search