Oreck BB1005 Vacuum Cleaner User Manual
Contents
1. OREGK XL AMAZING User s GUIDE COMPACT CANISTER VACUUMS BB1005 IMPORTANT SAVE THIS BOOKLET Includes e Safety Warnings Parts List Operating Instructions e Maintenance Warranty e Trouble Diagnosis e Accessories List OD AY BEFORE OPERATING CLEANER READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULLY Table of Contents Safeguards Important Electrical Information Important Safety Instructions page Warranty Parts List Accessories page Assembly Polarized Plug Notice To Operate Maintenance 4 Maintenance 8 Customer Service Troubleshooting Guide page 5 Safeguards WARNING Unplug cord from electrical outlet before servicing IMPORTANT Make sure filter bag is in place Do not operate cleaner without filter bag Damage to motor may occur Be sure bag gasket is in place If the white bag gasket is damaged or lost replace at once For best results change disposable filter bag regularly even if it is not completely full An extremely dirty bag or a bag close to full will affect the suction of the cleaner and can create excessive motor heat that could damage the motor A good practice is to change filter bag every 30 days even if it is not full Do not pick up moist material or liquids Clean your v2. This limited warranty does not cover the replacement of expendable or consumable parts such as belts brushes bulbs disposable bags and other parts subject to normal wear unless they are defective in material or workmanship This limited warranty does not apply to any part subjected to accident abuse commercial use alteration misuse damage caused by act of God the use of voltages other than indicated on the serial number displayed on this product or service of this product by other than Oreck or a participating Factory Authorized Service Center Oreck does not authorize any person or representative to assume or grant any other warranty obligation with the sale of this product Oreck s limited warranty is valid only if you retain proof of purchase from Oreck or an Oreck Authorized Retail Dealer for this product If you purchase this product from any other source your purchase is AS IS which means Oreck grants you no warranty and that you not Oreck assume the entire risk of the quality and performance of this product including the entire cost of any necessary servicing or repairs of any defects This warranty in addition to your statutory and other legal rights Reconditioned units carry a 6 month warranty from date of purchase Parts List 4D Qo Qm OT ID Adjustable shoulder strap Long extendable flexible hose Crevice tool Upholstery tool Horsehair bare floor and wall tool Horsehair
3. fig 19 Insert Fresh Air Scent Cartridge on tab located in center of the filter cover fig 20 Place the HEPA Filter in the filter cover fig 18 Replace the HEPA Filter assembly on the canister by placing the bottom lip of the cover in the inside slot of the canister and closing the cover until the top latch is locked NOTE It is recommended to replace the scent cartridge when the inner filter bag is replaced Replace the HEPA filter every 6 months Replace more often if vacuum is used to pick up fine particles or in extremely dirty areas Maintenance and Customer Service Your ORECK COMPACT CANISTER VACUUM a product of precise engineering The motor bearings are permanently lubricated and should not be oiled If you require additional information or have problems with your ORECK appliance you may call ORECK customer service or write to Telephone 0845 603 0153 Oreck UK P O Box 107 Exeter EX2 8ZQ Attention Oreck Customer Service Please specify the model number serial code number which can be found on the data plate on the bottom of the vacuum Save your sales or purchase slip Should your ORECK appliance require warranty service in the U S A present this slip to the Authorized Service Center as your proof of purchase date or in Canada call customer service Troubleshooting Guide PROBLEM PossiBLE SOURCE AREAS TO CHECK Cleaner Will 1 Not plugged in 1 Be sure cleaner is Not Run p
4. Attach Shoulder Strap fig 4 Clamp one end of shoulder strap in front slot located at front of handle fig 5 Clamp opposite end of shoulder strap in slot at back of handle fig 6 Adjust length by pulling strap through clip IMPORTANT Before using shoulder strap pull both ends to be sure it is secure To Operate Plug cord into electrical outlet Power Switch fig 7 Push power switch to ON position Hose and Tool Installation fig 8 The flexible hose uses a Shurlock locking system that prevents hose removal unless intended To install hose align J slot in hose coupling with tab inside the suction port Insert hose into suction port Twist collar clockwise to lock hose coupling in port Twist counterclockwise and pull to remove hose fig 9 The adjustable extension wand and cleaning tools supplied with your Oreck XL Compact Canister Vacuum lock together with friction Twist and push to be sure they lock tightly when installing Twist and pull to remove fig 10 When installing tools directly to blower or suction port without using hose tool adapter tube must be used Adjustable Extension Wand fig 11 To adjust extension wand press release button and pull inner tube to desired length Tube will lock when button is released To shorten length press release button and push inner tube For Easy Cord Storage fig 12 Wrap cord around the cord wrap and cord dump located on bottom of the canister T
5. dusting brush Adjustable extension wand On board tool caddy Paper filter bags Tool adapter tube for fitting tools directly to vacuum when not using hose HEPA filter not shown Scent cartridge not shown Accessories Sold Separately Replacement Hypo Allergenic Filter Bags 12 pk with 1 Micro Filter Replacement Micro Filter Replacement HEPA Filter Part No PKBB12DW Part No 72005 01 Part No HF1000 Replacement White Bag Gasket Wheel Kit Vinyl Tool Rack Part No 72017 02 Part No 09 73069 01 Part No CADDYBB Fresh Air Scent Cartridges Notes of Vanilla 8pk Spring Mullberries 8pk Blooming Jasmine 8pk Part No FA1PK Part No FA2PK Part No FA3PK To order new parts or accessories call 0845 603 0153 Assembly IMPORTANT DO NOT REMOVE the dirt retaining flap attached on the back of the front plate must be left in place for the unit to operate properly and to ensure cleaning effectiveness Attach Caddy and Insert Tools fig 1 Locate caddy clip slots at top rear corners of canister handle Place appliance on firm non slip surface or hold in your lap Grasp handle firmly Place one of caddy clip tabs inside slot on one side of handle and stretch the other tab around handle until the opposite tab inserts in slot fig 2 Insert crevice tool brush and fabric tool into caddy in spaces provided fig Caddy will lift up 90 to allow access to the HEPA filter cover
6. If fine materials such as soot cement plaster dust copy machine powder etc are picked up the bag surface may seal and cause the motor to shut off to avoid over heating If this happens turn the switch off then turn off the wall socket and or unplug the cleaner Replace filter bag Check and clear any clogs in hose or accessories After approximately 30 min the motor will have cooled and the cleaner will be ready to use Note The cleaner must remain unplugged for 30 minutes for motor to cool and system to reset IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance basic precautions should always be followed including the following READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire electric shock or injury Do leave appliance unattended when plugged in Unplug from outlet when not in use and before servicing Do not use outdoors or on wet surfaces Do not allow to be used as a toy Close attention is necessary when used by or near children Use only as described in this manual Do not use with damaged cord or plug If appliance is not working as it should has been dropped damaged left outdoors or dropped into water return it to a service center or call customer service at 0845 603 0153 Do not pull or carry by cord use cord as a handle close door on cord or pull cord around sharp edges or corners Do not run appliance over
7. acuum cleaner with a damp not wet cloth in the disposable bag cavity and the outside of canister unit IMPORTANT DO NOT REMOVE the dirt retaining flap attached on the back of the front plate It must be left in place for the unit to operate properly and to ensure cleaning effectiveness Important Electrical Information The wires in the main lead are coloured in accordance with the following code Blue Neutral Brown Live If the colours of the wires in the main lead of this appliance do not correspond with the coloured markings identifying the terminals in your plug proceed as follows The wire which is coloured blue must be connected to the terminal marked with the letter N or coloured black The wire coloured brown must be connected to the terminal marked with the letter L or coloured red Do not make any connection to the terminal marked E or or coloured green and yellow This appliance is double insulated and no earth connection is necessary If you remove the plug from power supply cord dispose of it A shock hazard could result if incorrect plug inserted into 13 AMP socket outlet When changing fuse use 5 AMP or same size replacement fuse Never use the plug without the fuse cover fitted in place N The fuse carrier is red and hinged to the plug Do not use the plug if it is different If necessary you may contact customer service for replacement fuse covers MOTOR PROTECTION SYSTEM
8. cord Keep cord away from heated surfaces Do not unplug by pulling on cord To unplug grasp the plug not the cord Do not handle plug or appliance with wet hands Do not put any object into openings Do not use with any opening blocked keep free of dust lint hair and anything else that may reduce air flow Keep hair loose clothing fingers and all parts of body away from openings and moving parts Do not use to pick up anything that is burning or smoking Such as cigarettes matches or hot ashes Do not use without filter bag assembly in place Turn off all controls before unplugging Use extra care when cleaning on stairs Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present SAVE THESE INSTRUCTIONS Household Use Only Warranty ORECK MANUFACTURING COMPANY Oreck Manufacturing Company 21180 Johnson Road Long Beach MS USA 39560 gives you the following limited warranty for this product only if it was originally purchased for residential use not resale from Oreck or an Oreck Authorized Retail Dealer Oreck will repair or replace free of charge to the original purchaser any part that is found to be defective in material or workmanship within three 3 years of the date of purchase ten 10 years on housing This limited warranty applies to normal domestic use Any commercial use of this product will void this limited warranty
9. o release cord twist the cord dump Blower Port fig 13 Remove HEPA Filter cover and filter at back of machine Firmly insert flexible hose into blower port Maintenance WARNING Unplug cord from electrical outlet before servicing Changing the Filter Bag fig 14 Use only genuine ORECK XL filter bags Stand unit on its back Twist knob counterclockwise to release and lift out front plate fig 15 Remove used bag and insert fresh bag The cardboard rim fits smoothly into the recessed top Align tabs on front plate with slots in housing and replace the front plate Close unit by turning knob clockwise fig 16 IMPORTANT The white bag gasket glued in the housing must be in place or unit will not operate properly Replace if needed NOTE The disposable inner filter bag must be replaced once a month even if it is not full Change it more often if it is used in extremely dirty areas Increase the cleaning power of your vacuum by changing the bag often Replacing the Micro Filter Remove filter bag by following the Changing the Filter Bag instructions fig 17 Remove old micro filter from bottom inside unit Replace with new filter NOTE A replacement filter is supplied in each package of 12 ORECK XL filter bags or you may order filters separately Using a HEPA Filter and Scent Cartridge fig 18 Remove HEPA Filter cover at back of machine by pressing down in top slot and folding back the cover Lift cover to remove
10. roperly firmly plugged into wall outlet 2 No electricity in 2 Check electrical wall outlet source fuse or circuit breaker 3 Motor protector 3 See Motor tripped Protection System page 2 4 Needs service 4 Take to service center or call for nearest service center Vacuum Will 1 Filter bag is full 1 Replace filter bag Not Pick Up See Changing Or Has Low the Filter Bag Suction 2 Hose wand tool page 4 is clogged 2 Remove 3 Air leak due to obstructions missing or 3 Replace gasket damaged gasket See page 4 Tools Wands 1 Proper friction fit Will Not Stay not being 1 Push and turn Together obtained ALL OTHER SERVICING SHOULD BE DONE BY AN ORECK AUTHORIZED SERVICE CENTER CALL CUSTOMER SERVICE HOT LINE 0845 603 0153 Whenever calling please be sure to have your model and serial number from data plate STRONG ENOUGH TO PICK UP A 16 LB BOWLING BALL 73063 01 REV 06 05 ECN R 8022 2005 Oreck Holdings LLC All rights reserved All word marks logos product configurations and registered trademarks are owned and used under the authority of Oreck Holdings LLC
Download Pdf Manuals
Related Search