Mobi Technologies 70060 Stereo Receiver User Manual
Contents
1. Model 70060 NuUBi MobiCamex Wireless Audio Video Monitoring System USER S MANUAL TABLE OF CONTENTS INTRODUCTION PACKAGE CONTENT MONITOR FEATURES 8 COMPONENTS CAMERA FEATURES amp COMPONENTS SAFETY TIPS INSTALLATION 8 SET UP CAMERA OPERATION 8 INSTALLATION POWER ON OFF CHANNEL SELECTION VOICE ACTIVATION VOX AUTOMATIC INFRARED NIGIT VISION MONITOR OPERATION amp INSTALLATION POWER ON OFF CHANNEL SELECTION AUTOMATIC CHANNEL SCAN BRIGHTNESS CONTROL AUDIO VIDEO OUTPUT LINK LCD ON OFF PROBLEMS 8 SOLUTIONS FCC REGULATION LIMITED WARRANTY AO O OO O U 0 N N 0 w N O O NOTES LIMITED WARRANTY Mobi Technologies Inc warrants this product to be free from defects in material and workmanship for a period of ninety 90 days from the date of purchase Should this product prove to be defective at any time during the warranty period Mobi Tech nologies Inc will at its option either replace or repair it without charge After the warranty period a service charge will be applied for replacement of parts or labor for repair To obtain warranty service please return the product to Mobi along with a dated sales receipt from the place of purchase Purchaser is responsible for shipping the product to Mobi Technologies Inc at the address indicated below and for all associated freight and insurance cost This warranty does not cover damage caused by accid2. check Led indicator Full Power Green Low Power Orange e The camera may not be transmitting power is not on or is in voice activ tion mode or AV mode e Wrong Channel Please note the monitor will return to Channel A automatically after power off e Check if the LCD on off switch is but turned to on e Low Power Check LED indicator Full Power Green Low Power Orange Camera has switched to Infrared Night Version mode e Check to see if the scanning feature is enabled e Check to see if Camera is in AV mode 11 CAMERA UNIT FEATURES amp COMPONENTS 15 Camera Lens 16 Channel Indicator LEDs 17 Channel Selection Switch 18 Voice Activation Action Selection Switch 19 Analog Audio Video Input Jack 20 Light Sensor for Automatic Night Vision 21 Power On Off Switch 22 Power On Off Indicator 23 DC Jack 24 Microphone 25 Child Safe Battery Door Screw 26 Battery Door SAFETY TIPS For proper setup and use please read all instructions Please keep this manual for future reference e This Product is not intended to be used as a medical monitor and its use should not replace adult supervision AN CAUTION This product cannot replace responsible adult supervision e Periodically examine this product for damage to the cord housing or other parts that may result in the risk of fire electric shock or injury Never use transmitter and receiver near water i e bathtub sin
3. e protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio commu nications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Operation with non approved equipment or unshielded cables is likely to result in interference to radio or TV reception The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user s authority to operate this equipment 12 PROBLEMS 8 SOLUTIONS Problem No reception No picture display can hear sound Only Black amp White picture displayed Units Continually Loses Signal Solution e Unit has not been switched on e AC DC adaptor has not been connected e Battery Levels
4. ent misuse abuse improper maintenance unauthorized modification or connection to an improper power supply A charge will be made for repair of such damage This warranty excludes all incidental or consequential damages and any liability other than what is stated above O 2009 Mobi Technolo gies Inc All Rights Reserved Mobi Technologies Inc 5913 Blackwelder St Culver City CA 90232 Toll Free Number 877 662 4462 www getmobi com Mobi and MobiCam are registered trademarks of Mobi Technologies Inc O 2009 Mobi Technologies Inc All Rights Reserved 13 INTRODUCTION Thank you for purchasing the MobiCam AV Wireless Audio Video Monitoring System The 900 MHz MobiCam AV incorporates the latest in advanced technology enabling you to transmit picture and sound wirelessly PACKAGE CONTENTS Please note the package should include the following a 1 x Camera Unit b 1 x Monitor Unit c 2 x AC DC adaptors 1 x Audio Video Cable Instruction Manual d e MONITOR UNIT FEATURES amp COMPONENTS 1 TFT LCD Display 2 Channel Indicator LEDs 3 Channel Selection Switch 4 Speaker 5 Automatic Channel Scan Indicator 6 Power On Off Indicator 7 Power On Off Switch 8 Volume Control 8 LCD On Off Switch 9 DC Jack 10 Belt Clip 11 Brightness Controls 12 Battery Door 13 Audio Video Output 14 Child Safe Battery Door Screw FCC REGULATION These limits are designed to provide reasonabl
5. k etc e The AC adaptor is not a toy AN WARNING To prevent strangulation with power cord never place transmitter within reach of child Always use transmitter and receiver where there is adequate ventilation To prevent overheating keep away from heat sources such as radiators heat registers stoves or other appliances that produce heat Audio Video Output Feature The A V feature of the MobiCam system allows you to link the Moni tor to a camcorder computer DVR or other video recording device so you can capture video and sound from the camera transmission The A V Output jack 13 is located at the left side of the monitor Simply connect the supplied AV Connector Cord to the jack 13 and connect the other end Three RCA Connectors to the Audio and Video input jacks of your VCR Camcorder or TV set LCD On Off This power saving feature is located on the side of the monitor 8 This feature enables the Monitor to use less power and remain operational as an audio only monitor The Monitor will resume working with a clear picture when the LCD is switched to on 10 MONITOR OPERTATION amp INSTALLATION Power ON OFF Use the volume and ON OFF switch on the side of the unit to turn on the unit 7 Channel Selection Press the Channel Selection Switch 3 on the Monitor to choose which channel you want the unit to transmit on The channel indicator LED 2 will illuminate which channel the Monitor i
6. power adaptors or batteries Using Batteries a Remove the battery door 12 26 at the bottom back of each unit by loosening the child safe screw 14 25 and sliding the cover downward to release b Both units use 1 5 volt AA size batteries Always use batteries of the same brand and age alkaline recommended Insert 4 AA batteries into the camera and 6 AA batteries into the monitor c Replace the covers by aligning the tabs with the tab holes and tightening the child safe screws CAUTION Remove batteries immediately once they run out of power and dispose of them properly Do not use batteries while using the AC adaptor for extended periods of time as this might cause battery leakage Using AC Adaptors a Insert the AC adaptor into the DC Jack 9 23 of either unit The AC adaptors are the same for both the Camera and Monitor b Plug the AC adaptor plug into a standard AC power outlet CAMERA OPERTATION amp INSTALLATION Power ON OFF Use the Power ON OFF sliding switch to turn ON OFF the unit 21 Channel Selection Press the Channel Selection Switch 17 on the Camera to choose which channel you want the unit to transmit on The channel indicator LED 16 will illuminate which channel the Camera is set to A or B Voice Activation To Activate Select the VOX setting on the Function Activation Switch 18 on the left side of the Camera unit When the sound level within the area surrounding the unit reaches a p
7. reset level the Camera will begin transmitting the image and sound to the Monitor NOTE The LCD on the Monitor unit will automatically switch to standby mode if no signal is received from the Camera To Deactivate Select the CAMERA setting on the Function Activa tion Switch of your camera Automatic Infra Red Night Vision The infra red night vision feature will switch on automatically during darkness or periods of very low levels of light and a black and white image will be displayed on the monitor Once the feature is activated objects must be within 6 ft 2 m of the camera to be seen on the monitor
8. s set to A or B NOTE If your picture continues to switch between channel A and B your Automatic Channel Scan is activated Press the Channel Selection Switch 3 on the monitor until the feature turns off Automatic Channel Scan Selecting this option allows the Monitor to scan between both channels automatically stopping at each for about 5 seconds This feature enables you to monitor two cameras at the same time Press the Channel Switching Button until the LED light 5 is turned on Brightness Control The brightness of the LCD can be adjusted by the 2 Brightness Control buttons on the side of the Monitor unit 11 Press the to increase and to decrease the brightness of the LCD Always remember that you are using public airways when using your monitor e Use only a dry cotton cloth to keep the Camera and Monitor units free of dust Do not use a dampened cloth water or liquid cleaner of any kind NNDANGER To prevent electric shock do not immerse in water wipe clean with damp cloth Always remove batteries from the Camera and Monitor and unplug the AC adaptors from wall outlets during long periods of non use e Replace only with the same or equivalent type Please dispose of old defective batteries in an environmentally friendly manner in accordance with the relevant legislation INSTALLATION amp SET UP Installing Batteries Your MobiCam AV can be powered by either using the supplied AC
Download Pdf Manuals
Related Search