Logitech 575HSD Speaker System User Manual
Contents
1. o 0 ZYVOX Base 5 HSD 00 Single Cabinet Surround Sound System OWwWNER S MANUAL Don t Worry This Is Going To Be Simple Great Sound Made Simple 59 Thomas Road Swampscott MA 01907 USA Telephone 866 367 9869 xaudio com info zvoxaudio com READ THIS FIRST Important Safety Instructions For ZVOX 575 HSD System WARNING TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE THIS APPLIANCE SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING WATER AND NO OBJECT FILLED WITH LIQUIDS SUCH AS VASES SHALL BE PLACED ON APPARATUS CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN This lightning flash with arrowhead Warning To reduce the risk of electrical The exclamation point within an symbol within an equilateral triangle is shock do not remove cover or back no equilateral triangle is intended to intended to alert the user to the presence serviceable parts inside Refer servicing alert the user to the presence of of uninsulated dangerous voltage within to qualified service personnel important operating and maintenance the product s enclosure that may be sufficient magnitude to constitute a risk of electrical shock to persons servicing instructions in the literature accompanying the appliance Important Safety Instructions Read these instructions Keep these instructions Heed all warnings Follow all instructions Do not use this apparatus near water Clean only with d2. When you turn on a new program the light will turn blue again and the program will play To defeat this automatic standby mode press the AUTO ON OFF button once the light will blink To restore the setting press the button again Using The Remote Control The ZVOX remote control has and buttons to control four ranges VOLUME PHASECUE SUBWOOFER TREBLE The blue light on the speaker will blink with each adjustment step up or down It will stop blinking when the maximum or minimum setting has been reached 1 VOLUME Adjust the ZVOX 575 HSD remote VOLUME buttons as desired When the MUTE button is pushed the speaker output is silenced and a blue light will blink until output is restored with another press of the MUTE button If your audio source is variable First set the volume on the TV or other audio source to about 3 4 of its full range Then adjust the ZVOX 575 HSD remote VOLUME buttons until the output is as loud as you require From this point forward use the TV remote to control the volume Use the ZVOX remote as required to adjust the other audio qualities PhaseCue Subwoofer and Treble 2 PHASECUE Adjust the level of virtual surround with these two buttons As you increase the PhaseCue level the apparent soundfield will expand well to the left and right of the ZVOX 575 HSD The effect is most obvious with DVD movies and live action TV programming News broadcasts talk shows and sitcoms do not
3. have much stereo content PhaseCue may have little or no effect on these programs NOTE IF YOU FIND THAT CROWD NOISE OR MOVIE SPECIAL EFFECTS ARE DROWNING OUT THE DIALOG TRY TURNING DOWN THE PHASECUE LEVEL THIS WILL RESTORE CLARITY TO DIALOG l AUTO JUTE POWER ON OFF QO SUBWOOFER OC TREBLE PHASECUE VOLUME i C2 ZYVOX www zvoxaudio com 3 SUBWOOFER Adjust the bass output of the ZVOX 575 HSD as desired The control has nine steps Most users will find a single setting that works for most audio programs If you use an external subwoofer leave this control in the mid point setting five steps up from minimum then adjust the external subwoofer to your preferred bass output 4 TREBLE Adjust as desired Nine adjustment steps are available and the difference between each step is small Most users will find a single setting that works for most audio programs Fine Tuning If you hear a consistent hiss or hum from the ZVOX 575 HSD it is likely you are using a variable audio signal output from your TV but ZVOX 575 HSD s volume is set too high Lower the setting on the ZVOX 575 HSD remote VOLUME by at least three steps or until the hiss is reduced then set it aside Use a higher volume setting on your TV remote from this point forward Please keep in mind that your ZVOX 575 HSD is a highly accurate audio system It may reveal noise distortion or other flaws inherent in
4. IR codes is Logitech Harmony The ZVOX 575 HSD will respond to the following preprogrammed audio remote codes listed in other universal remote controls candle 1004 hisense 1237 aiwa 1036 Not all universal remote controls contain these codes TV Audio Settings Turn off the TV s internal speakers Push the MENU button on the TV s remote control and navigate to the AUDIO setting options Choose INTERNAL SPEAKER OFF the wording may vary Analog audio option FIXED versus VARIABLE If you are using an analog signal connection there may be an AUDIO setting option to select AUDIO OUT as VARIABLE the wording may vary This is sometimes labeled AOV Variable audio output allows your TV s remote control to adjust the listening volume OUTPUT jack Use this jack to connect an external powered subwoofer if desired This jack supplies a full range monaural analog audio signal Set the subwoofer s crossover sometimes labeled Low Pass to 50 Hz or lower then adjust the subwoofer s output to blend well with the ZVOX 575 HSD Remote Control 1 Insert the AAA batteries inside the remote control 2 Turn on the ZVOX 575 HSD by pushing the power button on the remote control A blue LED light should come on 3 Auto ON OFF Function In normal operation the ZVOX 575 HSD enters standby mode 5 8 minutes after turning off the audio program The front panel light will turn from blue to green to indicate standby mode
5. some audio programs that were masked with smaller TV speakers The PhaseCue control adjusts the size of the perceived soundstage Feel free to adjust it for different kinds of programs In general movies and live action video programming benefit from a higher setting than music concert programming Remember there are nine discrete steps of PhaseCue effect 1 Year Limited Warranty To the original purchaser ZVOX Audio will warrant the ZVOX 575 HSD system to be free of defects in material and workmanship for a period of one 1 year from date of purchase With respect to defects ZVOX will at its option replace the product or repair the defect in the product with no charge to the original purchaser for parts or labor Customer is responsible for shipping charges where required This warranty does not extend to any defect malfunction or failure caused by misuses abuse accident faulty hookup defective associated equipment or use of the system with equipment for which it is not intended This warranty is only valid when the system is returned to the retailer that sold the ZVOX 575 HSD system to the original purchaser This is the sole and express warranty This warranty is in lieu of all other warranties expressed or implied of merchantability fitness for purpose or other wise In no event shall ZVOX Audio LLC be liable for incidental or consequential damages or have any liability with respect to defects other than the obligatio
6. 5 HSD Coaxial input Optical Digital Use an optical or TOSLINK connecting cable not supplied Connect one end to the optical digital output of your TV or other source Connect the other end to the ZVOX 575 HSD Optical input Analog Stereo Input 1 Plug the supplied analog connecting cable into the red and white jacks labeled Input 1 on the back of the ZVOX 575 HSD Use the red plug for the red jack right channel Use the other plug for the white jack left channel Plug the opposite ends of the cable into the Audio Out jacks of your TV or other audio source following the same color scheme Note connecting an analog stereo signal to the ZVOX 575 HSD may allow you to control the sound level produced with your TV remote A headphone output on a TV can also be used as a variable analog audio output if the sound level of the headphones is controlled by the TV s remote control A connecting cable matching the headphone output jack is necessary in this case Controlling The Audio Sound Level A standard digital audio signal Coaxial or Optical and a typical analog audio output are fixed level The level of the sound produced by the ZVOX 575 HSD should be adjusted using its supplied IR remote control Note A universal or programmable learning remote can be substituted to control the ZVOX 575 HSD and all of your TV and other connected devices One brand of universal remote controls containing the ZVOX audio
7. The MAINS plug or an appliance coupler is used as the disconnect device the disconnect device shall remain readily operable 18 CLASS II apparatus with double insulation and no protective earth provided Special Safety Warnings Regarding Placement of ZVOX 575 HSD and Other Equipment Stable Placement Do not place the ZVOX 575 HSD O on an unstable cart stand bracket or table The ZVOX 575 HSD may fall causing serious injury to a z child or adult and serious damage to the product E Do not use the ZVOX 575 HSD on any unstable surface Placement of a TV on the ZVOX 575 HSD Televisions weighing less than 140 pounds and with base dimensions of less than 34 in width and less than 15 in depth can be placed on top of the ZVOX 575 HSD BUT ONLY WHEN THE FOLLOWING SAFETY PRECAUTIONS ARE STRICTLY OBSERVED PLACING A TV ON TOP OF THE ZVOX 575 HSD WITHOUT FOLLOWING ALL THE PRECAUTIONS IS DANGEROUS AND SHOULD NOT BE DONE The television must weigh 140 pounds or less The base of the TV or the TV stand must be 34 wide or less The base of the TV or the TV stand must be 15 deep or less The TV MUST be anchored to the rear wall using anchor bolts and supporting cables supplied by the TV manufacturer following the installation guidelines provided by the TV manufacturer Be sure to take measures to prevent the ZVOX 575 HSD from becoming uneven or unstable Install the ZVOX 575 HSD ona solid and flat surface Installation and Operat
8. ing Instructions ZVOX 575 HSD Single Cabinet Surround Sound System Contents ZVOX Audio ZVOX 575 HSD cabinet AC power cord Remote Control and Battery Analog Audio Connecting Cable left and right RCA type plugs on each end Placement Place the ZVOX 575 HSD cabinet on a sturdy surface The ZVOX 575 HSD grille should face the listening area Power Connection 1 Connect the AC power cord to the 120V 60Hz Power Connector on the back of the ZVOX 575 HSD cabinet WARNING DON T PLUG AC CORD INTO OUTLET BEFORE IT IS CONNECTED TO THE POWER CONNECTOR ON THE REAR OF THE UNIT 2 After you have confirmed the AC power cord is properly connected to ZVOX 575 HSD connect the AC power cord plug into a convenient AC receptacle 3 After you have made the necessary audio signal connections see below set the POWER switch on the back of the ZVOX 575 HSD to ON ZVOX 120V 60Hz T1 25AL 250V Rear AC panel of ZVOX 575 HSD Audio Signal Connection There are three ways to connect an audio signal to the ZVOX 575 HSD o 1 Digital Coaxial labeled Coaxial Input 1 Output Oe Rear input panel of ZVOX 575 HSD Digital Optical labeled Optical 3 Analog Stereo labeled Input 1 Coaxial Digital Use a coaxial digital connecting cable not supplied Connect one end to the coaxial digital output of your TV or other source Connect the other end to the ZVOX 57
9. ns set forth as stated Except as provided herein ZVOX Audio LLC shall have no liability or responsibility to the purchaser or any other person or entity with respect to any liability loss or damage caused directly or indirectly by use of the product including but not limited to any incidental or consequential damages To ensure warranty coverage it is incumbent upon the original purchaser of the ZVOX 575 HSD system to inform the retailer of the defect within the warranty period The only acceptable method of establishing warranty status is a copy of the original proof of purchase indicating customer s name and purchase date Great Sound Made Simple Questions E mail us at info zvoxaudio com ZVOX is a registered trademark of ZVOX Audio LLC and Phasecue and Z Base are trademarks of ZVOX Audio LLC RadioShack is a registered trademark of RadioShack Corporation
10. ry cloth S OOS OT Be NE Do not block any ventilation openings Install in accordance with the manufacturer s instructions 8 Do not install near any heat sources such as radiators heat registers stoves or other apparatus including amplifiers that produce heat 9 Do not defeat the safety purpose of the polarized or grounding type plug A polarized plug has two blades with one wider than the other A grounding type plug has two blades and a third grounding prong The wide blade or the third prong are provided for your safety If the provided plug does not fit into your outlet consult an electrician for replacement of the obsolete outlet 10 Protect the power cord from being walked on or pinched particularly at plugs convenience receptacles and the point where they exit from the apparatus 11 Only use attachments accessories specified by the manufacturer specified by the manufacturer or sold with the apparatus When a cart is used use caution when moving the cart apparatus combination to avoid injury from tip over 12 Use only with the cart stand tripod bracket or table 13 Unplug this apparatus during lightning storms or when unused for long periods of time 14 15 16 IZ Refer all servicing to qualified service personnel Servicing is required when the apparatus has been damaged in any way such as power supply cord or plug is damaged liquid has been spilled or objects have fallen into
11. the apparatus the apparatus has been exposed to rain or moisture does not operate normally or has been dropped Grounding or Polarization This product may be equipped with a polarized alternating current line plug a plug having one blade wider than the other This plug will fit into the power outlet only one way This is a safety feature If you are unable to insert the plug fully into the outlet try reversing the plug If the plug should still fail to fit contact your electrician to replace your obsolete outlet Do not defeat the safety purpose of the polarized plug Alternate Warnings This product is equipped with a three wire grounding type plug a plug having a third grounding pin This plug will only fit into a grounding type power outlet This is a safety feature If you are unable to insert the plug into the outlet contact your electrician to replace your obsolete outlet Do not defeat the safety purpose of the grounding type plug Ventilation Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating and these openings must not be blocked or covered The openings should never be blocked by placing the product on a bed sofa rug or other similar surface This product should not be placed in a built in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer s instructions have been adhered to
Download Pdf Manuals
Related Search