LG Electronics 3377LLHH4400 Flat Panel Television User Manual
Contents
1. Owner s Guide Holmes Remote Control Stand Fan HASF2018RC HASF2120RC PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances basic safety precautions should always be followed to reduce the risk of fire elec tric shock and injury to persons including the following 1 Read all instructions before using the appliance 2 To avoid fire or shock hazard plug the appliance directly into a 120 V AC electrical outlet 3 Keep the cord out of heavy traffic areas DO NOT let the cord hang over the edge of a table or counter To avoid fire hazard NEVER put the cord under rugs near heat registers radiator stoves or heaters 4 To protect against electrical hazards DO NOT immerse in water or other liquids Do not use near water 5 Close supervision is necessary when any appliance is used by or near children or by disabled people 6 Always unplug the fan before moving it putting on or taking off parts cleaning or whenever the fan is not in use Be sure to pull by the plug and not the cord 7 Avoid contact with moving parts DO NOT operate without fan grills properly in place 8 DO NOT operate any appliance with a damaged cord or plug if motor fan fails to rotate after the appliance malfunctions or if it has been dropped or damaged in any manner Return appliance to manufacturer for examination electrical or mechanical adjustment or repair 9 DO NOT operate2. K N 2S os O HERS base Py J 7 ES by turning counter i NUNS XE Clockwise I i STEP 2 Take the l i xtension A LOGO PLATE SNAP ON K MOTOR HOUSING extension pole with poe B FRONT GRILL L TUT JOINT the solid end down C BLADE CAP M FAN POST SCREW and insert it into the 1 D FAN BLADE N REMOTE CONTROL HOUSING base The hollow end a ae oe thepoenitthe Le B Dea ai ee screw hole will be G GRILL SCREW H REAR GRILL MOTOR SHAFT J GRILL MOUNT R FOOT EXTENSIONS 4 ASSEMBLY INSTRUCTIONS Base Assembly facing up STEP 3 Replace the base collar over the extension pole slide it down the pole and secure it to the base by turning clockwise You will need the base and four extension legs Fan Head Assembly Push in the small tab on each extension and snap into base You are now ready to assemble the fan head See Figure 1 Step 1 Position the rear grill over the motor shaft making certain the 2 notches at the top and bottom of the rear grill fit over the 2 prongs on the motor housing Please make sure the rear grill fits securely against the motor housing Figure 2 Step 2 Secure the rear grill in its place using the rear grill mounting nut Turn this nut clockwise and tighten firmly Step 3 Slide the fan blade with the hollowed interior of the blade facing towards the rear grill firmly onto the motor shaft Make sure the shaft protrudes from the front of the b
3. al or workmanship provided the store has in stock replacement 2 Within the first 3 years from date of purchase subject to the conditions in paragraph H Holmes will repair or replace the product if it is defective in material or ee providing it is returned to Holmes freight prepaid with PROOF OF PURCHASE date together with 7 50 for handling and return packing ship ping charges G If you have any problem with this product please write our Consumer Service Department H eel Return INSTRUCTIONS Your warranty depends on your following these instructions if you are returning the unit more than 30 days after the date of purchase 1 Carefully pack the item in its original carton or other suitable box to avoid damage in shipping 2 Before packing your unit for return be sure to enclose a your name full address with zip code and telephone number b a dated sales receipt or PROOF OF PURCHASE c your 7 50 check for return packaging and d The model number of the unit and the problem you are having Enclose in an envelope and tape directly to the unit before the box is sealed 3 Holmes recommends you insure the package as damage in shipment is not covered by your warranty 4 All shipping charges must be prepaid by you as noted in paragraph F 5 Mark the outside of your package HOLMES THE HOLMES GROUP INC CONSUMER RETURNS 32 B SPUR DRIVE EL PASO TX 79906 SHIPPING AND HANDLING CHARGES 7 50 This warranty gives y
4. en the front grill Fan Head Base and Pole Cleaning Using a soft moist cloth with or without a mild soap solution carefully clean the fan base pole and head Please use caution around the motor housing area Do not allow the motor or other electrical components to be exposed to water FAN STORAGE Your fan can be stored in the off season either partially disassembled or assembled It is important to keep it in a safe dry location f stored disassembled we recommend using the Original or appropriately sized box f stored assembled or partially assembled remember to protect the fan head from dust SERVICE INSTRUCTIONS 1 Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit Doing so will void the warranty 2 If you have any questions regarding this unit s operation or believe any repair is necessary please write to our consumer service department 3 If you need to exchange the unit please return it in its original carton with a sales receipt to the store where you purchased it If you are returning the unit more than 30 days after the date of purchase please see the enclosed warranty 4 If you have any other questions or comments please write The Holmes Group Inc CONSUMER SERVICE DEPARTMENT P O Box 769 Milford MA 01757 0769 or visit our website at www holmesproducts com For your own records staple or attach your sales receipt to this manual Also please ta
5. in the presence of explosive and or flammable fumes THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC Alternating Current PLUG a plug having one blade wider than the other This plug will fit into the power outlet only one way If the pug does not fit fully into the outlet reverse the plug If it still does not fit contact qualified personnel to install the proper outlet DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG IN ANY WAY R 10 Use appliance only for intended household use as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons The use of attachments not recommended or sold by The Holmes Group may cause hazards 11 DO NOT use outdoors 12 Always use on a dry level surface 13 Keep unit away from heated surfaces and open flames 14 WARNING To reduce the risk of fire or electric shock DO NOT use this fan with any solid state speed control device 15 DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit Doing so will void your warranty The inside of the unit contains no user serviceable parts All servicing should be performed by qualified personnel only PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS Figure po shown Pole Assembly D H a e i BX STEP 1 Remove the RRES T A VA les base collar from the A i NA Ze CTS FERS
6. ke a moment to write the store name location and date purchase below STORE NAME LOCATION DATE PURCHASED STAPLE RECEIPT HERE THREE 3 YEAR LIMITED WARRANTY SAVE THIS WARRANTY INFORMATION A The quality controls used in the manufacture of this Holmes product are to ensure your satisfaction B This Warranty applies only to the original purchaser of this produc C This Warranty applies ONLY to repair or replacement of any supplied or manufactured parts of this product that upon inspection by Holmes authorized personnel proves to have failed in normal use due to defects in material or workmanship Holmes will determine whether to repair or replace the unit This Warranty does not apply to installation expenses D Operating this unit under conditions other than those recommended or at voltages other than the voltage indicated on the unit or attempting to service or modify the unit will render this WARRANTY VOID E Unless otherwise proscribed by law Holmes shall not be liable for any personal injury property or any incidental or consequential damages of any kind including water damage resulting from malfunctions defects misuse improper installation or alteration of this product F All parts of this Holmes product are guaranteed for a period of 3 years as follows 1 Within the first 30 days from date of purchase the store from which you purchased your Holmes product should replace this product if it is defective in materi
7. lade Step 4 Secure fan blade onto the motor shaft by turning the blade cap in a counter clockwise direction until it is firmly in place Step 5 Prepare the front grill by simply snapping the circular front grill logo plate in place Step 6 Center the front grill by aligning the Holmes logo so it is horizontal and parallel to the floor Then secure the front and rear grills completely together by snapping into place Lastly tighten the grill screw at the bottom of the rear grill Remote Control Handheld Unit leah Your remote control requires 2 AAA f oh batteries for operation To install the _ F batteries simply depress the back of the A remote with your thumb on the spot marked OPEN Insert batteries according to the dia gram shown inside Replace cover Do not mix old and new batteries Do not mix alkaline standard carbon zine or rechargeable nickel cadmium batteries Figure 4 Final Assembly First place fan head assembly onto the extension pole lining up the fan post screw with the hole in the extension pole Then simply insert the fan post screw into the hole and tighten until a secure fit is obtained Lastly insert the tilt adjustment knob into the neck joint and tighten Figure5 in place Fan Post Screw Screw Hole NOTE If your fan does not have a screw hole in the extension pole Extension Pole but instead has an indentation around the top of the pole please do the fo
8. llowing Step 1 First place the fan head assembly onto the extension pole and tighten the fan post screw until a secure fit is obtained Step 2 Insert the tilt adjustment knob into the neck joint and tighten in place OPERATING INSTRUCTIONS STEP 1 Set fan on a dry level surface STEP 2 Plug cord into any standard 120V AC outlet STEP 3 The speed is adjustable by pushing either the On Spd button on the remote control or the On Speed button on the touch key pad Push this button first for LOW again for MEDIUM and a third time for HIGH Push a fourth time to repeat the sequence To turn the fan OFF push the OFF button on the remote control or on the touch key pad STEP 4 To oscillate the fan head push the button marked OSC on the remote or OSCILLATION on the touch key pad Push a second time to stop OSCILLA TION STEP5 For a natural breeze movement push the button marked Mode or Mode on the touch key pad This will vary the fan speeds faster and slower By pressing the Mode button a second time or the SLEEP button on the touch key pad you activate the SLEEP setting This function slows the fan speed down and when used in conjunction with the timer settings will ultimately turn the fan off NOTE Both the BREEZE and SLEEP functions can be used with or without OSCILLATION and start off of any initial fan speed STEP 6 This fan is equipped with a 4 setting stop timer 8 hrs 4 hrs 2 hrs and 1 hr To ac
9. ou specific legal rights and you may have other rights which vary from state to state The provisions of this warranty are in addition to and not a modification of or subtraction from the statutory warranties and other rights and remedies contained in any applicable legislation To the extent that any provision of this warranty is inconsistent with any applicable law such provision shall be deemed voided or amended as necessary to comply with such law HMAN083 01 US 0M1 HASF2018RC 2120RC01UM1 Printed in China
10. tivate the timer push the Timer button on the remote con trol or the Timer button on the touch key pad One push will set the 1 hr the next push sets the 2 hr the third push activates the 4 hr and the fourth push sets the 8 hr Push again to begin repeating this sequence NOTE The timer can be used in conjunction with several other functions For example SLEEP 4HR TIMER causes the fan to gradually slow down over 4 hours and eventually turn off ADJUSTMENT INSTRUCTIONS Height Adjustment Follow these instructions to adjust the height of the fan Step 1 Turn the extension pole base collar see figure 3 and 5 counter clockwise to loosen pole Step 2 Adjust the pole to the desired height and firmly tighten collar in a clockwise direction CLEANING MAINTENANCE INSTRUCTIONS Follow these instructions to correctly and safely care for your Holmes stand fan Please remember Always unplug the fan before cleaning or disassembling Do not allow water to drip on or into the fan motor housing Be sure to use a soft cloth moistened with mild soap solution Do not use any of the following as a cleaner gasoline thinner or benzine Fan Blade Cleaning Instructions for fan head assembly see figure 1 STEP 1 To access the fan blade remove the front grill and blade cap STEP 2 Clean the fan blade front and rear grills with a soft moist cloth STEP 3 Replace blade tighten blade cap and securely fast
Download Pdf Manuals
Related Search