Kenwood ESP100 series Coffeemaker User Manual
Contents
1. 2 to produce steam to froth milk after having brewed coffee 1 Ensure that the pod filter holder with a pod holder is fitted to the coffee maker 2 Press the steam button and its light will flash see Fig D page ii When the steam indicator light glows continuously the unit is ready to produce steam see Fig E page ii 3 Place an empty jug under the steam hot water nozzle and move the function lever to the lower steam position to remove excess water from the system Return the function lever to the middle o position and discard the water 4 Part fill a jug with milk the milk may increase up to three times in volume so select a suitably sized jug Fresh cold semi skimmed milk gives the best results Position the jug under the steam hot water nozzle 6 Place the nozzle into the milk and move the function lever to the lower steam position The milk will begin to increase in volume and appear frothy To obtain a creamier froth rotate the jug with slow movements from the bottom upwards 7 Once the desired temperature and froth are obtained stop the steam by returning the lever back to the middle o position Never allow the milk to boil as this will spoil the flavour of the coffee 8 Pour the frothed milk into the cups containing the espresso coffee to make a cappuccino 9 Switch off the steam button in order to make further cups of coffee Note After having used the steam function The OK indicator light will2. ensure that they do not play with the appliance e Only use the appliance for its intended domestic use Kenwood will not accept any liability if the appliance is subject to improper use or failure to comply with these instructions before plugging in Make sure your electricity supply is the same as the one shown on the underside of the machine Important UK only The wires in the cord are coloured as follows Green and Yellow Earth Blue Neutral Brown Live e The appliance must be protected by a 13A approved BS1362 fuse e WARNING THIS APPLIANCE MUST BE EARTHED Note e For non rewireable plugs the fuse cover MUST be refitted when replacing the fuse If the fuse cover is lost then the plug must not be used until a replacement can be obtained The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer see Service e f a non rewireable plug is cut off it must be DESTROYED IMMEDIATELY An electric shock hazard may arise if an unwanted non rewireable plug is inadvertently inserted into a 13A socket outlet This machine complies with European Economic Community Directive 89 336 EEC key tank lid cup storage pod filter 8 supplied pod filter holder coffee outlet power on button indicator light OK indicator light steam button indicator light drip tray cover drip tray steam hot water nozzle function lever water tank B8O8O8 90988080
3. 9 important When selecting the power on and steam buttons always press them firmly before using for the first time 1 Wash the parts see cleaning 2 Flush the coffee maker through with cold fresh filtered water following steps to make coffee Make sure you fit the pod filter holder insert and one of the pod filters but do not use any coffee pods to make coffee 1 Lift the tank lid and then lift out the tank and fill with cold fresh filtered water ever fill above the MAX level marked Alternatively lift the lid and fill the tank whilst in position on the coffeemaker We recommend using filtered water from a Kenwood water filter as it produces better coffee and reduces limescale Never use fizzy water 2 Re fit the tank Make sure that it is correctly located and apply light pressure if necessary to ensure the valve at the bottom of the tank connects with the bottom of the machine 3 Note it is normal for water to remain in the compartment under the tank This can be dried using a sponge important Never operate the machine without water in the tank Top up as soon as the level gets low If the machine runs out of water during brewing the OK and steam indicator lights will flash alternately and the coffee maker will bleep Refill the tank and the flashing and bleeping will stop Make sure that the function lever is in the 0 position Plug the coffee maker into the power supply Press the power on butt
4. KENWOOD ESP100 series O sy before using your Kenwood appliance e Read these instructions carefully and retain for future reference e Remove all packaging and any labels safety Never attempt to remove the pod filter holder whilst coffee is brewing e Don t get burnt by o hot parts including the steam hot water nozzle pod filter holder and coffee outlet o steam or hot water coming out of the steam hot water nozzle or coffee outlet e Keep children away from the machine And never let the cord hang down where a child could grab it e Never use a damaged machine Get it checked or repaired see service e Never put the machine in water or let the cord or plug get wet you could get an electric shock e Unplug o before filling with water o before cleaning o after use Never leave the machine on unattended Don t let the cord touch hot parts Only use the pod filter and the pod filter holder supplied with this machine Never use ground coffee or teabags in the pod filter This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety e Children should be supervised to
5. ettings and cannot be adjusted Also the descaling mode will be lost Descale the machine Fit the filter into the filter holder The power OK and Steam indicator lights flash The temperature of the boiler is too high Switch off the machine for a period of time and re start it again If the problem persists return the appliance to a Kenwood authorised repairer e Kenwood Limited New Lane Havant Hampshire PO9 2NH UK www kenwoodworld com ere
6. flash quickly once per second for a short period to indicate the high temperature see Fig F page ii during which period of time the machine is not ready for brewing coffee Wait until the OK indicator light glows continuously see Fig G page ii otherwise the temperature will be too high and will burn the coffee hint e After frothing milk dispense hot water from the steam hot water nozzle see below which will help clean the nozzle and help the boiler to cool down more quickly al to produce hot water for other drinks eg tea fruit drinks 1 Ensure that the pod filter holder with a pod holder is fitted to the coffee maker 2 Press the power on button and its light will glow and the OK indicator light will flash 3 When the OK indicator light stops flashing and glows continuously place a cup under the steam hot water nozzle and move the function lever to the lower steam position 88 Hot water will dispense from the nozzle 4 Switch off and unplug after use Never use teabags in the pod filter setting the dispensing volume The coffee maker has been programmed to dispense a pre selected quantity of liquid which is 40ml for Espresso 125ml for a single caf crema and 250ml for a double caf crema These volumes can only be changed by carrying out the following procedure ensuring that the appropriate coffee pod and pod filter are fitted 1 Place the required cups s under the coffee nozzle 2 Press and hold the S
7. older without a pod and dispense one cup of water e The coffee outlet nozzle can be raised or lowered to fit closer to the cup or mug on the cup stand Simply pull down or push up 11 When the OK indicator light stops flashing and glows continuously turn the function lever to the upper coffee position te and a pre determined quantity of coffee will dispense from the coffee outlet see Fig B page ii 12 Once all the coffee has dispensed the coffee maker will bleep Return the function lever to the middle o position The OK light will flash for a couple of seconds until the pod filter holder can be removed and emptied see Fig C page ii important Never attempt to remove the pod filter holder with force Always wait a few seconds after making coffee as it will be held in place until it is safe to remove 13 If you want to make further cups of coffee wait for the flashing OK indicator light to glow again continuously Wait a few seconds then pull out the pod filter holder and fit a new coffee pod or change the pod filter if an alternative type of coffee is desired Continue as above Note when making an espresso the coffee maker will make a pumping noise which will cease part way through the operation but will resume again before all the drink is dispensed This ensures that the best coffee flavour is extracted After each coffee is dispensed excess water from the brewing process will be discharged into the drip tray oars
8. on and its light will glow and the OK indicator light will flash until the correct temperature is reached see Fig A page ii 7 Select the pod filter required Three filters are available each differently coloured The one which is coloured black is to be used with an espresso E S E pod the grey one is for use with a single soft type pod to make a single cup of caf crema W and the dark red one is for use with two soft type pods which are stacked one on top of the other to make 2 cups of caf crema ww 8 Place the desired pod filter into the pod filter holder Make sure that it is fitted correctly The tab with the text should face the front of the unit and be held firmly in place 9 Fit the pod s then push the pod filter holder into the coffee maker The holder will be magnetically held in place during operation Always follow the manufacturers instructions on the positioning of the pod in the pod filter Press the espresso pods firmly into the cavity e Never use ground coffee important t is important that the correct pod is used with the correct pod filter as the coffee maker senses what drink is required and as a result doses the right amount of water at the correct pressure to produce the perfect drink 10 Place a cup or cups under the coffee outlet hint e For optimum coffee we recommend priming your machine every time it is switched on Fit the espresso pod filter into the pod filter h
9. rised Kenwood repairer UK If you need help with using your machine or servicing spare parts or repairs in or out of guarantee call Kenwood customer care on 023 9239 2333 Have your model number ready it s on the underside of the coffee maker spares and attachments call 0870 2413653 other countries Contact the shop where you bought your machine guarantee uk only If your coffee maker goes wrong within one year from the date you bought it we will repair it or replace it if necessary free of charge provided you have not misused neglected or damaged it it has not been modified unless by Kenwood it is not second hand it has not been used commercially you have not fitted a plug incorrectly and you supply your receipt to show when you bought it This guarantee does not affect your statutory rights trouble shooting guide symbol warning signs possible cause solution sti DA O 7 1 ok ok ok pP ok app OK and steam indicator flash alternately The steam indicator light flashes quickly The power indicator flashes The power indicator and OK indicator flash alternately Lack of water The memory is corrupted The machine needs to be descaled The pod filter holder is missing Refill the water tank The coffee maker needs repairing See service and customer care The coffee maker can still be used but the dispensing volumes will default to factory s
10. team button for 5 seconds during brewing and the OK and steam indicator lights will flash simultaneously When the coffee volume in the cup reaches the required level release the button and the water volume will be stored in the memory This can be re programmed at any time following the above procedure descaling When the power on indicator light starts flashing the machine needs to be descaled and it will continue to flash until the unit is descaled 1 With the machine switched off place a jug under the steam hot water nozzle This may need to be emptied during the descaling process 2 Fil the water tank to the Max level with a liquid descaling agent follow the manufacturers guidelines 3 Fit the pod filter holder with pod filter fitted to the coffee maker 4 Press the power on button Both the power on and OK indicator lights will flash 5 When the OK indicator light stops flashing turn the function lever to the lower steam position p 10 11 12 cl 1 2 3 Press the Steam button for three seconds This will activate a descaling program and the 3 indicator lights On Off OK and Steam will flash in succession indicating the descaling cycle is in operation During this time the pump will operate 30 seconds On followed by 2 minutes Off Allow the entire descaling agent to flow out from the steam hot water nozzle The machine will bleep when the tank is empty When the tank is empty return the function le
11. ver to the middle o position The indicator lights will continue to flash Rinse the tank and fill with fresh water Turn the function lever to the lower steam position and allow all the fresh water to flow out from the steam hot water nozzle During this cycle the pump will operate continuously until the tank has emptied and the coffee maker will bleep Turn the function lever to the middle o position Hold down the steam button for 3 seconds to reset the descale cycle and the indicator lights will stop flashing The coffee maker is now ready for use eaning Before cleaning unplug and let everything cool Never immerse the appliance in water Don t wash parts in the dishwasher tank pod filter pod filter holder Wash rinse and allow to dry steam hot water nozzle Prior to cleaning allow some hot water to flow out of the nozzle see to produce hot water for other drinks then unplug and allow to cool before proceeding Unscrew the nozzle by turning anti clockwise then wash thoroughly Check that the hole in the nozzle is not blocked If necessary unblock with a pin Clean the steam hot water delivery tube Make sure the end is not blocked Screw the nozzle back onto the delivery tube drip tray drip tray cover Empty the drip tray regularly Wash then dry thoroughly service and customer care 2 2 e If the cord is damaged it must for safety reasons be replaced by Kenwood or an autho
Download Pdf Manuals
Related Search