Iqua 2 Headphones User Manual
Contents
1. button briefly twice Adjusting volume Slide the Volume slider to increase or decrease the volume 10 Voice dialing when supported by the phone To activate the voice dialing feature of your phone press the ac button briefly once Please refer to the user guide of your phone for details Some phone models do not support voice dialing For optimal performance connect your phone with Snake 2 before recording voice tags Muting an active call You can mute or unmute the microphone of Snake 2 during an ongoing call by pressing the button briefly during the call When your microphone is muted Snake 2 beeps periodically You can mute the speakers of Snake 2 by sliding the volume slider to minimum Switching the call between phone and handsfree mode To transfer an active call from Snake 2 to your mobile phone press and hold down the button until the call is transferred to your phone To transfer an active call from your mobile phone to Snake 2 use the functions of your phone as instructed in its user guide Light indication summary The Snake s LED light can be either blue or red and is usually accompanied by a sound signal The different signals indicate Blue light flashing 5 times power is switched on off Blue light flashing every 3 seconds power is on Blue and red light flashing in turns in pairing mode waiting for user to complete pairing with mobile phone Redlight flashing every 3 se2. product does not interfere with you operating the vehicle Charging the battery Before using Snake 2 you must charge it for approximately 6 hours When the battery is fully charged it provides up to 10 hours of talk time and up to 7 days of standby time 1 Connect the charger cable to Snake 2 2 Plug the car charger into the cigarette lighter The red light will turn on 3 When the battery is fully charged the red light will turn off Switching on and off To switch on Snake 2 Press and hold the amp button until the blue light starts blinking To switch off Snake 2 Press and hold the button until the lights turn off Pairing the Snake 2 and your mobile phone Pairing is the process of linking Snake 2 with your Bluetooth enabled mobile phone After this process is completed you can use the Snake 2 with this paired mobile phone If you want to use the Snake 2 with another mobile phone you must repeat the pairing process again Even though Snake 2 can be paired with up to 8 compatible phones it can only be connected to one phone at a time 1 2 Make sure Snake 2 is charged and turned OFF Press and hold down both the 5 button and the WZ button at the same time until you here a sound and the lights start flashing Release the buttons Snake 2 is now in pairing mode waiting for your mobile phone to contact it Complete the pairing with your mobile phone Please refer to the manual of your mobile phone for
3. the sustainable reuse of material resources Household users should EN contact either the retailer where they purchased this product or their local government office for details on where and how they can take this item for environmentally safe recycling Business users should contact their supplier and check the terms and conditions of the purchase contract This product should not be mixed with other commercial wastes for disposal 16 12 MONTH LIMITED WARRANTY IQUA Ltd guarantees that this product is free from material and workmanship defects for a period of twelve 12 months unless stated otherwise from date of purchase provided the following terms of this warranty are satisfied This warranty only applies to the original owner of this product 1 The purchaser must be able to proof the purchase by presenting the original sales receipt describing the product to establish the validity of the warranty claim to IQUA Ltd atthe provider of warranty service IQUA Ltd shall have the rightto deny warranty without dated proof of purchase Any evidence of alteration erasure or forgery results in termination of the right of warranty IQUA Ltd agrees to repair or replace without charge to the original owner any defective product under warranty IQUA Ltd will supply replacement parts free of charge for any IQUA product under warranty upon request Replacement or repair do not extend original warranty period This warranty is not valid
4. Iqua Snake Bluetooth Headrest Handsfree User Guide eo e iqua Communicate in stule Contents About Bluetooth Technology tette 2 General Information Getting Started Call Functions Light indication summary Battery Information Jioc et ede c Ata mene ee eae eae Care and Maintenance iiie cad dees dp necis 12 MONTH LIMITED WARRANTY sssseeeeeem em emeret enne 17 About Bluetooth Technology Bluetooth is a technology for wireless communication between devices Bluetooth technology is based on a radio receiver and transmitter built into a tiny microchip one of which is incorporated into this product and the other is in a compatible mobile phone Bluetooth enables wireless connections between a device and a mobile phone within a radius of 10 meters of each other without a physical cable or line of sight connection Iqua Snake 29 Headrest Handsfree can be used with any brand of Bluetooth mobile phones that supports the Headset or Handsfree profiles For the latest compatibility information please visit www iqua com The Bluetooth word mark and logos are owned by Bluetooth SIG Inc and any use of such marks by IQUA is licensed Other trademarks and trade names belong to their respective owners 2 General Information Thank you for purchasing Iqua Snake 29 Headrest Handsfree It is a stylish product that enables comfortable handsfree communication with compatible mobile phones tha
5. conds low battery e Red light on continuously charging the battery Blue light on continuously phone call active 12 Product Specifications Size 470 mm L x 230 mm W x 30 mm H Talk Time Up to 10 hours Charging time Within approx 6 hours Bluetooth Compliance Bluetooth 1 2 specification Paired Devices Up to 8 one at a time Speaker 2pcs 2 x 1W Operating Range Up to 10 meters 13 Battery Information Do not attempt to replace the battery by yourself as it is built in and cannot be changed Do not dismantle the charger as it may expose you to dangerous voltages or other hazards Please charge the device only with the chargers provided by the manufacturer Incorrectly reassembling the device can cause electric shock when it is used again Do not use the charger outdoors or in a humid environment A Avoid charging the device in extremely high or low temperatures Leaving the battery in hot or cold places such as in a closed car in summer or winter conditions will reduce the capacity and lifetime of the battery and its ability to charge Always try to keep the battery between 15 C and 25 C 59 F and 77 F A device with a hot or cold battery may not work for a while even when the battery is fully charged Battery performance is particularly limited in temperatures well below freezing 14 Care and Maintenance Donot expose the device to liquid moisture or humid
6. details on how to search and pair When the mobile phone has found the handsfree device the phone will show Iqua Snake 2 on its display In order to pair with the phone enter the PIN code of Snake 2 which is 0000 Once pairing has been successful you will hear a sound and the blue light will start blinking If pairing fails you will hear a sound and the lights will stop blinking Repeat the above procedures Disconnecting Snake 2 and your phone To disconnect Snake 2 and the phone do one of the following 1 Switch off the Snake 2 2 Disconnect Snake 2 in the phone menu 3 Move the phone more than 10 meters away from Snake 2 Reconnecting the paired Snake 2 with the phone To reconnect Snake 2 to the last phone used simply switch on Snake 2 and it will automatically connect to the phone Otherwise make the connection in the phone menu as instructed in the user guide of the phone Call Functions Answering ending and rejecting a call Answer a call When there is an incoming call you will hear the mobile phone s ringing tone through the Snake 2 speakers To answer a call just press the button The blue light turns on to indicate an active call End a call To end an active call press the button briefly Reject a call When you receive an incoming call that you do not want to answer simply press the WZ button Redialing the last dialed number To place a call to the last dialed number press the
7. for product owners who attempt to repair defective units Under Certain product liability regulations may apply to you as the owner of the Product however under no circumstances is IQUA Ltd liable for any indirect or consequential damages to person or property by the use of any IQUA products The warranty is not valid in case of fire lighting earthquake accident misuse unusual physical or electrical stress or any other cause beyond normal usage and care of the product IQUA Ltd reserves the right to make changes or improvements in design or manufacture without having any obligation to install such changes in existing and sold products Warranty does not cover normal wear and tear ofthe product or the operation time of the battery 17 DECLARATION OF CONFORMITY We Iqua Ltd declare under our sole responsibility that the product HHF 601 conforms with the provisions of the following Council Directive 1999 5 EC C 0678 1 18 IQUA Ltd Tekniikantie 12 Tel 358 9 2517 2700 02150 Espoo info iqua com FINLAND WWW IQUA COM
8. ity as it is not waterproof Do not use or store the device in dusty dirty areas Its moving parts and electronic components can be damaged Donotstore the device in hot areas High temperatures can shorten the life of electronic devices damage batteries and warp or melt certain plastics Donotstore the device in cold areas When the device returns to its normal temperature moisture can form inside the device and damage electronic circuit boards Donotdrop knock or shake the device Rough handling can break internal circuit boards and fine mechanics Donotuse harsh chemicals cleaning solvents or strong detergents to clean the device Use a soft clean dry cloth to clean any lenses Do not expose your device to contact with sharp objects as this will cause scratches and damage Do not stick anything inside the device as this may damage internal components Do not attempt to take apart the device as it does not contain serviceable components Correct disposal of this product Applicable in the European Union and other European countries with separate collection Systems This symbol shown on the product or its literature indicates that it should not be disposed with other household wastes at the end of its working life To prevent harming the environment or human health from uncontrolled waste disposal please separate this from other types of wastes and recycle it responsibly to promote
9. t support Bluetooth wireless technology It is designed for easy installation and convenient phone calls while driving The microphone speaker and keys are close to you for good audio quality and easy usage You can adjust the flexible neck according to your preference and if you want privacy you can plug in the headset The device can be charged with the cigarette lighter charger included in the sales package Overview of the product 10 1 NN 2 3 4 5 6 7 8 9 10 11 Main body Loudspeakers Adjustable neck Microphone Installation piece and screws Call Power button Switch Snake 2 on off answer a call end a call redial or activate voice dialing Mute button Mute unmute an active call reject an incoming call Volume slider Adjust the volume Indicator light Status indication with blue and red light Charger connector For charging the battery Headset socket For connecting the privacy headset Sales package content 1 Snake 2 including headrest installation piece and screws Car charger Privacy headset Quick Guide User Guide qa RON Getting Started Installation Attach Snake 2 to the headrest of your car seat with the headrest installation piece and screws as shown in the picture Make sure that the product is not in the operating area of any possible side impact airbags or other safety or operating equipment of your car Also check that the
Download Pdf Manuals
Related Search