Insignia NS-CLIP01 Clock Radio User Manual
Contents
1. Press to turn on the Sleep timer 15 30 45 60 75 90 To turn off press until 00 appears on the display Pil Preset e In iPod mode press to begin playback Press again to pause playback Press again to resume playback Press and hold to turn off your iPod iPhone screen e In FM mode press to select a preset station Continue pressing to cycle through the available preset stations You can store up to 10 preset stations e In iPod mode press to go to the previous track or press and hold to use fast back e In FM mode press to go to the next lower radio frequency or press more than one second and release to search for a lower radio station e In iPod mode press to go to the next track or press and hold to use fast forward e In FM mode press to go to the next higher radio frequency or press more than one second and release to search for a higher radio station VOL VOL Press to increase or decrease the clock radio volume SNOOZE DIMMER Press while the alarm is sounding to turn the alarm off for 10 minutes You can do this as many times as you want To turn the alarm off until the next day press any other button To turn the alarm off press the Alarm button until there is no source displayed next to the alarm icon on the display When the alarm is not sounding press to cycle through the display brightness levels high gt middle gt low Note When the clock radio is turned on the LCD backl2. TUNE gt or TUNE I lt keys to fast forward or fast backward until you release the key Using the FM radio 1 Fully extend the FM antenna on the back of the clock radio 2 Press the POWER SOURCE button repeatedly to enter radio mode The tuner frequency appears after one second 3 Adjust the antenna to get the best radio reception Manual tuning e Press TUNE gt gt I or TUNE I lt briefly to tune to a higher or lower frequency Auto tuning e Press and hold TUNE gt gt I or TUNE I lt for more than one second to automatically tune to a higher or lower frequency Tuning automatically stops when it detects a station signal During auto tuning press POWER SOURCE to exit the auto tuning mode Note If there is no station found in one cycle auto tuning stops at the beginning frequency Setting presets You can store up to ten preset stations 1 In radio mode press TUNE gt gt I or TUNE ma to select a station 2 Press and hold gt II PRESET for two seconds to enter programming mode The PRESET PII icon appears and the memory digits flash in the display 3 Press TUNE gt gt or TUNE ka repeatedly to select a desired preset number 01 to 10 to store the station 4 Press PII PRESET to confirm your choice The preset station is stored in the memory 5 Repeat steps one through four to store more stations Press any other keys to leave the programming mode 6 To select a preset station briefly press gt Il PRESET repeate
3. power source when cleaning e The finish on your clock radio may be cleaned with a dust cloth and cared for as other furniture Use caution when cleaning and wiping the plastic parts e Ifthe front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth slightly dampened with a mild soap and water solution Never use abrasive cloths or polishes as these will damage the finish of your clock radio Caution e Never allow water or other liquids to get inside your clock radio e Modifying or tampering with the internal components of your clock radio can cause a malfunction and might invalidate its warranty If your clock radio is not performing as it should take it to the local dealer for assistance System requirements Compatible with iPod Nano 3G 4G 5G 6G iPod Touch 1G 2G 3G 4G iPod classic iPhone original 3G 3Gs 4 45 Specifications e Number of alarms two Frequency range FM 87 5 107 9 MHz 200 KHz steps e Station preset ten e External connections 3 5 mm stereo 30 pin iPod connector e Volume 16 levels e Speaker 2 x 36mm e Output power 1W x 2 RMS e Power source DC 5 9V 1 8A adapter e Back up batteries 2 x AAA alkaline batteries e Dimensions WxDxH 6 81 x 2 87 x 5 70 in 173 x 73 x 144mm Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules Operation of this product is subject to the following two conditions 1 this device may not cau
4. OOZE DIMMER to turn off the alarm The alarm is set for the next day 2 If you do not want to set the alarm for the next day press ALARM 1 or ALARM 2 repeatedly until the alarm icons disappear from the display To use the snooze e While the alarm is sounding press SNOOZE DIMMER The SNOOZE indicator appears in the display The alarm turns on automatically ten minutes later Notes e Ifthe alarm is set to Buzzer the alarm volume gradually increases until it reaches the maximum e Ifthe alarm is set to Radio or iPod the volume starts from Volume 1 and gradually increases to the volume level setting before the clock radio was turned off e The alarm sounds for 20 minutes and then shuts off automatically If two alarms are set the first alarm is stopped set for the next day when the second alarm time is reached Using your iPod iPhone Docking and charging your iPod iPhone 1 Press POWER SOURCE to select iPod mode The iPod icon appears in the display 2 Plug your iPod iPhone into the dock Note The iPod iPhone charges automatically while it is docked with your clock radio Play music on your iPod iPhone 1 Dock your iPod iPhone to the clock radio Press gt I PRESET on the clock radio or press Play on your iPod iPhone 2 Press VOL or VOL to adjust the volume to a comfortable level 3 Press TUNE gt gt I to skip to the next track forward or press TUNE I lt to skip to the next track backward Press and hold the
5. dly until you reach the station you want Playing music from an external sound source 1 Plug an audio cable with a 3 5 mm plug not included into the AUX IN jack on the back of your clock radio and into your external sound source such as an MP3 player 2 Turn on your clock radio then press the POWER SOURCE button repeatedly until AUX appears on the display 3 Control playback from your external sound source Troubleshooting Problem Solution O O o o My dock radio won t turn on My dock radio will not play in FM mode FM radio reception sounds distorted or fuzzy My iPod iPhone won t play My external audio device MP3 player won t play My iPod iPhone won t charge when it s docked e Make sure that the power cord is fully inserted in the power outlet and firmly connected to the DCIN jack on the back e Make sure that power is connected and your clock radio is turned on e Make sure your external device is turned on and is playing e Make sure the volume on your external device is turned up and is not set to mute e Make sure that the volume on your clock radio is not extremely low Repeatedly press the POWER SOURCE button to select FM mode e Make sure that the clock radio is correctly tuned to an FM Station Move your clock radio closer to a window to improve reception e Make sure your iPod iPhone is on and charged e Repeatedly press the POWER SOURCE button to select iPod m
6. ight defaults to High Power Source Press and hold to turn on your clock radio Press and hold to turn off your clock radio When your clock radio is on press to cycle through the sound sources iPod RADIO AUX Extend the antenna to improve reception 11 CLOCK SYNC Press to set the time or sync the time with an iPhone See Using the Time Sync function on the right 12 AUXIN jack Plug the connector from an external sound source such as an MP3 player into this jack 13 DCIN 5 9V jack Plug the small connector from the AC adapter into this jack Important notes e The two AAA batteries are only for the clock memory When battery power is low or if they are installed incorrectly the _ logo shows on the display Change or reinstall the batteries e Please remove the batteries if your clock radio is not used for a long time Precautions when using batteries e Use only the size and type of batteries specified e Do not mix different types of batteries together e g alkaline rechargeable and standard carbon zinc or old batteries with fresh ones Exhausted batteries must be removed to prevent any battery leakage e Dispose of batteries properly according to environmental regulations e Battery battery pack or battery installed shall not be exposed to excessive heat such as sunshine fire or the like Setting the time 1 Press and hold Clock Sync for two seconds until the hour bli
7. nks on the display 2 Press Tune pa or i to set the hour 3 Press the Clock Sync button again The minutes blink on the display 4 Press Tune I lt or gt gt I to set the minutes 5 To finish setting the clock press the Clock Sync button again or just wait for ten seconds until the display returns to normal Using the Time Sync function 1 Place your iPod iPhone in the docking station 2 Press the Clock Sync button The clock radio syncs the time with the iPod iPhone automatically Note The Time Sync function can be used with most of the iPod iPhone models except some older models such as iPod mini iPod 3G and iPod 4G Selecting the mode Source e Press SOURCE repeatedly to select iPod Radio or AUX The source you select appears on the display Setting the alarm To set the alarm time 1 Press the Alarm button to select the alarm music source Buzzer Radio iPod or close the alarm If you select iPod make sure your iPod iPhone is placed in the dock If you select Radio the alarm will be the last radio station you listened to 2 Press and hold ALARM 1 or ALARM 2 until the hour digits blink 3 Press Tune a lt or i to set the hour then press the ALARM 1 or ALARM 2 button The minutes digits blink 4 Press Tune lt lt or pp to set the minutes then press ALARM 1 or ALARM 2 to save the setting and exit the alarm setting mode To turn the alarm off 1 When the alarm is sounding press any key except SN
8. nsigniaproducts com for details Contact Insignia For customer service call 1 877 467 4289 www insigniaproducts com Made for iPod and made for iPhone mean that an electronic accessory has been designated to connect specifically to iPod iPhone respectively and has been certified by the developer to meet Apple performance standards Apple is not responsible for the operation of this devise or its compliance with safety and regulatory standards Please note that the use of this accessory with iPod or iPhone may affect wireless performance iPod and iPhone are trademarks of Apple Inc registered in the U S and other countries 2012 BBY Solutions Inc Inc All rights reserved INSIGNIA is a trademark of BBY Solutions Inc Registered in some countries All other products and brand names are trademarks of their respective owners ENGLISH 11 1380
9. ode e Makesure your iPod iPhone is not paused e Make sure that your iPod iPhone is properly docked e Make sure that there are songs in your iPod iPhone e Make sure that the hold function is not activated on your iPod iPhone e Make sure that your iPod iPhone is working properly before you dock it into your clock radio e Remove your iPod iPhone from the docking compartment Clean the connectors in the docking compartment and on your iPod iPhone then replace it in the docking compartment e Your iPod iPhone software may be outdated Upgrade its software For details visit www apple com You need to use the controls on your MP3 player to control playback e Make sure your external device is on and charged e Repeatedly press the POWER SOURCE button to select AUX mode e Make sure your external device is not paused e Make sure the audio cable is fully inserted into the external device and the AUX IN jack on the clock radio e Make sure that there are songs in your external device e Make sure that your external device is working properly before you connected it to your clock radio e Make sure that your iPod iPhone is properly docked e Make sure that the hold function is not activated on your iPod iPhone e Make sure that your iPod iPhone battery is not faulty e Make sure that the power cord is plugged in Maintaining e To prevent fire or shock hazard disconnect your clock radio from the AC
10. se harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation This equipment has been tested and found to comply within the limits for a class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced technician for help FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user s authority to operate this equipment Canada ICES 003 statement This Class B digital apparatus complies with Canadian ICES 003 90 day limited warranty Visit www i
11. standby mode The Source name is no longer displayed Volume control e After you select the mode you want press Volume or Volume to set the volume to a comfortable level Note When the volume is turned to minimum 00 the system enters MUTE mode Features Front view ja INSIGNIA Dil ALARM 1 ALARM 2 SLEEP PRESET i4 TUNE P Top view SNOOZE DIMMER POWER SOURCE Back view CAUTION M RISK OF ELECTRIC SHOCK DO NOT OPEN This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation N A Insert your iPod iPhone into this dock to play selections through your clock radio The clock radio charges the iPhone iPod when docked Use the adapter that came with your iPod iPhone if needed Alarm 1 Alarm 2 Press to set the alarm See Setting the alarm on the right Sleep
12. z Made for iPod iPhone Quick Setup Guide Clock Radio with iPod iPhone Dock NS CLIP01 Congratulations on your purchase of a high quality Insignia product Your NS CLIPO1 represents the state of the art in clock radios with an iPod iPhone dock and is designed for reliable and trouble free performance Package contents e Clock radio with iPod iPhone dock e AC power adapter e AAA batteries 2 e Quick Setup Guide Works with all docking iPods and iPhones Installing the batteries 1 Open the battery compartment on the bottom of your radio 2 Place two AAA size batteries in the battery compartment Make sure to match the and on the battery to the and signs in the battery compartment 3 Close the battery compartment until it clicks into place Connecting the AC adapter 1 Plug the small connector at the end of the power cord into the DC IN 5 9V jack on the back of your radio 2 Plug the AC adapter into a 100 240V 50 60Hz power outlet The clock radio enters standby mode and the time appears on the display Turning the radio on and off 1 In standby mode press and hold POWER SOURCE to turn on the clock radio The Source name appears in the upper left hand corner of the display 2 When you turn on the clock radio for the first time iPod mode activates by default For normal use the system activates the last source used before you powered it off 3 Press and hold POWER SOURCE again to switch to
Download Pdf Manuals
Related Search