Hotpoint WE24 Refrigerator User Manual
Contents
1. COOLING LIGHT ON OFF PILOT LAMP BUTTON Using the wine cellar Hotpoint Bottle ageing compartment Manual temperature control ee The ageing compartment s main function is that of When you plug in your wine cellar the display shows guaranteeing that your wines are preserved in optimal the temperature inside the cellar it has been set to conditions reach 15 C and become steady on it Should you need to adjust it follow the instructions below The temperature has been set in the factory at a temperature held to be excellent in most cases and is 1 When you plug in your wine cellar the display shows 15 C in the upper compartment the temperature that has been set 2 Press the H button for one second see the Wine has a complex nature and it derives from a lon 9 Control Panel The temperature will begin to blink and slow process In order to best express its attributes very specific conditions are necessary 3 Press the D or buttons until you reach the All wines are preserved at the same temperature but desired temperature depending on their different characteristics wines are A Wait 5 seconds for the temperature to stop served and tasted at very different temperatures see blinking the Table of ideal wine temperatures 5 Wait until the wine cellar reaches its temperature Therefore just as for manufacturers wine cellars for before you place the wine bottles inside your new appliance the absolute2. temperature value is not important for preserving your wine Rather the The inside light does not go on or it goes off constant temperature through time is important Wine temporarily when the inside temperature goes over preservation is ideal at any temperature as long as 24 C This allows you to reach the pre set that temperature does not vary temperature more quickly Taking out the wooden shelves WARNING The wooden shelves are not sliding Do not take them out when loaded with bottles to prevent the risk of the bottles breaking You can take the shelves out for cleaning only when they are not loaded with any bottles cB Table of ideal wine temperatures This table indicates the approximate temperatures at which wine should be served Should one of your wines need to be served at a temperature that is greater than the temperature inside your wine cellar we suggest that you leave it wine out for the time that is necessary before you serve it Dry and Sweet Sparkling Wines 6 C Verdicchio di Matelica e dei Castelli di Jesi 8 C White wines from Trentino Alto Adige 11 C Franciacorta White Wines 11 C Dry aromatic white wines 10 C Dry young and fruity white wines 8 C Red Bordeaux EG White wines from Friuli Venezia Giulia White Bourgogne 11 C Rodano wines 15 C Languedoc Roussillon 13 C Red rather tannic wines with medium Ros Provence tel etree 16 C Stocking the wine bottles Standard 24 bottle s
3. the device free Do not use mechanical devices or any means not suggested by the manufacturer to soeed up defrosting Do not damage the coolant circuit Contact the after sales service to replace the neon The cable must not be bent or crushed The cable must be checked on a routine basis and replaced only by authorised technicians The power supply cable is of a Y type Contact the after sales service to replace it Do not use electrical equipment inside the food compartments unless they are of a kind suggested by the manufacturer The Manufacturer shall not be liable if any of the above rules are not complied with DATA SHEET width cm 60 length cm 44 8 depth cm 55 Weight 30 5 KG Weight 35 5 Kg Voltage 115 220 V Frequency Hz 50 60 These values may change in different countries In order to find the specific features of your device check the product features plate When the device is empty Installation Positioning and connection Unpacking 1 3 Unpack the device immediately and make sure it has not been damaged during transport Should it be damaged do not connect and get in touch with the Dealer Carefully remove the protections and the adhesives open the door and make sure all the components are present Take out the power supply cable Positioning 1 2 3 Position the device in a well ventilated area not damp and free avoid cabinets with c
4. the wall outlet or not enough to make contact Or there could be a power failure in your home e The wall outlet is not in working order Plug the wine cellar into another wall outlet to check The compressor never stops e Contact the Service Centre Any work that is done to the wine cellar should be performed by your authorized local Service Centre Short term faults such as power failure will not compromise the wines It is only when working faults are left unsettled for a long time that the wine may suffer
5. User Guide WINE CELLAR Contents co Features 2 cB Notices Data Sheet English 1 Installation 3 Location and power connection Technical information Product Description 4 Interior Parts Control Panel Using the Wine Cellar 5 6 Bottle ageing compartment Manual temperature control Taking out the wooden shelves Table of ideal wine temperatures WE 24 Stocking the wine bottles 7 How to stock the bottles Maintenance and troubleshooting 8 Care and Maintenance Troubleshooting K Hotpoint Features Notices Remember to keep this booklet so you can refer to It at any time In case of sale transfer or should you move remember to keep it together with the device Read the instructions carefully there is important information about installation use and safety To prevent danger stemming from instability of the device you must fasten it in place following the assembly instructions strictly Whenever moving or transporting the device keep it in a vertical position The beverage centre must not be used by children or invalids without Supervision by an adult or a tutor in order to prevent the cellar from being used improperly Children may use the beverage centre only if supervised by an adult in order to prevent them from playing with the cellar After installing the device the power cable and socket must be easy to reach Keep the ventilation openings on the casing of
6. losed walls Keep the device away from heat sources Make sure the minimum distances between the device and the walls of the room where it is placed are kept in order to ensure perfect ventilation of the device See figure Y Ventilation space at least 50 mm K Hotpoint Wiring connection After transport stand the device vertically and wait for at least 3 hours before connecting it to the wiring system Before putting the plug into the power socket make sure that the socket is earthed and according to legal regulations the socket is able to hold up to the maximum power load of the machine indicated on the Data Sheet table or on the feature plate to the bottom right see Description of the device the power supply voltage falls within the range indicated on the Data Sheet table or on the feature plate to the bottom right see Description of the device the power socket is compatible with the plug of the device Otherwise replace the socket or the plug do not use extensions or multiple sockets Dimensions of the compartment 450 Furniture side area 588 l Dimensions of the cellar Product Description SSE Interior Parts CONTROL DOOR PANEL 2 T a Cn BOTTLE AGEING SHELVES DATA PLATE COMPARTMENT Control Panel PILOT DISPLAY REDUCE INCREASE LAMP LIT TEMPERATURE TEMPERATURE POWER CONNECTION LIGHT
7. tock The 24 bottle stock for standard mixed and renana bottles is recommended for wines that need to be visible and easily removed STANDARD 24 Bottles 100 lying down 3 shelves Position each bottle into the slots on the 3 wooden shelves 6 bottles can be placed on the bottom of the wine cellar We suggest you place the Renana bottles onto the lower shelf and the bottom of the wine cellar because they have been specially designed to hold larger bottles The wooden shelf can safely hold up to 22 bottles Ks K Hotpoint Champagne bottle stock Champagne bottles are larger than standard bottles They must be placed onto the base of the wine cellar which can hold up to 5 If you want to stock more than 5 Champagne bottles in your wine cellar remove the 3th shelf and stock the bottles in two rows placing the bottles in the second row between those on the bottom row This will hold up to 9 bottles Some stocking configurations PRESERVATION 28 Bottles 100 lying down Maintenance and troubleshooting E e an Care and maintenance Disconnecting the wine cellar During cleaning and maintenance it is imperative that you unplug the wine cellar Troubleshooting If you notice that your wine cellar is not working properly check with the following list before you call your Service Centre Problem Possible causes solutions The compressor does not work e The plug is not plugged into
Download Pdf Manuals
Related Search