Home

Auto Page RF-310 Automobile Alarm User Manual

image

Contents

1. Office 310 618 2002 Customer Service 800 262 2527 Ext 462 www autopageusa com
2. handling charges Note The enclosed Warranty Card may be reguired to receive warranty services This WARRANTY will be considered void if the eguipment has been misused neglected improperly serviced altered dropped or damaged by water contrary to the AutoPage OPERATIONS MANUAL Or if used with accessories not approved by AutoPage which may have contributed to the defect See note below regarding product installation The purchaser s remedies under this WARRANTY shall be limited to the repair or replacement of electronic components only THE FOLLOWING IS NOT COVERED Damages or deterioration to cases batteries covers and cabinets the cost of repairs replacement and labor of which shall be borne by the purchaser even if occurring during the WARRANTY period Any eguipment or parts which are claimed to be defective under this WARRANTY must be sent to the AutoPage Service center with proof of purchase at the purchaser s expense prior to such return a Return Authorization Number should be obtained AutoPage will return the eguipment charges prepaid Warranty Service can be provided through the dealer where the eguipment is originally purchased Any unexpired WARRANTY shall be applicable to eguipment and parts in the possession of the original purchaser only THIS WARRANTY IS IN LIEU OF ANY AND ALL OTHER WARRANTIES EXPRESSED OR IMPLIED INCLUDING BUT NOT LIMITED TO ANY WARRANTY OFMERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOS
3. AUTOPAGE KUJ RF 310 PROFESSIONAL VEHICLE SECURITY SYSTEM OPERATION MANUAL THIS PRODUCT IS DESIGNED FOR PROFESIONAL INSTALLATION ONLY TRANSMITTER OPERATION Transmitter Button System Function Remark a Arm Lock door Button a Q Arm and Delete Optional Sensor Press twice MN Button a Car Locator System in Armed N Button Panic function Press 3 seconds N Button for 3 seconds m Disarm amp Unlock Door Button m m Two Steps Door Unlock 8 Press twice within 3 Button Disarm System seconds al Car Locator Button Pop Trunk Release Press 2 seconds Button for 2 seconds If the H3 6 Gray Wire is ey Panic function not Trunk release Output Button for 3 seconds See Alarm Feature III 2 ESIIN NNN INN Button Side button 2nd Car Operation or Side Button Garage Door Opener Switching Code ACTIVE ARMING LOCK 8 ARM 1 Press f button on transmitter 2 The siren will chirp once and parking light will flash once indicating that the system is now armed The vehicle doors will lock upon arming when interfaced with the security system Note Defective sensor reminder If the siren sounds 3 chirps then you have left a door trunk or hood lid ajar See Feature I 3 Programming SILENT ARMING DISARMING Press the 3 button on the transmitter to arm or disarm your security system with no chirp sound heard arm disarm confirmation will be through the vehicles parking lights only SH
4. Alarming Flashing Slowflash On Locking ss ALARM INDICATORS CHIRP INDICATORS PARKING LIGHTS Parking Light 1 flash 2 flashes reminder Intrusion Intrusion Locator Locator LED INDICATORS Off Disarmed Slow Armed flash LED Function flashes Dause flashes Dause flashes Shock Sensor pause 5 Trigger on Ignition pause Fast Passive flash arming On Valet mode solid This device complies with part 15 of the FCC rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation LIMITED LIFETIME WARRANTY PROVISIONS U S and Continental U S Only AutoPage Inc WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery Your AutoPage eguipment is guaranteed for life to the original purchaser user of the eguipment under the following conditions If the product proves defective according to AutoPage s testing within the first year the defective unit may be exchanged or repaired free of charge Proof of Purchase dated sales receipt must accompany all warranty returns otherwise your return will be rejected and sent back After one 1 year the purchaser should ship the unit prepaid to AutoPage with a money order in the amount of 20 00 to cover shipping and
5. E AutoPage shall not be liable under the foregoing WARRANTIES or otherwise for Any personal injury of any kind to the purchaser its employees or agents or anyone else whomsoever resulting directly or indirectly from the use or presence of the eguipment or parts Conseguential damages of any kind any inability of the purchaser to use the eguipment IMPORTANT NOTE Any damages to the alarm system resulting from an installation performed by anyone other than a professional installation technician authorized by a dealer of Auto Page will void the product s warranty This WARRANTY CARD is for your record However AutoPage reserves the right to reguest you to submit this WARRANTY CARD which must have complete information to receive warranty service Please keep this card in a secured place AUTOPAGE WARRANTY SERVI CE CARD Model Serial CUSTOMER TO COMPLETE DEALER TO COMPLETE Mr Mrs Ms Your Name Please Print Company Name Address Dealer s Address City State Zip Code City State Zip Code Telephone Number Dealer s Telephone Number Year Make Model of Vehicle Date of Installation Purchase Dealer s Signature Proof of Purchase which includes the store name and date of purchase must accompany all warranty returns It is the purchaser s responsibility to keep this card for any future warranty service AUTOPAGE KUY 1815 West 205 Street Suite 101 Torrance California 90501 1525 Main
6. OCK SENSOR OPTIONAL SENSOR BY PASS Press the button on the transmitter twice within 3 seconds will arm the security system by pass the shock sensor or the optional sensor connected to 4 pin plug The system will chirp one additional time to confirm the sensor bypass mode was activated The sensor bypass feature is programmed to activate for one arming cycle only The security system will return to normal operation during the next arming cycle PASSIVE ARMING See Feature II 2 Programming Active arming disarming is controlling your security system via the remote transmitter This security system is equipped with an optional Passive Arming feature which allows the security system to arm 30 seconds after the last door is closed Operation is as follows 1 Turn the ignition to the OFF position and exit the vehicle CONT NEXT PAGE 2 After all entrances are closed the security system LED will flash fast for 30 seconds If you reopen any door hood trunk the security system LED will stop flashing It will begin flashing again once all vehicle entrances are closed 3 After 30 second timer has elapsed the security system will automatically ARM The siren will chirp 1 time and the parking lights will flash 1 time PASSIVE DOOR LOCKING See Feature II 2 Programming The vehicle doors will automatically lock after passive arming cycle has been completed ACTIVE DISARMING UNLOCK 8 DISARM 1 Press th
7. e mf button on the transmitter 2 The siren will chirp twice and parking lights will flash twice to indicate that the security system is now disarmed The vehicle doors will unlock and disarm when interfaced with the security system TAMPER DISARMING If the alarm is triggered upon disarm the system the siren will chirp 4 times and parking lights will flash 3 times TWO STEP DOOR UNLOCK See Feature III 2 Programming This feature will independently unlock the driver s door only when disarming the security system Pushing the button on the transmitter a second time within 3 seconds will unlock the entire vehicle AUTOMATIC RE ARM See Feature I 2 Programming If this feature is selected the security system will automatically re arm itself 60 seconds after disarming with remote transmitter Automatic rearm will cancel if any door is opened before the 60 seconds timer has elapsed DISARMING WITHOUT A TRANSMITTER The Override function may be used if the remote transmitter is lost or inoperative 1 Enter the vehicle and turn the ignition switch to ON position Alarm will sound 2 Within 10 seconds push and release the valet switch The alarm will stop sounding and enter the disarm mode You can now start and operate the vehicle normally VALET MODE The valet switch allows you to temporarily bypass all alarm function eliminating the need to hand your transmitter to parking attendants or garage mechanics When the system is in
8. revents the vehicle s starter from cranking The siren and parking lights will turn on to alert of an intrusion for 30 seconds Then the siren will stop and automatically reset and re arm If any the sensors or detectors are still active the alarm system will sound a maximum of six 30 second cycles IGNITION CONTROL DOOR LOCKS See Feature II 3 Programming If the vehicle s door locks have been interfaced to the security system the system will automatically lock the vehicle s doors when the ignition is turned ON and or unlock the vehicle s doors when the ignition is turned OFF TRUNK RELEASE See Feature III 2 Programming Press and hold WN button on transmitter for two seconds to remote control the trunk release or other electric devices CAR LOCATOR Press the AW button on the transmitter to active car locator function The siren will chirp 6 times The parking light will flash 12 times allowing you to easily locate your car P PATHWAY ILLUMINATION See Feature III 3 Programming When disarming the security system the vehicle s parking lights will stay on illuminating a pathway to the vehicle The vehicles parking lights will stay on for 30 seconds or until the vehicle s ignition is turned to the ON position ALARM OPERATING CONDITION Parking Starter Pager tenn me _ Sisane Jopin Slow flash LED Chirp 1 Flash Slow flas Off Di h a K Chirps Flashes Fast flash 3 Trigger
9. valet mode all alarm functions are bypassed however the remote panic feature and remote door locks will remain operational Enter Valet Mode 1 Turn the ignition to ON position 2 Push and hold valet switch for 2 seconds or until the LED turns on The LED will remain on as long as the system is in valet mode Exit Valet Mode 1 Return to normal operation turn ignition ON 2 Push and hold valet switch for 2 seconds the LED will turn off indicating the system is exiting the valet mode PANIC FUNCTION The transmitter can be used as a remote panic switch to manually trigger the alarm in case of emergency 1 Pressandholdthe a button on the transmitter for 3 seconds The alarm will immediately sound 2 To stop the alarm press and hold the amp or a button on the transmitter the panic mode will be turned off immediately 3 Ifthe button is not pressed the alarm will automatically stop after 30 seconds Note If the H3 6 Gray Wire is not a Trunk release Output See Alarm Feature Ill 2 Programming Press and hold the AR button on the transmitter for 3 seconds The alarm will immediately sound TRIGGER THE SYSTEM When armed your vehicle is protected as follows 1 Light impacts will trigger the warn away signal A long chirp from siren horn 2 Heavy impacts Doors open Hood open Trunk open Turning on the ignition switch All will trigger the programmed seguence The starter disable relay if installed p

Download Pdf Manuals

image

Related Search

Related Contents

Development of a PC-Based Eight-Channel WIM System  38 DP Eco Faur résultat AP 2009  MANUAL DE INSTRUCCIONES USER MANUAL KS-8  KR7A-133/KR7A-133R German User's Manual Rev. 1.01 for WEB  Emulex LP11002 Network Adapter  X-317 Users Manual    Avaya 4625SW User's Manual  Manual - QQLinx  

Copyright © All rights reserved.
Failed to retrieve file