B&D Easylifter Specifications
Contents
1. Easylifter gee SECTIONAL TILT DOOR OPENER Easyiiftor Description B amp D s Easylifter sectional door opener is one of B amp D s openers designed for the retail market This product is only available in retail outlets specifically designed for DIY orientated consumers PART NO 062503 4 piece 2 3m C Rail Chain kit Motor Specifications 4 Piece C Rail Version Contains 062503 Horsepower 43hp Rated Pull Force 870N Stand by Power 5 5W Rating 230V Motor Type Permanent split capacitor Speed 1500 rpm Volts 230 240 Volts AC 50Hz only Current 2 0 amperes Drive Mechanism Gears 16 1 worm gear reduction Drive Length of Travel Travel Rate Lamp Door Linkage Safety Personal Electronic Electrical Limit Device Limit Adjustment Start Circuit Dimensions Length overall Headroom Required Hanging Weight Receiver Operating Frequency Product Code 062503 Chain with one piece trolley on steel C Rail 2 3m 127mm per second On when door starts off 21 2 minutes after stop Adjustable door arm Pull cord trolley release Push button and stop Push button and automatic reversal in down direction Push button and automatic stop in up direction Independent up and down force adjustment screws Motor overload protector and low voltage push button wiring Circuit actuated by limit nut Screwdriver adjustment on side panel Low voltage p2. e remote control on the car e A metal garage door foil backed insulation or metal siding will reduce the transmission range e Use outside coaxial antenna adapter to move antenna Product Code 062503 5 Door reverses for no apparent reason and opener light doesn t blink e Is something obstructing the door Pull manual release handle Operate door manually If it is unbalanced or binding call for professional garage door service e Clear any ice or snow from garage floor area where garage door closes e Review Force Settings Open and close the door in learn mode for several 3 5 consecutive cycles to allow the operator to adjust to inconsistent doors e f door reverses in FULLY CLOSED position re learn travel limits Repeat safety reverse test after adjustment is complete The need for occasional adjustment of the force and limit settings is normal Weather conditions in particular can affect door travel 6 Door reverses for no apparent reason and opener light blinks for 5 seconds after reversing e Check the Safety Infra red Reversing Sensor if you have installed this accessory If the light is blinking correct alignment Note Continuously holding down the door control button will allow the door to close if the protector system is not properly aligned The transmitter will not close the door The opener lights will blink 7 Opener noise is disturbing in living quarters of home e f operational no
3. ise is a problem because of proximity of the opener to the living quarters Vibration Isolator Kit included with the operator can be installed This kit is designed to reduce the sounding board effect and is easy to install 8 The garage door opens and closes by itself e Delete all remote controls and reprogram e Make sure remote push button is not stuck on e Disconnect all push buttons or key switches attached and wait one day 9 Door stops but doesn t close completely e Review Limit Adjustment section Repeat safety reverse test after any adjustment of door arm length close force or down limit See overleaf for continuation of Trouble shooting guide An Falesco Company 10 11 12 13 14 15 Easylifter ES SECTIONAL TILT DOOR OPENER Door opens but won t close Check the Safety Infra red Beam if you have installed this accessory If the light is blinking correct alignment If opener light does not blink and it is a new installation check the down force Repeat the safety reverse test after the adjustment is complete Opener light does not turn on Replace light bulb 40 Watts maximum Replace burned out bulbs with rough service light bulbs Opener light does not turn off There may be a defective earth at the ceiling or wall receptacle The unit must be earthed Opener strains or reversed during opening Door may be unbalanced or springs are broken C
4. lose door and use manual release rope and handle to disconnect trolley Open and close door manually A properly balanced door will stay in any point of travel while being supported entirely by its springs If it does not call for professional garage door service to correct the problem Do not change force settings Opener motor hums briefly then won t work Garage door springs are broken see no 13 If problem occurs on first operation of opener door is locked Disable door lock If chain was removed and reinstalled the motor may be out of phase Remove chain cycle motor to down position Observe drive sprocket When it turns in clockwise direction and stops in down position re install chain Repeat safety reverse test after adjustment is complete Opener won t activate due to power failure Pull manual release rope and handle down and back to disconnect trolley Door can be opened and closed manually When the power is restored pull the manual release handle straight down The next time the opener is activated the trolley will reconnect The Emergency Key Release accessory if fitted disconnects the trolley from outside the garage in case of power failure Product Code 062503 RP 07 06
5. ome outlets are controlled by a wall switch e Have you disengaged all door locks Review installation instruction warnings in your opener instruction manual e Is there a build up of ice or snow under door The door may be frozen to ground Remove any obstruction e The garage door spring may be broken Have it replaced e Repeated operation may have tripped the overload protector in the motor Wait 15 minutes Try again 2 Opener operates from remote but not from door control e s door control button lit If not remove the bell wire from the opener terminals Short the red and white terminals by touching both terminals at the same time with a piece of wire If the opener runs check for a faulty wire connection at the door control a short under the staples or a broken wire e Are wiring connections correct 3 Door operates from door control but not from remote e Check battery Replace battery if necessary e Is the light at the wall control flashing Press button with key symbol to unlock the opener against remote controls e Is the receiver LED flashing at the back side of the opener when the transmitter is pressed The opener receiver must re learn the remote control code e If you purchased a new remote control then check on carton of remote control for compatibility or call the Service Hotline 4 Remote has short range e Is battery installed If needed change the battery e Change the location of th
6. ring the first year of operation Follow the or tilt up smaller sprocket for tilt doors user manual instructions carefully and repeat the safety reverse test after any adjustment Illuminated wired wall button 433 MHz radio frequency for better reception and less interference Maintenance of Your Opener e Easy limits set up with cams Once a Month e Manually operate door If it is unbalanced or binding a call for professional garage door service Method of operation e Check to be sure door opens amp closes fully Adjust Activate the operator by either the door control button limits and or force if necessary outside key switch or keyless entry system the remote e Repeat the safety reverse test Make any necessary control transmitter or manually open the door by pulling adjustments the release handle down and back toward the operator Twice a Year e Check chain tension Disconnect trolley first Adjust if Door type necessary Once a Year Standard residential sectional overhead and tilting garage doors e Qil door rollers bearings and hinges The opener does not require additional lubrication Do not grease the door tracks RP 07 06 Easylifter gp eee SECTIONAL TILT DOOR OPENER Trouble shooting guide 1 Opener doesn t operate from either door control or remote e Does the opener have electric power Plug lamp into outlet If it doesn t light check the fuse box or the circuit breaker S
7. ush button circuit 323m 50mm 14 5kg 433 92MHz Transmitter Storage Capacity Storage Capacity 8 transmitters 1 dip switch 1 keypad Optional Accessories amp Auxillary Inputs Wireless Entry Keypad Yes Additional Remote Control transmitters Yes Safety Infra Red Beam Yes Wall Mounted Transmitter Button Yes Warranty Warranty Years 1 year manufacturer s warranty parts only or 2 years manufacturer s warranty if installed by a B amp D approved installer An Falesco Company Easylifter k Product Code SECTIONAL TILT DOOR OPENER Features Trouble shooting e Strong and reliable AC motor amp maintenance e n built automatic safety reverse system stops then reverses when the door comes in contact with an object When properly installed opener will provide high performance with a minimum of maintenance The opener does not require additional lubrication Care of Your Opener e Courtesy light on for 21 2 minutes e Manual disengagement cord pull to disengage the Limit and Force Adjustments These adjustments must opener to manually open the door be checked and properly set when opener is installed Automatic reset after a power failure Only a screwdriver is required to adjust the limits Weather conditions may cause some minor changes in the door operation requiring some re adjustments Dual speed sprockets speed adjustment for sectional particularly du
Download Pdf Manuals
Related Search