ecoglo Photoluminescent Egress System Operating Instructions 17.6
Contents
1. NCE OUTPUT 17 6 mcd m as defined by ASTM E 2073 00 TARGET OUTPUT DURATION The maximum time that lighting may be reduced below 1 foot candle 10 76 lux during a performance 4 Maintenance amp Cleaning 1 Cleaning to remove built up dirt and objects from the photoluminescent components will ensure the components continue performing to specification Mopping high pressure water but not water blasting or steam cleaning or wiping with a cloth will keep the photoluminescent components clean Observation will determine if cleaning is required however a regular clean every 4 to 6 weeks or after particularly heavy use will ensure correct performance Do not use highly alkaline material ph gt 8 to clean the product as this will result in the in deterioration of the anodised surface and delamination of the photoluminescent components Similar difficulties will be experienced with acid material ph lt 5 Heavy objects should not come into contact with the nosings at any time Damage occurring in this manner will not be repaired or replaced under the warranty issued by the manufacturer September 2004 Page 22. ecoglo Photoluminescent Egress System Operating Instructions FACILITY NAME FACILITY LOCATION OPERATIONS MANAGER 1 Introduction The ecoglo egress system is illuminated by natural or artificial light sources The performance of the photoluminescent components depends upon the amount of light and the time of exposure to that light Based on the type of lights in the facility ref ACTIVATION SOURCE TYPE and the brightness of those lights ref MINIMUM ILLUMINANCE AT TARGET ecoglo will supply the time ref ACTIVATION DURATION that the lights must be left on to charge the photoluminescent components prior to a performance 2 Operating Specifications ACTIVATION SOURCE TYPE MINIMUM ILLUMINANCE AT TARGET ACTIVATION DURATION TARGET LUMINANCE TPUT nee warner 17 6 med m TARGET OUTPUT DURATION MATL 3 Operating Definitions ACTIVATION SOURCE Light source used to charge photoluminescent material ACTIVATION SOURCE TYPE Type of light to act as activation source eg metal halide fluorescent light incandescent light natural light September 2004 Page 1 TARGET Product containing photoluminescent material which is to be illuminated by the activation source MINIMUM ILLUMINANCE AT TARGET Minimum illuminance measured in lux on the photoluminescent material ACTIVATION DURATION Length of time that the activation light source must illuminate the target with the minimum illuminance level TARGET LUMINA
Download Pdf Manuals
Related Search