INON Strobe Light Holder・LE (shipped before September 10, 2012
Contents
1. Installing on compatible Arm Refer to respective user manual to attach on compatible TYS Adapter compatible arm or Arm Il System Float Arm System INON Inc http Awww inon jp September 2012 All right reserved No part of this manual may be reproduced or transmitted in any form or by any means electronic or mechanical including photocopy recording on any information storage and retrieval system now known or to be invented without permission in writing from INON Inc2. INON INON Strobe Light Holder LE shipped before September 10 2012 User Manual Appendix Thank you for purchasing INON product This document explains installation method of compatible strobe LED flashlight on this product shipped before September 10th 2012 in combination with the Z Adapter II Please take below contents as installation method instead of the same section of the original user manual The Strobe Light Holder shipped before January 19th 2012 does not come withTAllen Wrench AF 5mm j or M6 Hex Wrench which is necessary to install the Z Adapter Il Please prepare the wrench separately Other INON products like Grip Base D4 Grip BaseM1 or Z Joint Direct Base Ill comes with the wrench as standard accessory Attaching LED flashlight Firstly separate Light Head and Battery Box of your LE series LED flashlight and remove total three O rings two yellow O rings and one black LE250 LE550 S LE550 W LE700 S LE700 W or orange LE240 O ring from the Battery Box Separate the Strobe Light Holder Body and 2x TS Light Holder Plates Widen the mouth of the TS Light Holder Plate to attach it on the Battery Box then re install removed three O rings on the Battery Box and attach the Light Head on Battery Box When removing attaching Light Head Battery Box O rings make sure to refer to your LED flashlight user manual to ensure proper and appropriate procedure Put INON grease in sc
3. rew holes on the Strobe Light Holder Body and joint the Strobe Light Holder Body and the S Light Holder Plates together with supplied screws You can attach either 1 or 2 compatible LED flashlight s thumbscrew and replace the screw with supplied Strobe Light Holder Cap 3x M2 Cap Bolt Screw then attach it and the Washer white on the Z Adapter II 3x M2 Spring Washer Z Adapter II Preparation When using Z Adapter Il remove pre installed Washer white from M6 ie 2 Make sure that Z Adapter Il already has 3 sets of M2 Cap Bolt IM2 Spring are necessary Washer f Without using the Washer white and 3 sets of M2 Cap Bolt I M2 Spring Washer could damage a combined strobe A A Washer white is necessary pe a Z Adapter Il When you attach LED flashlight only use supplied Strobe Light Holder M6 Screw to fasten the Z Adapter II as shown in image right Make sure that the protruded part of the Strobe Light Holder Body seats in groove of the Strobe Light Holder M6 Screw Z Adapter II Installation Set the Z Adapter II with replaced screw on the Strobe Light Holder Body so that the O ring on the Strobe Light Holder Body Bp contacts with the Z Adapter II Fix on combined strobe with the Allen wa IP Wrench AF 5mm using long side of the wrench not to appl excessive torque Applying excessive torque like using short side F of the wrench may damage on the combined strobe
Download Pdf Manuals
Related Search