Quick Start Guide - Applied Industrial Technologies
Contents
1. 0 or set the POWER switch to the OFF position GS10 R_ Reversing Speed Control i Set the FORWARD OFF REVERSE switch to the OFF position Set the speed adjust potentiometer to 0 full CCW Apply AC line voltage Set the FOWARD OFF REVERSE switch to the desired direction of rotation Slowly advance the speed adjust potentiometer CW The motor slowly accelerates as the potentiometer is turned CW Continue until the desired speed is reached To coast the motor to a stop turn the speed adjust potentiometer to 0 or set the FORWARD OFF REVERSE switch to the OFF position C_D TB501 VOLTAGE lt _ ARMATURE VOLTAGE SWITCH SW501 90 or 180 VDC ASSURE THAT THE VOLTAGE SWITCH SETTINGS ARE CORRECT SW501 amp SW502 L2 FRMSW L1 A2 TOSW At L2 TOSW L1 A2 FRMSW A1 REPLACE SIX SCREWS ON FRONT CASE amp FIVE SCREWS ON BOTTOM PLATE 115 VAC LINE MOTOR ARMATURE INPUT 115 or 230 VAC SPECIFICATIONS AC Line Voltage 115 VAC or 230 VAC 10 50 60 Hz single phase Horsepower Range with 115 VAC applied 1 8 1 HP Horsepower Range with 230 VAC applied 1 4 2 HP Maximum Armature Current Maximum Field Current Field Voltage for 115 VAC Input 50 VDC F1 to L1 100 VDC F1 to F2 for 230 VAC Input 100 VDC F1 to L1 200 VDC F1 to F2 Eo ECO E a A A E 1 37 at base speed Analog Input Voltage Range signal must be isolated S1 to S2 for 0 90 VDC Armature Volta2. STEP 1 REMOVE THE SIX 6 PHILLIPS SCREWS ON THE FRONT CASE NOTE THE TWO SHORTER SCREWS 6 32 x 2 ON THE FRONT CASE ARE USED AT HOLE LOCATIONS 5 amp 6 CUSTOMER SUPPLIED WATERTIGHT CORD CONNECTORS 2 STER 2 REMOVE THE FIVE 5 PHILLIPS SCREWS ON THE BOTTOM PLATE GS10 amp GS10 R NEMA4X SCR MOTOR CONTROLS ADJUSTABLE SPEED DC MOTOR CONTROL BOTTOM PLATE CUSTOMER SUPPLIED WATERTIGHT CORD CONNECTORS 2 DO NOT REMOVE THE THREE 3 SCREWS SECURING THE BOTTOM PLATE TO THE HEATSINK 2009 Applied Industrial Technologies Inc All Rights Reserved C 0209 11 5139 AC LINE VOLTAGE SWITCH SW502 115 or 230 VAC STEP 3 WIRE THE CONTROL Movs01 AS SHOWN THROUGH THE CONDUIT HOLES IN THE BOTTOM PLATE A FIELD OUTPUT CONNECTIONS The field output is for shunt wound motors only Do not make any connections to F1 and F2 when using a permanent magnet PM motor For field motor connections see Field Voltage in Specifications box below EARTH FIELD GROUND OUTPUT GREEN SCREW OPERATION Set the speed adjust dial to 0 full CCW Apply AC line voltage Set the POWER switch to the ON position Slowly advance the speed adjust potentiometer CW The motor slowly accelerates as the potentiometer is turned CW Continue until the desired speed is reached To coast the motor to a stop turn the speed adjust potentiometer to
3. ge 0 1 4 VDC for 0 180 VDC Armature Voltage Input Impedance S1 to S2 Load Regulation 1 base speed or better NEMA 4X 7 To reverse direction a Set the FORWARD OFF REVERSE switch to the OFF position b After the motor comes to a complete stop set the FORWARD OFF REVERSE switch to the desired direction of rotation For a complete user manual visit www Applied com gsmum
Download Pdf Manuals
Related Search