HC_SecureKeyboard programming_HC_en_100
Contents
1. Enter x Exit programming mode and save changes You will hear two short beeps The keypad is now ready and the relay can be pulsed with the User Code Yyy y 212 Changing User Code Task Explanation 1 Enter xxxx Enter the programming mode using your Master Code You will hear two short beeps 2 Enter 1zzzz Set new User Code that will be used for switching HouseControl to normal or disable You will hear two short beeps mode z any number 3 Enter Exit programming mode You will hear two short beeps The keypad is now ready and the relay can be pulsed with the User Code ZZZZ The yellow signal light starts blinking as soon as the keypad is ready for use When monitoring is switched on the red signal light blinks for 30 seconds after which it will stop blinking and remain on The red light is off in disable mode and only the yellow light blinks Wiring Consult the separate HouseControl wiring diagram Installation and Programming of SK 983A HC Security Keypad HouseControl M and L models 154E 11 003 AC 17 2 20062. Installation and Programming of SK 983A HC Security Keypad HouseControl M and L models NORMAL DISABLE MODE Connect the wires from the relay A to input IN1 in HouseControl Adjust the input settings as described in the TeleControl User s Manual B TAMPER CIRCUIT 11 13 1 1 30 x ry x j Connect the tamper circuit wiring B to input IN5 in HouseControl olola Wiring diagram for the signal lights can be found from the separate installation sheet Task Explanation 1 Enter 0000 Enter programming mode using the factory set Master Code You will hear two short beeps If you have used DAP jumper to override the Master Code you can skip this step and go directly to step 2 2 Enter Oxxxx Set new personal Master Code The leading zero indicates that the Master Code is changed You will hear two short beeps x any number 3 Enter Tyyyy Set the new User Code that will be used for switching HouseControl to normal or disable You will hear two short beeps mode Number one at the beginning refers to the User Code y any number 4 Enter 401 Set the relay output to momentary mode with one second output The relay releases or pulls You will hear two short beeps when the User Code is entered 5 Enter 70 Set the keypad to lock itself for 30 seconds after 10 consecutive incorrect code entries You will hear two short beeps 6
Download Pdf Manuals
Related Search