2100 SERIES/GEMINI USER`S MANUAL VER. 1.2 Module
Contents
1. 2100 SERIES GEMINI USER S MANUAL VER 1 2 Module Installation amp Contact Removal Instructions Section 1 Twin Access Contact TAC Receiver Twin Access Contacts TAC Module Contact Removal Insructions P N 510 133 101 102 103 104 105 106 Receiver Signal TAC P N 510 133 103 104 107 108 Receiver Coaxial TAC 50 OHM P N 510 133 105 106 Receiver Coaxial TAC 75 OHM P N 510 133 103 104 107 108 Receiver Power TAC CAUTION PARTS TOOLS REQUIRED ae 5 64 Allen Hex Wrench AN DO NOT depress contacts with fingers Phillips Head Screwdriver 510133103 INSTRUCTIONS T Receiver RECEIVER TAC MODULE j jii To insert Contact into Module j l remove the contact retaining n plate from the bottom of the STOP RING OF PIN ALWAYS module by unfastening the 2 TOWARD RETAINING Flat Head Phillips Screws iii i Insert contacts into the rear of the U module with the stop ring of the 510122101 B10188101 61013510 contact facing the back of the Z CONTACT RETAINING module The contacts will i PLATE automatically drop into align A ment Replace the contact retaining plate and secure with two 2 Flat l D COMPLETED TAC MODULE Head Phillips Screws NOTE The contact retaining plate U U must be removed prior to the extraction of the contacts To remove the contact retaining plate unfasten the 2 Flat Head Phillips Screws2. and remove the contact retaining plate The contacts are then easily extracted by hand N wo gt TAC Receiver Module Installation Removal 1 To install a module into the Receiver place the supplied hardware 4 socket head cap screws in the TAC Receiver Module 2 Place the Module in the front of the Receiver aligning the locating pins on the module with the appropriate holes in the Receiver Frame so that the upper and lower module screws touch the mating holes on the Receiver Frame install modules such that the numbers can be read from top to bottom making them right side up 3 Using a 5 64 Allen Hex Wrench tighten the top screw 1 to 2 full revolutions while lightly applying pressure against the face of the module 4 Maintain this pressure while tightening the bottom screw 1 to 2 full revolutions 5 Repeat this sequence in order until the module is seated 6 As the module is being seated watch to ensure that it does not become cocked at any time as a result of the guide pins not being properly aligned with the receiver or binding of the pins due to one screw being advanced ahead of the other more than 1 to 2 turns If this should occur back the screws off until the module is level an
3. d repeat the tightening process Torque the screw until it is 4 to 5 inch pounds 7 To remove unfasten using a 5 64 Allen Hex Wrench on the top and bottom screws VM2100_V1 2 pmd www vpc com Virginia Panel Corporation
Download Pdf Manuals
Related Search