Bullard POWERHOUSETM Charging Station Free
Contents
1. Bullard Bullard 1898 Safety Way Cynthiana KY 41031 9303 Toll free 877 BULLARD 285 5273 Tel 859 234 6616 Fax 859 234 8987 www bullard com Bullard POWERHOUSE Charging Station Free Standing Adapter Kit User Manual This addendum contains instructions for converting the POWERHOUSE Charging Station into a free standing unit IEY NOTE Although the Powerhouse is designed for permanent vehicle installation Bullard also provides this adapter kit for unattached free standing use As a free standing unit the Powerhouse cannot provide secure storage of the thermal imager and its spare battery in a vehicle in accordance with NFPA 1901 10 1 7 Free standing use is not recommended for vehicles The adapter kit includes a back cover panel rubber feet an AC power adapter and necessary wiring connectors 1 Attach Power Cord Attach the DC Power Cord to the tab at the lower end of the Back Plate Figure 1 Figure 1 2 Reattach the Back Plate to the Powerhouse housing Place the latch spring provided with the Powerhouse unit firmly onto the protruding spring seat on the back of the latch near the top of the Powerhouse unit Set the unit in place on the back plate making sure that the free end of the latch spring seats into the milled recess in the back plate and that the free end of the DC Power Cord extends toward the circuit board The Powerhouse unit is a snug fit on the back plate and it may be necessar2. 2007 Bullard All rights reserved Bullard is a registered trademark of Bullard Powerhouse is a trademark of Bullard 6050046923 1007
3. y to spread the sides slightly as you set it into place Once in place secure the unit to the back plate using the four 4 stainless steel 10 32 Phillips Head screws provided 3 Connect Power Cord to Powerhouse Circuit Plug the connector on the free end of the DC Power Cord into the mating connector on the battery charger circuit board see Figure 4 of the Powerhouse Users Manual 4 Attach the Cover Plate Insert each screw into one of the four 4 rubber feet provided Place the cover plate in place on the back of the Powerhouse assembly and secure it in place with the four screws and rubber feet Tighten the feet finger tight if necessary gently tighten with a Phillips screwdriver Do not overtighten Figure 2 Bullard GmbH Lilienthalstrasse 12 53424 Remagen Germany phone 49 2642 999980 fax 49 2642 9999829 www bullardextrem com Cisco Centre 20 Jalan Afifi 08 03 Singapore 409179 Tel 65 6745 0556 Fax 65 6745 5176 www bullard com Bullard Asia Pacific Pte Ltd Figure 2 5 Attach AC DC Power Supply Insert the DC plug of the Power Supply into the rectangular opening in the cover plate and plug it into the receptacle attached to the Powerhouse unit Figure 3 h Figure 3 Place the finished assembly on its feet on a flat surface Plug the power supply into a 110 volt AC receptacle and operate the unit as described in the Powerhouse User Manual ISO 9001 certified
Download Pdf Manuals
Related Search