USER MANUAL - Crem International
Contents
1. 174mm 410mm 233mm 244mm DIMENSION SKETCH TOWER Single Tower 934 610 500mm 174mm 410 233mm 244 DIMENSION SKETCH TOWER B gt lt gt A A j D i b _ Y Y Y Serving Station 483mm 373mm 325mm 449mm 110mm For the warranty to be valid the conditions for maintenance must have been followed according to our instructions proper precaution has been made and warranty claim been issued without delay The affected equipment may not be used during awaiting service if there is any risk that the damage or defect would worsen The warranty will not cover consumption supplies such as glassware normal maintenance such as cleaning of filters contaminations in water lime incorrect voltages pressure or adjustment of water amounts The warranty will not cover damages of defects caused by incorrect handling and operation of the appliance FOR SERVICE Please contact your dealer Your Dealer crem INTERNATIONAL www creminternational com2. To keep temperature and aroma put the lid A back on the serving station immediately after the brewing A IMPORTANT The temperature in the serving station will decrease with 1 5 C h There is 40ml of coffee standing in the tubes from the inner container to the coffee faucet This part is not insulated and will drop in temperature much faster If the serving station haven t been used in Ih the first cup can be lower in temperature Cups after the first will not be affected of this Do not change the recommended portion of coffee Do not mix freshly brewed coffee with old coffee Always rinse the serving station before next brew Empty the filter holder from filter and coffee grounds directly after a brew Dispense 50ml of coffee every hour to always have fresh and hot coffee to the faucet CLEANING AND CARE TOWER The filter holder To keep the serving stations clean It is effective to start a half brew with and serving station water only should be cleaned This will disolve the coffee remains every Empty the serving station by opening the tap and this will also be cleaned Rinse the serving Repeat this every day station before each Disassemble the level tube and clean it every week with the enclosed brush new brewing A IMPORTANT Disassemble the level tube and clean it every Rinse the serving week with the enclosed brush station on the inside Turn off the bigger lid
3. 1 Confirm the new settings by pressing the 10 2 left button once 15 3 20 4 25 5 For right side Press right buttons and Q at the same time for 5 seconds until you hear 3 beeps the display shows the current setting Adjust with the right buttons increase and decrease Confirm the new settings by pressing the right Q button once MESSAGE SHOWN ON DISPLAY TOWER Error message Display shows E2 E4 A IMPORTANTI LEVEL CONTROL All maintenance and installations must be done of an authorized technician shown on the displav The water high level sensor is triggerd before the low level sensor Clean the level sensor Change the level sensor Cables connected is incorrectly shown on the display Filling time too long Poor water pressure Water tap is not open Restart machine TEMPERATURE CO TROL shown on the display Temperature sensor out of range Temperature sensor is broken Cable loose 5 C 105 C Change temp sensor Connect cable shown on the display Heating time is too long Solid state broken Element broken High limit control defect Restart machine Change solid state Change heating element DIMENSION SKETCH TOWER Tower 934mm 928mm 500mm
4. Trav Adjustable Foot BUTTONS AND DISPLAY INFORMATION TOWER 1 1 Brewing 1 1 Brewing Full brew 5 0L Full brew 5 0L 1 2 Brewing 1 2 Brewing Half brew 2 5L Half brew 2 5L Pause Stop Pause Stop When machine is in use and filling water display shows When machine is filling up and heating water displav is blinking When water has reach right temperature displav will light up EB with steady light While machine is brewing While machine is brewing Full brew Half brew f Displav shows see A Displav shows see B INSTALLATION AND START UP TOWER MIN 10cm Adjustable feets Place the brewer unit on a flat horizontal surface that will support the weight of the machine Make sure that air is able to circulate behind the machine minimum 1 Bottom Side Connect the supplied water hose to the cold water connection using R connection When pushing the machine into position make sure there is no interference to the hose to ensure proper water flow Water supply to the machine is the customer s responsibility according to instruction and advice from the supplier In areas with high level lime problem a descaling filter should be mounted The new hose set supplied with the appliance shall be used and that old hose sets shall not be reused Connect
5. and clean the mixer several times with tube A fresh tap water Cleaning of serving station 5L Fill the serving station with hot water Full brewing without coffee and filter B Put 2 tablespoons with cleaning powder in the serving station and wait at least 15 minutes Tap off 2 3 of the cleaning solution Clean the serving station with the following cleaning brush B Rinse the serving station with fresh tap water sereral times before a new brew _ CLEANING PARTS 110102 02 Cleaning powder 1104231 Cleaning brush OPTIONS Cleaning brush for level tube 1103360 I mixer tube To clean the exterior of the machine use a soft rag with liquid cleaning agent to prevent scratches PROGRAMMING TOWER Press left buttons and at the same time for 5 seconds until you hear beep Display shows the present setting A Adjust with the left buttons increase water temp and decrease water temp Confirm the new settings by pressing the left button once 70 C min temperature 96 C max temperature TADJUST SIGNAL For tett side Off 6 2596 5 Press left buttons and at the 20 4 same time for 5 seconds until you hear 3 15 3 beeps the display shows the current setting 10 2 Adjust with the left buttons 5 increase and decrease 0 0 5
6. the technical data for the machine responsible for their safety Children should be supervised to ensure they do not play with the appliance Do not use the machine outdoors so it can be Place the machine out of the reach of children exposed to weather rain snow frost It will m Position the mains cable so that people cannot cause material damage to the machine trip over it Keep it away from sharp edges and Do not to open the machine or repair it in heat sources any way avoid danger only have the machine The new hose sets supplied with this appliance repaired in a technical workshop Service are to be used old hose sets must not be re Centre or by a qualified person used Remove the mains cable from the socket when m This appliance is not suitable for installation in the machine is not in use for longer periods To an area where a water jet could be used do this pull the plug not the cable This appliance must not be cleaned by a water This appliance must be placed a horizontal jet position which is resistant to any water that may leak a This appliance is intended to be used in For the optimal performance of the machine household and similar applications such as these parameters shall not be exceeded Staff kitchen areas in shops Maximum permissible inlet water pressure Offices and other commercial working 800KPa 8Bar environments Minimum permissible inlet water pressure On agricu
7. USER MANUAL Part No 1704519_02 CONTENT TOWER CONTENT kasir snien tkis na ONE rt 2 GIE 4 Introduction Warnings Precautions intended ise i a A e a a sa 4 Facts amp weight General functional description OVERVIEVV OF COMPONENTS 6 TOWER atus 6 SINGLE TOWER 7 BUTTONS ANE DISPLAT INFORMATION tirsisti de 8 B tton functions asns a a a tawka da iB 8 Display indications When brewin ssssscessccsscssssosesnssseseensossseonssssanechscsasenswssdesshigonisgsoseonictesganocivecesesensstaseahiethcetneesabia 8 INSTALLATION AND START UP Positioning Water COMMECHON scassessrsescsssesscscicssscassscsnsecsanssnsnsssseaiaannstssssscansostnnsiccnsesnsansseyssacsseedueacanianansoactaiasbussassassstaacasansesniacive 9 Electrical connection and 10 O O E Brewing a H Filter positioning Add coffee Filter holder and serving station positioning Start Dispensing hot water To keep temperature and aroma CLEANINGAND GARE bata 14 Cleaning Cleaning serving station Exterior cleaning when necessarv sresennzsanzannzznnznnnnzananzanznnnennanznnenanznnzztnentaznznznnnnatanannagz
8. annanaztannnnznnaznanzta 14 PROGRAMMING Adjusting water temperature Adjusting water quantitv CONTENT TOWER Single TOWER 18 Serving a sam a 19 Some important information mav appear in textboxes seen below caution More INFO INFO INFO INFO GENERAL TOWER Thank vou for choosing a TOWER coffee brewer We hope you enjoy it 1 Read the user guide before using the machine Always keep this guide close at hand for future This guide contains important instructions for reference proper and safe use of the vending machine a Never immerse the machine plug or mains Do not use the machine if the mains cable plug cable in water because there is a danger of is damaged or the machine has fallen down electric shock If the mains cable is damaged it must be The appliance is not intended for use by replaced by the manufacturer service agent or persons including children with reduced similarly qualified persons in order to avoid a physical sensory or mental capabilities or hazard lack of experience and knowledge unless they Only plug the machine into a properly installed have been given supervision or instruction earthed safety socket whose line voltage concerning the use of the appliance by a person matches
9. ion to a closable valve is recommended Min water pressure 2bar 200kPa Max water pressure 8bar 800kPa 91 INSTALLATION AND START UP TOWER The brewer is not reconnectable and may only be installed to the electric supply network with a voltage that is stated on the brewer and shall be carried out by an authorized electrician Recommended install a line circuit breaker and a earth fault breaker to the machine CAUTIONI Connect to a separate 3 phase onlv Brewer should be connected to 400V with Zero and earth Use 16 Amp fuses A IMPORTANTI Electrical installations must be done of an certificated electrician 400V 3N 9000W 50 60Hz Turn on the power switch B machine will start filling with water While machine is heating up display is blinking Once the water has reached the correct temperature the display will stop blinking and show a steady light A approx 17 minutes Machine is now ready to use OPERATION TOWER Brewing with coffee Place a filter in the filter holder Alwavs use Coffee Queen s recommended coffee filter paper Part No 110102 Recommended powder amount is 609 1 Add coffee restaurant catering ground coffee Make sure that the coffee is evenly spread Slide the filter holder into position A Loosen upper lid B on the serving station and then p
10. lace the serving station C Make sure that the serving station is centered with the rotation plate OPERATION TOWER Brewing with coffee Push for 5L push button for 2 5L 1 1 Full brew display is blinking between all 3 lines 1 2 Half brew displav is blinking between lower 2 lines STOP PAUSE button A Press the button once for pause CAUTION Do not remove To continue the brewing if it is in pause mode press serving station before displav is lit Press the button twice to stop brewing with a steady light and the ready beep When brewing is completed 3 second beep will be heard from the has been heard it machine display will be lit with a steady light can cause serious It is now safe to remove the serving station spill and burns On front of the brewer unit there is tap for serving hot water lt is possible to dispense hot water while the machine is brewing coffee A NOTE You can as a maximum dispense 2 pitchers 1 8L each of hot water while brewing coffee Tap for hot water OPERATION Brewing with coffee Tips for keeping coffee hot Pre heat the serving station start a brewing with only water into the serving station When brewing is complete let it stand for about hour Pour out the water Then start a brew with coffee TOWER
11. ltural estates 200KPa 2Bar By clients in hotels motels and other Maximum working temperature 40 C residential type environments Minimum working temperature 10 C Bed and breakfast type environments GENERAL Facts amp weight Hot water tap Yes Yes Electronic temperature control Yes Yes Height Width Depth 934 928 500mm 934 610 500mm Tank volume 25L 25L Power supply 400V 3N 9000W 50 60Hz Cold water connection External thread Capacity 350 cups hour 175 cups hour Serving station 2x5L Ix5L TOWER 53 kg SINGLE TOWER 41 kg TOWER bulk brewer Coffee brewer with automatic water supply Equipped with a separate tap for hot water Brewing in a removable serving station Brewing in paper filters Brew time for 5L approx 7min SINGLE TOWER 2x5L approx 7min TOWER OVERVIEW OF COMPONENTS TOWER Power Switch Display Function Buttons Filter Holder Serving Station Lid Carry Handle Serving Station Level Tube Tap for Coffee Drip Tray Insert Drip Tray Adjustable Foot Tap for Hot Water OVERVIEW OF COMPONENTS Displav Function Buttons Tap for Hot Water TOWER Power Switch Filter Holder Serving Station Lid Carrv Handle Serving Station Level Tube Tap for Coffee Drip Trav Insert Drip
Download Pdf Manuals
Related Search