User`s Manual
Contents
1. Back Wrap 580500 Back Wrap Application Note For maximum cooling place the Wrap against the horse s bare back unless there is a wound In the case of a wound cover with a bandage before applying the Wrap Step 1 Place the Wrap on the horse s back aligning the hose connection on top of the horse s withers similar to the positioning of a pommel or saddle horn Draw the front strap from the far side of the horse under his belly clipping to the nearside front buckle Step 2 Adjust the tautness by shortening the nylon strap through the sliding buckles on both near and far sides Strap should be snug to the horse s belly but not as tight as a girth Follow the Same protocol for the rear strap carefully monitoring your horse s reaction Do not proceed furthe until your horse appears calm and relaxed Step 3 Clip the upper Breastplate Straps into either side of the Back Wrap at the horse s shoulders Pass the bottom Breastplate Strap through the horse s front legs and clip to the Front Girth Strap Adjust the tautness by shortening the nylon straps at all points Step 4 Use the lacing along the spine of the Back Wrap to customize its shape for optimal fit and contact For best contact adjust each side of the Back Wrap to cover the horse s spine The right and left sides of the Wrap may overlap slightly but should not be folded over onto themselves Step 5 Clip the split end of the Y Connector to each of the two Heat Exchanger Conn2. After assembly fold at the natural horizontal fold and make sure the Wrap is flat and smooth 702073 REV C G Game Rea a Ne gt Se ee Back Wrap 580500 Back Sleeve 540500 Right Back Heat Exchanger 560502 Left Back Heat Exchanger 560504 Y Connector 570316 Breastplate Strap gt s3 lt Back Girth Strap Front Girth Strap IMPORTANT SAFETY INFORMATION Always consult with your veterinarian before using the Game Ready Equine System for an Injury During treatment the horse must be accompanied by an attendant Do not place the Wrap directly against open wounds sores rashes infections or stitches First place a sterile dressing on the wound and then apply the Wrap Do not store in a closed plastic bag after use as this may promote mold growth Do not puncture the Wrap doing so will void the Game Ready Equine warranty Initial applications of the Back Wrap may cause some horses mild concern at the new sensation Carefully monitor your horse s reactions throughout each step of the process and proceed only when your horse appears calm and relaxed It is recommended that the highest level of pressure is Medium Pressure _ pn_ for this Wrap If the pressure appears uncomfortable pause the Unit and restart with no pressure CoolSystems Inc 1201 Marina Village Pkwy Suite 200 Alameda CA 94501 1 888 GAMEREADY Wwww gamereadyequine com dy 2008 ee gt 2 oe ee De Equine
3. JA cE NRC DA Back Wrap 580500 Equine Back Wrap Sleeve 2 Heat Exchangers Y Connector Your Equine Back Wrap has been packaged with each of the two removable Heat Exchangers already inserted into the Sleeve Before you remove the Heat Exchangers for cleaning take care to note their assembly in the Sleeve The Y Connector is bagged separately Fig 1 Back Wrap Heat Exchanger Removal 1 Disconnect the Y Connector from the Heat Exchangers 2 Place the Sleeve on a flat surface with the logo side down Fold back the flaps along the center of each side of the sleeve to open the zippers Gently pull out each Heat es Exchanger from each side of Sleeve bottom view 2 Heat Exchangers the Wrap Fig 2 Back Wrap Heat Exchanger Insertion 1 Place the Sleeve on a flat surface with the logo side down Fold back the flaps along the center of each side of the sleeve to open the zippers Insert each of the two Heat Exchangers into the corresponding side of the Wrap with the black side facing down slide each Heat Exchanger Connector though the corresponding opening in the Sleeve The part of the Sleeve which you have folded over to open the zipper should be pulled over the top of the Heat Exchanger to close the zipper The green side of the Heat Exchanger should touch the green side of the Sleeve Connector Bottom view of Back Wrap Important Make sure the Heat Exchanger is flat inside the Sleeve with no folds or creases
4. d mild detergent or antibacterial soap Hang to dry Hand wash the Heat Exchanger do not machine wash doing so will void the warranty Periodically run hydrogen peroxide through your Game Ready Equine System to keep the interior water chamber of your Wrap clean See Control Unit User s Manual for more detail Cold sterilization only Storage Store the Back Wrap laying flat with green sides out or hang Do not bend lengthwise Warranty Information Sleeve In case of manufacturer defect Sleeve may be returned within 7 days of purchase Heat Exchanger amp Y Connector 1 year from date of purchase See warranty card included
5. ectors Clip the single end of the Y Connector to the Single Hose Connector Clip the Single Hose Connector to the Control Unit Begin initial treatment with no pressure In order to acclimate the horse to the sensation of the Back Wrap If after several minutes there are no signs of aversion from the horse begin administering cold therapy at low pressure Advance to medium pressure only when your horse appears comfortable and relaxed Medium pressure should be the highest setting used for the Back Wrap as the product performs optimally at this setting Caution First application of this Wrap may cause horses to startle preliminarily at the new sensation Proceed with administering therapy with caution Do not open the zipper on the Wrap while the Wrap Is in use or while being applied to the horse Protocol 30 40 minute application on low medium or no pressure Always consult your veterinarian before using the Game Ready Equine System on any injury eS Ne gt 2 ee A Back Wrap 580500 Equine Note Y Connector Run the Connector Hose through the Strap to fix the Connector in place Do not allow the Hose to bend the Wrap at the connection This can restrict water flow and affect cooling After treatment disconnect the Hose from the Wrap first before removal of the Wrap from the horse Connector Hose Control Unit Care Gently remove the Heat Exchangers from the Sleeve Hand wash the Sleeve in cold water an
Download Pdf Manuals
Related Search