Mirage Instructions - Draft
Contents
1. N position for heater to operate with or without heat Switch 2 Turns the heat ON OFF Thermostat T see Fig 2 In order to maintain a certain room temperature set the controller to max Operate the appliance at full power until the required room temperature is reached Set back the thermostatic controller until the appliance switches off with an audible click This temperature will be kept almost constant by the thermostatic control switching on and off automatically Please note that the appliance can only be switched on when the thermostat setiing is higher then the room temperature Thermal Safety Cut out A thermal safety cut out is incorporated in the heater to prevent damage due to overheating This can happen if the heat outlet was restricted in any way The heater will switch on once the obstruction has been removed and the heater has cooled If the cut out continues to operate intermittently the heater should be switched off and a service agent contacted Maintenance WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE Lamp Replacement see Fig 3 Fig 4 and Fig 5 The lamps are located behind the back panel To gain access to the lamps the screws indicated in Fig 3 which secure the back panel must be removed Remove and slide out panel as indicated on Fig 4 Remove the defective lamp by unscrewing it as shown in Fig 5 Replace with a 60W E14 SES Clear candle lamp Take ca2. XxX Dimplex A world of expertise Contact Details Please note that some of the contact details on this PDF document may not be current Please use the following details if you need to contact us Telephone 0844 879 3588 Email customer services gdcgroup co uk The customer support section of our website also features a wide range of information which may be of use to you and is available 24 hours a day It includes e Operating and installation instructions e Easy How to use guides for storage heaters e Service and repairs e Where to buy our products e Literature downloads e Heating requirement calculator Visit www dimplex co uk support A division of GDC Group Ltd Registered No 1313016 England Millbrook House Grange Drive Hedge End Southampton S030 2DF Sa RE on ni i roaucer registration Number www dimplex co uk WEE GEOOSITS Paper from sustainable sources SCDimplex CDW15CW 8 CDW15CO Chadwick Suites 08 50213 0 UK Issue 0 C The product complies with the European Safety Standards EN60335 2 30 and the European Standard Electromagnetic Compatibility EMC EN55014 EN60555 2 and EN60555 3 which cover the essential requirements of EEC Directives 73 23 and 89 336 CDW15CW 8 CDW15CO Chadwick Suites Model No s CDW15WW CDW15WO CDW15CW 8 CDW15CO IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Important Safety Adv
3. ice When using electrical appliances basic precautions should always be followed to reduce the risk of fire electrical shock and injury to persons including the following If the appliance is damaged check with the supplier before installation and operation Do not use outdoors Do not use in the immediate surroundings of a bath shower or swimming pool Do not locate the heater immediately below a fixed socket outlet or connection box This appliance is not intended for use by children or other persons without assistance or supervision if their physical sensory or mental capabilities prevent them from using it safely Children should be supervised to ensure that they do not play with the appliance Do not use this heater in series with a thermal control a program controller a timer or any other device that switches on the heat automatically since a fire risk exists when the heater is accidentally covered or displaced Ensure that furniture curtains or other combustible material are positioned no closer than 1 metre from the heater In the event of a fault unplug the heater Unplug the heater when not required for long periods Although this heater complies with safety standards we do not recommend its use on deep pile carpets or on long hair type of rugs The appliance must be positioned so that the plug is accessible If the supply cord is damaged it must be replaced by the manufacturer or service agent or a s
4. imilarly qualified person in order to avoid a hazard Keep the supply cord away from the front of the heater WARNING In order to avoid overheating do not cover the heater Do not place material or garments on the heater or obstruct the air circulation around the heater General Unpack the heater carefully and retain the packaging for possible future use in the event of moving or returning the fire to your supplier The fire incorporates a flame effect which can be used with or without heating so that the comforting effect may be enjoyed at any time of the year Using the flame effect on its own only requires little electricity These models are designed to be free standing and are normally positioned against a wall Before conneciing the heater check that the supply voltage is the same as that stated on the heater Please note Used in an environment where background noise is very low it may be possible to hear a sound which is related to the operation of the flame effect This is normal and should not be a cause for concern Electrical connection WARNING THIS APPLIANCE MUST BE EARTHED This heater must be used on an AC supply only and the voltage marked on the heater must correspond to the supply voltage Before switching on please read the safety warnings and operating instructions Controls see Fig 2 Switch 1 Controls the electricity supply to the heater and flame efiect Note This switch must be in the O
5. lt at the time of your call The customer services help desk will also be able to advise you should you need to purchase any spares Please do not return a faulty product to us in the first instance as this may result in loss or damage and delay in providing you with a satisfactory service Please retain your receipt as proof of purchase Glen Dimplex UK Limited Millbrook House Grange Drive Hedge End Southampton Hampshire SO30 2DF c Glen Dimplex UK Limited Customer Services Republic of Ireland UK customer help line 8 00am 5 00pm Mon Fri and 8 30am 1 00pm Sat Autumn Winter only Tel 0845 600 5111 Fax 01489 773053 e mail customer services glendimplex com Tel 01 8424833 All rights reserved Material contained in this publication may not be reproduced in whole or in part without prior permission in writing of Glen Dimplex UK Limited
6. re not to over tighten the lamp Refit the back panel and secure with the screws Cleaning WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER For general cleaning use a soft clean duster never use abrasive cleaners The glass viewing screen should be cleaned carefully with a soft cloth DO NOT use proprietary glass cleaners To remove any accumulation of dust or fluff the soft brush attachment of a vacuum cleaner should occasionally be used to clean the outlet grille of the fan heater Recycling For electrical products sold within the European Community At the end of the electrical products useful life it should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice in your country After Sales Service Your product is guaranteed for one year from the date of purchase Within this period we undertake to repair or exchange this product free of charge excluding lamps amp subject to availability provided it has been installed and operated in accordance with these instructions Your rights under this guarantee are additional to your statutory rights which in turn are not affected by this guarantee Should you require after sales service you should contact our customer services help desk on 0845 600 5111 It would assist us if you can quote the model number series date of purchase and nature of the fau
Download Pdf Manuals
Related Search