e-stop systems quick start guide - In
Contents
1. lights must be on e Check that all black receptacles have something plugged into them correctly VERY IMPORTANT After E Stop Has Been Pressed 1 TURN OFF ALL IPM MACHINES AND CONNECTED DEVICES 2 Restart E Stop as per above 3 Restart connected devices as normal 4 DO NOT USE AS AN ON OFF SWITCH 5 Test at the start of each job IN PLACE User manual is located in the accessory bag of the unit co CONFIDENTIAL Copyright 2012 In Place Machining Company Version 1 2 08 27 20122. E STOP SYSTEMS ED Power In z I CDANGER O WAE O Connects to power source 110v 240v Single Phase 20 AMP Max if needed Customer s ELECTRICIAN connects 3 phase power here 100 AMPs Max UNIT MUST HAVE 3 PHASE POWER TO WORK Unit can be configured 240v 380v 480v 575v a black receptacles must be filled with dummy plug or daisy chain F Dummy _ plug or daisy chain if equipped a J E Stop buttons or accessories Do not need all white receptacles filled CONFIDENTIAL Copyright 2012 In Place Machining Company Customer s ELECTRICIAN connects to IPM load here Connect 110v 240v IPM machines load here Don t force connectors NOTCH ALWAYS UP Notch always up Align notch and slide in Dummy plugs are kept in pouch in yellow bag IN PLACE MACHINING COMPANY Version 1 2 08 27 2012 E STOP SYSTEMS O E Stop Start Up Procedure SINGLE UNIT Ep on Red Light On Red Light On Push Start D Pull Emergency Buttons Out Green Light On B Push Green Start Light 3 Verify Amber Light is On Amber Light Turns On If using multi unit daisy chain verify all steps are completed on each unit Amber lights go on when all green buttons are pushed in the daisy chain scenario Troubleshooting if E Stop doesn t start e Check that all STOP buttons are pulled out red
Download Pdf Manuals
Related Search