Trimpro Rotor XL Users Instructions PDF
Contents
1. Tightening screw dimmer switch Allen key 5 32 LOWER AND RAISE THE BLADE 1 Remove the 4 set screws located in the 2 holes on the side of the aluminum hub where the blade is fixed see drawing 2 Remove the blade and the hub in one piece from the motor shaft In order to facilitate the trimming spray vegetable oil and clean the grate and blades frequently with 3 Clean the blade with alcohol soap or isopropyl alcohol This must be done when the machine is not running Sharpen the blade 4 Use a grindstone when necessary To sharpen them never remove the blades from the hub even for sharpening 5 Put a gentle pressure with the bottom of the blade on the grindstone with the sharpening angle desired 6 Pass the blade on the grindstone with a movement from left to right and from right to left until the blade is properly sharpened 7 Put back the blade and the aluminum hub on the motor shaft 8 Put back in position the 4 set screws in the 2 holes on the side of the aluminum hub2. WARNING WHEN THE MACHINE IS RUNNING e Never put your fingers gloves or any other body part in contact with the grate the blade and or h i USER INSTRUCTIONS TEA pressure on the grate THE TRIMPRO ROTOR XL IS DESIGNED TO BE USED WITH FRESHLY HARVESTED PLANTS DO not use scissors knives or any instrument above the grate e Safety glasses and gloves are required at all times USER INSTRUCTIONS e Gloves have to be tight enough so they can t get inside the grate slots A loose glove is dangerous beware To be used in accordance with all applicable laws and regulations The manufacturer does not accept any responsibility for damages caused to or by the TRIMPRO ROTOR XL which is the result of improper use or assembly ADJUSTMENT OF THE BLADE HEIGHT To adjust the height of the blades follow these steps 1 Remove both A screws blocking screw then both B screws tightening screw See drawing 2 Turn the C screw height adjustment screw To raise the blades turn clockwise To lower the Carefully read the security instructions see Warnings before using the machine Plug the machine into an electrical outlet Turn on bottom blade motor by side mounted dimmer switch and adjust to desired speed Segregate freshly harvested flowers into similar sizes Lift cover and add several handfuls of flowers to upper container Quantities will vary according to flower type Close the cover turn on the upper mot
3. or and adjust to desired speed Let the plants move around in the machine for 1 to 3 minutes or until desired cut is obtained blades turn counterclockwise Open the exit door and keep it open until the upper container is empty Increasing the rotation speed may facilitate emptying the container 3 Apply pressure on the blades to ensure it is well located Frequently remove the accumulation of plants under the machine The accumulation should never reach the motor in order notto 4 Put both B screws back obstruct the motor ventilation 0 28 ON ON S a NS a 5 Verify if the height of the blade is OK by closing the grate If not return to step 1 10 Turn off the machine 6 To finish put both A screws back 11 Unplug the machine from the electrical outlet Note If the top motor has to be stopped DO NOT USE YOUR HANDS as this may burn the motor Turn off the motor using the OFF switch instead A For security reasons we recommend to keep a distance of at least 1 8 of an inch 3mm between the Lift cover te and the blade Carefully read Ps dd owas grate and the blade the security instructions A OK xe Segregate B fresh flowers Tightening screw 3 Allen key 5 32 A Blocking screw Allen key 5 32 ADJUSTMENT SCREWS Allen key 3 16 Bottom motor C Height adjustment screw dimmer switch i Ss 9 is 5 Blocking screw 2 o Upper motor oI Allen key 5 32 SIN B
Download Pdf Manuals
Related Search