ZZQ8B repeater user manual
Contents
1. ZZQ8 New Repeater User Manual Summary This is a TX RX repeater which repeats the wireless RF signal when the distance is not enough Put the repeater between the transmitter and receiver They should meet the items as below 1 The frequency of transmitter and repeater should be same 2 Oscillating resistor should be matched with repeater 3 Set repeater number while multiple repeaters are used together 4 This repeater supports PT2240 1 5M IC OSC learning code trans mission protocol it can pair up to 100pcs transmitters Il Technical data Working frequency 315 433 92MHz working voltage DC12V Standby current 30mA Working current lt 255mA Receiving sensitivity 108dBm Transmitting power 500mW transmitting distance is about 1500m in the open area lll Diagram Power supply j Power LED Send LED Function DIP switch 12345678 bee Testing Pairing Repeat mode Number of Transmit time repeater Delete POWER power indiction SEND Repeating indication it will be on while transmitting signal DIP switch 1 3 define the number of repeater from 0 6 While only need 1 repeater in the area put the number as 0 If need 2 or more repeater in the area should define the number of repeater like 1 2 3 4 5 6 When use over 1 repeater the response time will be longer FFA HA 2A A Aa Ee 4 delete the paired transmitter available when the repeater works in on status of g2. ang 6 5 transmit time adjust Off 6 sec On 12 sec If the repeater is 0 the transmit time is immediately 6 when it is off all the transmitter can be repeated if it is on it only repeats the one which is paired 7 Push to ON position to pair the transmitter After pairing push back OFF position the gang 6 should be on 8 for testing IV Operation 1 Install antenna Please install the 2 antennas to the device when first time use No order 2 Deploy repeater Please put the device in the middle between transmitter and receiver and adjust well the distance according the signal of transmitter When it is ready please also adjust the receiver is I i Transmitter Repeater Receiver Repeater working diagram 3 Set working mode Connect to DV12V power supply the POWER indicator LED will be on the repeater goes into working status Adjust the DIP switch to select transmitting signal 4 Set the DIP switch code for different application Common function Repeat all the transmitters While there is only one repeater used Set the code like this Then all the transmitter has same frequency can use this repeater to send the gignal again 12345678 Repeat the paired transmitters In this status the repeater only repeat the transmitter which is paired When pair transmitter switch 7 ON And press the transmitter button After pairing is finished switch it off T When dele
3. te paired transmitter switch 4 ts ON press the transmitter then the one will be deleted No 2 L AT No 3 LECCE 12345 8 12345678 ry The ie No 4 No 5 bl No 5 E nnu 12345678 12345678 12345678 Note if there are only 1 to 3 repeaters used Push the 5 gang as OFF position If there are 4 to 6 repeaters used Push the 5 gang as ON position Multiple repeaters No 1 V Notice 1 Install the antenna to upwards and do not put it near the metal things and wall 2 This device is not waterproof 3 If receiver cannot receive signal please adjust distance between repeater and transmitter up to the repeater can receive the signal from transmitter and then adjust the receiver to the repeater 4 Power supply is DC12V output current is no less 300mA
Download Pdf Manuals
Related Search