User`s manual
Contents
1. User s manual TRIX RANGE SUMMARY AAA AA 2 gt IM EPE TT 3 Za o AA A Spey eese A Sk AA NAAA 5 A Vena A 6 S OOOO BA 7 oul O REA SZ A AAA 7 ero OWOCE O A 9 54 EM RENE 11 0 3 O O AA 2 ei Eu UU HE 13 6 1 ee AA L p DENNIS ecccececccncee 14 IESU ERIE 14 12 e HEEN 14 8 Em RENE 16 9 OOO RR 19 9 1 IU eec 19 9 2 BE Croce dec ccce 19 Mera xX 3 1 Introduction Congratulations for purchasing a DISAN central vacuum unit of Matrix range A combination of technology simplicity and well being The Matrix range is ideal compact practical and re ally powerful and available in two different models Matrix PT with disposable bags and Matrix FF with permanent flat cartridge and easy collection of the dust 2 Unpacking Follow the instruction printed on the cardboard box to move the central unit to the location selected for installation Arrange the cardboard box on the floor with the opening side upward and cut the adhesive tape Open the box remove internal cardboard and lift with both hands the central unit with the nylon bag Arrange it on the floor and remove the dust protection bag gt f Collect all the accessories in the box and dispose in accordance with the prescription MATRIK 2 2 1 Control ofthe accessories Check inside the box that all accessories are present Central unit Metal fixing plate Two rubber muffs F2. if so proceed to emptying the dust contai ner and check also the motor protection On Matrix FF check if the dust container drawer is full and the condition of the flat polyester filter 2 Safety protection The 10 Amp fuse blows if the vacuum motor is exposed to an overload by main power or if the motor is defected 3 Overheating If the motor becomes overheated due to a chocked filter or for a blockage in the piping the thermostat will switch the motor off when temperature is over 90 C It will restart when it is cooled down after about 8 10 minutes If after you have excluded that a stoppage somewhere between the motor and the handle has happened call the customer service 4 Flexible hose is blocked If suction at the inlet valve is correct but not on the handle the flexible hose could be stopped It has to be verified by sight by digit pressure or with a pro be MARX 5 Blockages in the pipes Contact the Disan customer service 6 Simultaneous use of several inlet valves the Matrix range is conceived to be used by a single person at the time 7 Inlet valve seal damaged or not well secured The air loss in connection with a whistling noise by a closed inlet valve is caused by a not perfect sealing or screwing of the inlet with pipes Check the tightness and if needed change the joints TROUBLESHOOTING CHART HERRERA Absence of Weak suction power Motorbreak The motor does not switch off Defective ru
3. the protection class IP55 and the moderate noise level the Matrix units can be installed even outdoor The minimal room for installation chamber is 70 x 60 cm Ixh 5 2 Inlet reversibility The Matrix unit is usually delivered with inlet connection assembled on the right side of the unit When necessary it is possible to switch the central unit form right to left by assembling the inlet on the left side Open the front cover with quick fix magnets 2 Loosen the 3 screws from inside and remove the inlet muff 3 In the opposite side unscrew in the same way the inlet cap J disais CD A Change the inlet muff with the inlet cap Paying attention to the right positioning of the joints MATK 6 7 5 3 Fixing the central unit Inside the packaging you will find the special installation template to easy the position and fixing as well as the installation wall plate D Schablone zur Montage siehe Montageanleitung M1 1 EA A Fe 1 Dima di fissaggio vedi manuale di montaggio M1 1 S an E Installation template view installation support M1 1 AZ Y F Marron d installation voir material de montage M1 1 A Zem OFF gt A B 3 4c u MARX wie 1 The template should be fixed on the H ma wall where the central unit should be E installed For reference the inlet and outlet should be considered _ 39 cm 20 cm 2 Mark the drilling point thro
4. an takes no responsibility for any harm or damage done due to misuse of the central 6 1 Use of accessories L 1 Place the suitable ends together Into the handle into the two chrome plated extensions or into the chrome plated telescopic wand 2 Lift the cover of the inlet valve and place the metal cuff or the vacuum hose AO an automatic inlet is being used the system will start when the inlet flap is opening vacuum Sb If using a semi automatic inlet the unit will start when the hose is inserted into the valve or when the switch is operated on the handle of flexible hose 4 In the event of excessive suction make use of the pressure regulation on the handle 5 When vacuuming is finished the unit can be switched off by removing the hose from the inlet valve and carefully closing the flap 7 Maintenance 7 1 Technical advice If during operation an irregularity is experienced that is not dealt with in following section maintenance of central unit please switch off the cleaner and get it inspected by a quali fied customer service No maintenance or repair work should be carried out on the central unit unless it is discon nected from the main power supply Disan recommend a general check of the electric motor bearings cables every 4 5 years 7 2 Ordinary maintenance All this operations have to be carried out on the central unit disconnected by the main power and when the cleaner and other p
5. arts are chilled form the surrounding temperature This maintenance is made to keep the cleaner working properly and to extend the lifetime of the Cleaner Emptying of dust container Modell Matrix PT 1 Open the front panel which is closed with quick fix magnets 2 Remove the disposable paper bag filter close it with the flap and waste in the proper trash 3 Clean the motor protection by shaking and knocking The cleaning of motor protection can be done also with cold water but before use pay attention this must be completely dry 4 Before inserting a new paper bag filter shake it until it takes the maximal volume Beware that rubber joints are in a good shape and they are in the proper place 5 Close the front panel O dean 11 Modell Matrix FF Open the front panel 1 and the internal panel 2 both with quick fix magnets 2 Slide out the dust container remove the funnel and waste the content in the proper trash 3 Clean the flat filter by shaking and knocking or even with cold water but make sure in the second option that this must be completely dry before to use it again 4 Close the front panel the cleaner is now ready to be used again MUT TACY T Lu UELUT TM UT Hit ANIMA Pp WA ill NA The device is now ready for use again 8 Troubleshooting Table page 17 1 If vacuum power at the inlet valve seems too weak the first investigation to do is On Matrix PT check if the paper bag filter is full
6. nning of the motor Voltage supply fells down 12 9 Guarantee 9 1 Terms of guarantee The guarantee conditions become valid from the date the system was first purchased Always refer to professional advice on installation and maintenance problems Any attempt by the customer or other persons to modify or repair the system with non original parts will automatically render the warranty void and the manufacturer will not be held responsible for any damage caused either to persons or their property The following relieves the manufacturer of any responsibility for warranty The manufacturer will replace under guarantee any parts that are found to be defective due Improper installation Improper use of the system or accessories Operating against the regulations of the respective country Use of non original spare parts failing to observe the operating instructions Total or partial inobservance of the present manual Not sending of guarantee coupon to faulty construction All defective parts must be returned to the manufacturer for inspection in their technical laboratories and the parts will be replaced The costs involved by taking apart assembly and for the transport are responsibility of the purchaser The guarantee issued by Disan will be valid if the coupon is received by the manufacturer or installer no more than 30 days after the purchase date Replacement parts under guarantee will not be issued if the payment term
7. our clamps for rubber muffs Paper bag User s guide and Guarantee coupon EN EA A Ze Installation template 4417 disan 441 dU quan zem 1 a Dun Every central unit manufactured and packaged in our facility is standing an operational test and certified by every operation 3 Construction scheme Matrix PT Motor Motor protection Disposable bag Cover with quick fix Matrix FF Flat filter Dust container MATIX 4 A Technical data Field of application area up To max tube length max inlet valves TECHNICAL FEATURES Power Motor stage Inlet power supply IE ten tee ele lee Max Vacuum Max air volume Airwatt O 32mm Filtration Filtration surface Housing Dust container capacity Max Noise Level Size Weight Matrix PT m2 130 COl 50 otk 3 4 xs lt a Volt 230 mbar 260 m3 h 220 W 42 Paper Bag m2 3350 ABS O1 dB 59 cm 23x39x49 5 kg 7 9 m2 Stk kW Volt mbar m3 h GM2 dB cm kg Matrix FF 130 carol 3 4 E 1 230 IP55 260 190 378 Flat filter 5200 ABS 3 5 59 23x39x49 5 7 6 5 Installation ATTENTION THE UNDERMENTIONED OPERATIONS MUST BE CARRIED OUT BY QUALIFIED STAFF 5 1 Place of installation The installation of central unit is following to the layout of the piping set by an appointed installer Considering the construction s features
8. s were observed by the purchaser Any disputes will be resolved by the courts in Bolzano Italy 9 2 Coupon of guarantee For the registration of your guarantee fright fill in the coupon on the cover of the present book and insert the data reported on the identification label of your Cleaner Send it within 30 days from purchase 13 MATIX da affrancare zu frankieren to stamp d affranchir isan Zentralstaubsauganlagen Disan GmbH Mitterweg Bozner Boden 13A e 39100 BOZEN Tel 39 0471 971000 Fax 39 0471 978888 info disan com www disan com disan l ESE Timbro e firma del venditore Stempel und Unterschied des Verk ufer Stamp and sign of seller Cachet et signature Data di acquisto Kaufdatum Date of purchase Date d achat Indirizzo e nome dell acquirente Anschrift und Name des K ufers Purchaser s name and address Nom et adresse de acqu reur GARANZIA 24 MESI GARANTIE 24 MONATE GARANTEE 24 MONTHS Y f eX V DOGO V eX MARX 16 gt gt gt disan central vacuum systems Disan GmbH Mitterweg Bozner Boden 13A 39100 BOZEN Tel 39 0471 971000 e Fax 39 0471 978888 info disan com www disan com
9. ugh the template 3 Arrange the plate on the wall 4 Hang the central unit on the wall plate 5 Hang the suction unit the frame MAITRI 5 4 Connection to pipe network 1 Connect with the muff and clamps included the middle side inlet in with piping network 2 Connect with the muff and clamps included the outlet with the exhaust line 3 The silences optional can be connected 2 near the exhaust grid disan 5 5 Electrical connection Before plugging in the central unit make sure that the main power supply correspond to the voltage requirements written on the label which referred to the data on the identification plate The manufacturer declines all responsibility for damages to persons or objects due to an electric system not in compliance with the regulation in force e Connect the low voltage starting cable e Plug in the main electric cable 6 Use of central unit The cleaner is manufactured in order to minimize the output of noise both in the body as in the motor During operation please pay attention to the following advices e Do not allow children to operate the cleaner without surveillance e Do not allow the suction of the handle to come into contact with eyes or ears Do not insert fingers in the handle Pay attention to the ceasing of the cleaner Due to the vacuum pressure in the tubing and in the motor the system remains active for a couple of second after switching it off unit Dis
Download Pdf Manuals
Related Search