BioPak Drying System User Instruction Manual
Contents
1. BIOP Ak 9 2o EVO TIEN BioPak Drying System User Instruction Manual Biomarine Incorporated Biomarine Ntron Inc 456 Creamery Way Exton Pennsylvania 19341 U S A Phone 610 524 8800 Fax 610 524 8807 Web www biopak240R com Document A470346 Revision C B5 06 6000 38 0 January 2011 ECO 9054 A47D346 BioPak 240R Drying System User Instruction Manual Revision C B5 06 6000 38 0 Table of Contents Subject Page Cautions and Warnings Drying System Set Up Maintenance Specifications Warranty Illustrated Parts List oa ON Cautions and Warnings e This product is intended for use with 110 VAC 60 Hz main power as specified on the blower unit Attempts to utilize this product with any other power source will cause damage to the blower motor e Plug dryer into a properly grounded receptacle Always make sure the amperage of the electrical outlet is sufficient for the amperage rating of the dryer It is strongly recommended to utilize GFI protected power outlets Do not use extension cords with this product e This product is not intended for use in any area that may contain explosive or hazardous atmospheres This product is not intended for use submerged in liquid Do not expose to rain or water Do not use product where it can fall into water If dryer falls into water do not reach into water Do not direct the resulting air flow towards the eyes ears or mouth Do not operate without dryer filte2. LACE AT THE SOLE OPTION OF BIOMARINE DEFECTIVE PARTS APPEARING WITHIN THE ONE YEAR PERIOD AS APPLICABLE BIOMARINE SHALL PROVIDE PARTS AT ITS OWN EXPENSE BUT ALL LABOR SHALL BE AT THE EXPENSE OF THE BUYER BIOMARINE SHALL HAVE NO OBLIGATION FOR REPLACEMENT UNLESS 1 BIOMARINE HAS RECEIVED WRITTEN NOTICE OF THE ALLEGED DEFECT WITHIN THIRTY 30 DAYS FOLLOWING THE DISCOVERY OF THE DEFECT OR TWELVE 12 MONTHS FROM THE DATE OF PURCHASE WHICHEVER OCCURS SOONER AND 2 THE BUYER SUBMITS PROOF OF DATE OF PURCHASE WITH INVOICE OR EQUIVALENT DOCUMENTATION AND 3 THE DEFECTIVE GOODS ARE PROMPTLY RETURNED BY BUYER AT THEIR SOLE EXPENSE TO BIOMARINE AT 456 CREAMERY WAY EXTON PA 19341 USA AND 4 THE EQUIPMENT HAS NOT BEEN ALTERED AND 5 THE DEFECT OCCURS UNDER CIRCUMSTANCES OF PROPER USE IN ACCORDANCE WITH ALL INSTRUCTIONS AND MANUALS PROVIDED TO THE BUYER It shall be the responsibility of the buyer to read carefully and abide by all instructions provided to the buyer in the instruction manual or elsewhere If buyer and the employees of the buyer did not abide by such instructions then the alleged defect shall not be deemed to have arisen under circumstances of proper use The instructions for use of the goods reflect the opinion of experts based on field use and tests The instructions should be followed carefully It is impossible however to eliminate all risks inherently associated with the use of the goods Unintended consequences may r
3. dy a BioPak for drying follow the below listed steps 1 Conduct washing and disinfection of the BioPak as directed by the Benchman manual 2 Reassemble the BioPak respirator excluding the moisture sponges and the carbon dioxide scrubbers Moisture sponges should be dried external to the Biopak to insure that they are completely dry before installation into the BioPak for storage This will prevent the formation of mold internal to the BioPak 3 Install the storage plug onto the facepiece adapter of the BioPak and remove the inhalation breathing hose from the BioPak center section lid Disconnect the constant add and demand add feed lines to the center section to prevent blowing water up the lines 4 Position the drying system blower on a level surface away from standing water or liquid away from explosive or hazardous atmospheres and away from contamination sources such as fouled air air laden with dust or particles or air laden with chemicals or solvents 5 Connect the dryer system hose and manifold together Be sure to connect the hose to the blower and not the suction side of the blower unit 6 Remove the number of caps from the drying system manifold ports to equal the number of BioPaks to be dried 7 Connect the loose end of the BioPak inhalation hose to one of the ports of the drying system manifold 8 Plug the power cord of the drying system into a suitable power outlet as specified on the blower unit 9 Turn the blower o
4. eet requirements set forth in this manual 1a 1b Page 6 of 6
5. esult because of factors as weather conditions the presence of other materials or the use or manner of application of the goods all of which are beyond the control of Biomarine The buyer shall assume all such risks Buyer shall be responsible for insuring that the goods are functioning properly at all times and shall not use any goods Which are not functioning properly If buyer uses goods when they are not functioning properly then buyer agrees to defend indemnify and hold Biomarine harmless against all losses damages and injuries to persons or property as a result of the use of the malfunctioning goods These warranties do not extend to the goods if they have been subjected to misuse neglect or accident including extended exposure to direct flames and or caustic chemical products after its delivery to buyer nor does it extend to any item that was modified or altered after its delivery to buyer IN NO EVENT WILL BIOMARINE BE LIABLE FOR ANY LOSS OR DAMAGE DIRECTLY OR INDIRECTLY ARISING FROM THE DEFECTS OR FROM THE USE OF THE GOODS OR FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES WHETHER IN CONTRACT TORT OR OTHERWISE OR FOR PERSONAL INJURY OR PROPERTY DAMAGE OR ANY FINANCIAL LOSS Any description of the goods contained in any documents to which these warranty provisions related including any quotations or purchase orders relating to the goods being delivered to buyer are for the sole purpose of identifying the goods and any such descriptio
6. n Note that actual drying time may vary depending upon factors such as ambient temperature and relative humidity and the level of BioPak saturation 10 When drying is complete turn the blower off and unplug the blower 11 Disconnect the BioPak inhalation hose from the dryer manifold and reconnect to the BioPak center section lid 12 Complete the BioPak turn around maintenance procedures as stated in the Benchman Manual Page 3 of 6 A47D346 Maintenance BioPak 240R Drying System User Instruction Manual B5 06 6000 38 0 Revision C There are no useable serviceable parts in the drying system other than the filters contained within the blower Should air flow become restricted through the blower the filer elements are most likely clogged and need to be cleaned Reference the manual provided with the blower unit for maintenance procedures Specifications Power Air Volume Heat Number of BioPaks Simultaneously Dried Accessories Page 4 of 6 110 120 Vac 60 Hz 41 liters second 86 ft minute MAX None 1106 As proved by blower unit AA7D346 BioPak 240R Drying System User Instruction Manual Revision C B5 06 6000 38 0 Warranty Biomarine warrants subject to the terms below that the goods will be free from defects in design materials and workmanship for a period of one 1 year from the date that the goods are purchased by buyer THE SOLE LIABILITY OF BIOMARINE FOR ALL PURPOSES SHALL BE TO REP
7. n as well as any sample or model which may have been displayed to or seen by buyer at any time have not been made part of the basis of the bargain and have not created or amounted to any warranty express or implied that the goods would conform to any such description or any such sample or model EXCEPT AS SPECIFICALLY SET FORTH IN THESE WARRANTIES BIOMARINE MAKES NO WARRANTIES EXPRESS OR IMPLIED WHETHER ARISING BYLAW CUSTOM CONDUCT OR USAGE OF TRADE INCLUDING WARRANTIES AS TO MERCHANTABILITY OR AS TO THE FITNESS OF THE GOODS FOR ANY PARTICULAR USE OR PURPOSE AND ANY WARRANTIES INCLUDING WARRANTIES AS TO MERCHANTABILITY AND FITNESS FOR PARTICULAR USE OR PURPOSE AND THE RIGHTS AND REMEDIES PROVIDED HEREIN ARE EXCLUSIVE THESE WARRANTIES SHALL RUN TO THE BUYER ONLY AND SHALL NOT BE CONSTRUED AS A CONDITION Biomarine does not warrant that the goods are free from the rightful claim of any third person by way of infringement or patents or other proprietary information or disclaims any warranty against such infringement The terms of these warranties shall apply to the product sold by Biomarine except absorbent filters and anti fog lens inserts which are considered consumable item and as such are not covered by the terms of these warranties No waiver alteration or modification of the terms of these provisions shall be valid unless in writing and signed by an executive officer of Biomarine These warranties shall not apply to accessories o
8. r devices purchased by Biomarine and attached to or made part of the goods except that Biomarine warrants the the installation of such items in the completed product shall so conform to the installation instructions of the manufacturers thereof as not to invalidate such applicable warranties on such items as are obtained by Biomarine from such manufacturers and ji the workmanship incorporated in such installation shall be free from defects Page 5 of 6 AA7D346 BioPak 240R Drying System User Instruction Manual Revision C B5 06 6000 38 0 Illustrated Parts List ITEM QTY PARTNUMBER DESCRIPTION REF P B6 02 5002 86 0 110 120 Vac North American Drying System Complete REF 2 B6 02 5002 87 0 Manifold Assembly Complete 1a 1 B2 06 6001 94 0 110 120 VAC North American Blower Dryer Unit 1b 1 User Supplied Other Power Configuration Blower Dryer Unit 2 7 B2 06 6002 19 0 Turn Key Hose Clamp Small 3 B2 02 7001 90 0 Connection Hose 4 B2 06 6002 30 0 Tum Key Hose Clamp Large 5 1 B6 02 5002 87 1 Replacement Manifold Block 6 6 B2 06 6001 92 0 Manifold Port Cap 7 1 B5 06 6000 38 0 User Manual not depicted Note 1 Complete dryer system includes all depicted components Configured for 110 120 Vac operation with North American power cord and plug 2 Complete manifold assembly includes all depicted components with the exception of the blower unit 3 Blower unit may vary from depiction below 4 User supplied blower units shall m
9. rs in place Keep filters clean as dirty or clogged filters will limit air intake and may damage dryer motor or cause overheating e Use of this product in applications other than its intended use will void the system warranty e Follow instructions provided with the blower unit Page 2 of 6 A47D346 BioPak 240R Drying System User Instruction Manual Revision C B5 06 6000 38 0 Drying System Use This product is capable of simultaneously drying up to six 6 BioPak 240R respirators Drying time will depend upon a number of factors such as ambient temperature ambient relative humidity and the degree of BioPak 240R saturation The drying system utilizes a separately supplied blower The blower supplied is only suitable for connection to power sources of 110 VAC 60 Hz There are no heaters within the drying system so there are no concerns about over heating the BioPak Users in locations that supply power other than specified can purchase their own blower unit to connect the manifold of the dryer system Specifications for the required blower are listed below to aid in the selection of a suitable unit e Air Volume 41 liters second 86 ft minute Maximum Heating Capacity None e Air Flow Blower shall be constructed so that air flow is not through or past motor electrical brushes establish that blower does not blow degraded brush material or any other motor material out exhaust that could become lodged within the Biopak To rea
Download Pdf Manuals
Related Search