Home
SG Standard for Shoes Type Riding Gear with Wheels
Contents
1. adhesives used for underwear nightwear gloves and socks excluding those for infants and toddlers 24 month old or younger Japanese socks wigs fake eyelashes fake beards or sock glue 2 For those for young children materials that have no harmful effect on human body shall be used 5 Check by the methods described below 1 Check by the test method specified by the Section Regarding Formaldehyde in the Appendix 1 of Article 1 of the Ordinance of the Ministry of Health and Welfare No 34 of 1974 based on the Act on Control of Household Products Containing Harmful Substances adhesives used for underwear nightwear gloves and socks excluding those for infants and toddlers 24 month old or younger Japanese socks wigs fake eyelashes fake beards or sock glue 2 Synthetic resin parts as well as parts painted with synthetic resin paint shall conform with the Article 4 Provision on Toys of the Public Notice of the Ministry of Health and Welfare No 370 based on the Food Sanitation Act 5 Indications and User s Manual Indications on the Riding Gear and a user s manual of the Riding Gear shall be as follow s 10 1 Indications 1 Indicate the following 1 Check by eye and hand information on a product using means that do not easily wear off 3 and 4 shall be indicated where easily viewable on the outside surface of packaging as well However they may be omitted if these
2. knee pads elbow pads and gloves b Instructions to use gear while paying sufficient attention to automobiles pedestrians etc and not to use it where its use is prohibited c Instructions to sufficiently practice in a safe place before using and to use it 12 where there is supervision of a guardian this is applied only to those for young children d Instructions to check for any damages and deformations before using and not to use gear if there is any e Instructions to stop using when it feels uncomfortable after wearing gear f Instructions that putting on and taking off of gear shall be done by a guardian and to check that the gear is properly equipped this is applied only to those for young children g Instructions to replace wheels when they are worn out because they tend to sideslip when they are worn h Instructions not to use on wet surfaces because it may cause unexpected sideslips and it is difficult to travel on such surfaces i Instructions to reduce speed by maneuvering gear and to use the brake after speed is sufficiently reduced Gj Because brakes and wheels 13 may become hot right after using instructions not to touch them until they cool down k Instructions to use with sufficient attention because even small obstacles bumps and dips in roads may be causes of fall 1 Instructions to use with sufficient attention because a slight ga
3. check shall be performed after are no backlashes performing the checks under 3 Strength and 4 Durability 6 Fastenings for fixing wheels 6 After removing fastenings as needed and movable parts shall have check by eye that nylon nuts claw nuts a preventive measure against etc are used looseness 7 The Riding Gear shall have a 7 Check by eye brake 2 Friction 2 The static friction coefficient 2 Place the Riding Gear on a stainless steel resistance in the direction perpendicular plate with a smooth surface and from to the direction of rotation of above apply a force which is the sum of wheels limited to those 400N and the gravitational force that acts contacting a road surface on the mass of the Riding Gear Under this shall be 0 3 or more condition and using a push pull gauge etc measure the magnitude of the force generated by horizontally pulling the Riding Gear until it starts moving Measure it five times From the measured values calculate an average value of three forces excluding the largest and the smallest values and calculate the static friction coefficient by dividing with a force to which the average value is added This check shall be performed after performing the check under 4 Durability 3 Check by the methods described below 3 Strength 3 The strength of the Riding Gear shall be as follows 1 1 For those with dedicated shoes the attaching strength of the dedicated sho
4. indications on a product are visible through the outside surface of packaging 1 Name or an abbreviated name of an applicant manufacturer importer etc 2 The year and month of manufacture or importation or their abbreviation 3 Intended user s weight The lower limit of an intended user s age in case of those for young children 4 A size of a shoe or a foot corresponds to gear 5 Precautions for use a Instructions to use helmets knee pads elbow pads and gloves b Instructions not to use gear where its use is prohibited 2 User s Manual 2 Attach a user s manual toa 2 Check that it does not use technical terms product that clearly indicates and it is easily comprehensible for general 11 the following information 1 consumers through 3 shall be indicated where easily viewable such as the cover page etc of a user s manual and make 4 more easily recognizable by placing safety warning marks like A or by other measures Make 4 a through c especially stand out compared to other precautions by using boxed texts bold font and or larger fonts 1 Intended user s weight The lower limit of an intended user s age in the case of those for young children 2 A size of a shoe or a foot corresponds to gear 3 Instructions to make sure to read the user s manual and to keep it after reading 4 Precautions for use a Instructions to use helmets
5. SG Standard for Shoes Type Riding Gear with Wheels 1 Purpose The purposes of this standard are to set requirements for the quality of safety of shoes type riding gear with wheels and for the prevention of incorrect use by consumers and to prevent damages on general consumers bodies and to ensure safety of life 2 Scope of Application This standard is applied to the gears and similar products which have been equipped with shoes or are intended to be used by fixing shoes to them are intended to be used by a single user are driven only by human strength travel by the rotation of wheels hereinafter collectively the Riding Gear and do not correspond to any of the following Products designed to be used on non paved road Products with drive system such as chains and belts 3 Categorization Categorization of the Riding Gear is as follows For Young Children Products intended to be used by those who are 18 months or older and who weigh less than 20kg For Children Products intended to be used by those who weigh 20kg or more and less than 50kg For General Use Products intended to be used by those who weigh 20kg or more and less than 100kg 4 Quality of Safety The quality of safety of the Riding Gear shall be as follows 1 Appearance 1 Appearance and structure of 1 Check by the method described below and structure the Riding Gear shall be as follows 1 It has a smooth finish 1 Check by eye hand etc This chec
6. ct the use when the Driving Mechanism is operated as specified in Table 8 Table 8 Number of Operation Operation Method For Have the Driving Category Young Mechanism Children operate for 5 000 times using a force by which the operation is completely performed or a Item Standard force of 200N whichever is smaller For Children Have the Driving Mechanism operate for 5 000 times using a force by which the operation is completely performed or a force of 500N whichever is smaller For General Use Have the Driving Mechanism operate for 5 000 times using a force by which the operation is completely performed or a force of 1 000N whichever is smaller 3 In case of movable parts other than the Driving Mechanism that have points which bear force due to a user s weight when traveling there shall be no damages that affect the use when these points are repeatedly operated for 5 000 times Checking Method 3 Check by eye and hand 5 The materials for the Riding Gear shall be as follows 1 For those with dedicated shoes for which fiber is used inside of the shoes the materials shall conform to the Section Regarding Formaldehyde in the Appendix 1 of Article 1 of the Ordinance of the Ministry of Health and Welfare No 34 of 1974 based on the Act on Control of Household Products Containing Harmful Substances
7. es shall be 1 000N or more Also after removing the force there shall be no damages on each part that affect the use 2 For those without dedicated shoes the attaching strength of belts etc for attaching shoes shall be as shown in Table 1 Also after removing the force there shall be no damages on each part that affect the use Table 1 Attaching Strength of Belts Etc Magnitude of Belt position Strength Other than 400N or more the rearmost part Rearmost 500N or more part 2 There shall be no damages that affect the use when the impact energy specified in Table 2 is applied to the frontal part of traveling 1 1 Check by fixing the frame of the Riding Gear and applying a force of 1 000N ata speed of 20mm min 2 Check by fixing the Riding Gear applying the force specified in Table 1 to a belt at a speed of 20mm min and then removing the force 2 Check by making the Riding Gear swing like a pendulum while using a pole as its axis hitting a test wall with the Riding Gear and applying an impact energy as shown in Figure 2 direction if there is a removable brake attached in the front apply it after removing the brake If there is a brake in the front the brake shall not come off when the impact energy specified in Table 3 is applied to the brake Table 2 Frontal Impact Energy Impact Category iets For young 38J children For childre
8. in Table 6 onto a surface to which a shoe is fixed 100mm Ld Figure 4 Shape of Weight Table 6 Mass and Drop Height of Weight Category Mass of Drop Weight Height For 10kg 150mm Children For 15kg 250mm General Use Figure 5 Fall Position 4 Durability 4 The durability of the Riding 4 Check by the methods described below Gear shall be as follows 1 There shall be no damages 1 Place the Riding Gear on the test drum that affect the use when attach obstacles to the test drum as making the Riding Gear travel shown in Figure 6 with the wheels for three hours with the contacting the drum and with the weight weight specified in Table 7 of the specified mass in Table 7 placed on fixed to it the Riding Gear Next check by rotating the test drum at a speed equivalent to the Table 7 Mass of Weight Riding Gear s traveling speed of approx Mass of 0 5m sec and making the Riding Gear Category Weight travel in a way that it passes the obstacles For Young 20kg every 1 5sec Children For Children 40kg For General Use 60kg Rotation of direction of a drum Figure 6 Shape of Obstacle 2 For those with a mechanism 2 Check by eye and hand by which they obtain a driving force using the movement of parts etc which fix frames or wheels hereinafter the Driving Mechanism there shall be no damages that affe
9. k shall without sharp points burrs be performed after performing the checks cracks scratches under 8 Strength and 4 Durability deformation etc that may cause physical injury when used 2 Sharp points such as bolt 2 Sharp points such as bolt heads with a heads protruding from the cross sectional area of 100mm or less that outside surface shall be protrudes 10mm or more to the outside located where users do not surface shall be located where it does not touch contact a test cylinder with a diameter of 50mm and a length of 75mm as shown in Figure 1 A head of a bolt with a cross sectional 100mm or less that is protruded 10mm or Figure 1 Method for Checking a Sharp Point Using a Test Cylinder 3 Those with dedicated shoes 3 Check by eye hand etc This check shall shall not have any sharp be performed after performing the checks points protruding inside of under 3 Strength and 4 Durability the shoes or any parts that excessively compress feet 4 In case of movable parts 4 Check by scale etc This check shall be excluding fastenings of performed after performing the checks those for young children under 3 Strength and 4 Durability where two or more parts are connected the gap between these two or more parts shall not be 5mm or more and less than 12mm 5 Connection assembly etc of 5 Check by eye hand manually moving etc each part are fine and there This
10. n 90J For general use 135J Figure 2 How to Apply Frontal Impact Energy Table 3 Frontal Brake Impact Energy Impact Category nergy For young 25J children For children 60J For general use 90J 3 There shall be no damages 3 Check by making the Riding Gear swing that affect the use when the like a pendulum while using a pole as its impact energy specified in axis hitting a test wall with the Riding Table 4 is applied to the Gear and applying an impact energy as bottom of wheels shown in Figure 3 If there is a brake at the rear the brake shall not come off when the impact energy specified in Table 5 is applied to the brake Table 4 Bottom Impact Energy Category Tapie Energy For young 38J children For children 90J For general use 135J Table 5 Rear Brake Impact Energy Impact Category ack For young 14J children For children 30J Figure 3 How to Apply Bottom Impact For general use 50J Energy 4 In case of those other than 4 Check by dropping a weight specified in Figure 4 and Table 6 from the height specified in Table 6 onto the position for young children and those without dedicated shoes there shall be no damages specified in Figure 5 which is on the thataffct these when the surface to which a shoe is fixed weight specified in Table 6 is dropped from the height specified
11. p may be a cause of fall 5 How to use maintain inspect and store a Parts which especially require maintenance including replacement of expendable parts as well as maintenance methods b Parts which especially require inspection inspection methods as well as how to handle defects c Information particularly necessary for the purpose of storing 6 Statement that the SG Mark system is a compensation system for bodily injury caused by defects of this product 14 7 Name address and phone number of a manufacturer importer or distributor 15
Download Pdf Manuals
Related Search
Related Contents
Denon PUREPROGRESSIVE DVD-3800 User's Manual User Manual - The UK Mirror Service ESTIME DE SOI / PARENTS / MODE D`EMPLOI BakkerElkhuizen The Egg Ergo USER'S MANUAL - Icon Heath & Fitness FCModeler User`s Manual Overhead Door Corporation Phonix S7100BCB mobile phone case 取扱説明書 file_642_removedor de salitre Copyright © All rights reserved.