Ultra Thin Micathermic Heater User Manual
Contents
1. damages or do not allow limitation on implied warranties the above limitations and exclusions may not apply to you This warranty gives you specific legal rights and you may also have other rights that vary from state to state For Technical Support and Warranty Service Please Call 888 876 5387 Or Write To Soleus International Inc 20035 E Walnut Dr North City of Industry CA 91789 USA www soleusair com 102. either repair or replace it free of charge within a reasonable time after the unit is returned during the warranty period As a condition to any warranty service obligation the consumer must present this Warranty Certificate along with a copy of the original purchase invoice THIS WARRANTY DOES NOT COVER e Damage accidental or otherwise to the unit while in the possession of a consumer not caused by a defect in material or workmanship e Damage caused by consumer misuse tampering or failure to follow the care and special handling provisions in the instructions e Damage to the finish of the case or other appearance parts caused by wear e Damage caused by repairs or alterations of the unit by anyone other than those authorized by Soleus Interna tional Inc e Freight and Insurance cost for the warranty service ALL WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE LIMITED TO ONE YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY SOLEUS INTERNATIONAL INC DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT SHALL SOLEUS INTERNATIONAL INC S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS UNIT This warranty covers only new products purchased from our authorized dealers or retailers It does not cover used sal vaged or refurbished products As some states do not allow the limitation or exclusion of incidental or consequential
3. E WASHER WHEEL BASE MICATHERMIC HEATER OPERATING INSTRUCTIONS CONTROL PANEL 1 Place the heater on a firm level surface and plug into a grounded 120V 60Hz power outlet Only operate heater in upright position with caster wheels attached Turn on the heater and select a heat setting On the control panel turn the POWER SELECT dial to the desired setting LOW 500W HIGH 1000W Adjust the thermostat by turning the THERMOSTAT dial on the control panel You will hear a faint click noise when the thermostat is turned to a point above the current room temperature Continue to turn the thermostat to increase the room temperature If the area becomes too warm turn the THERMOSTAT dial down slightly until you reach a point where the temperature is more comfortable Once you have chosen the desired temperature the heater will remain on until the room temperature increases to the temperature set on the THERMOSTAT dial The heater will cycle on and off to maintain the desired room temperature The power indication light will cycle on and off with the heater When the heater is in heating mode the light will turn on When the heater is in standby mode the light will turn off Unplug the heater when not in use POWER INDICATION LIGHT POWER SELECT DIAL THERMOSTAT DIAL TTT OPERATING INSTRUCTIONS CONTINUED OPTIMAL OPERATING CONDITIONS To get the most out of your Soleus Air Micathermic heater follow these helpful
4. HM1 10 32 Ultra Thin Micathermic Heater lb Intertek 309402 Model No HM1 10 32 Thank you for choosing a Soleus Air Micathermic heater This owner s manual will provide you with valuable information necessary for the proper care and maintenance of your new product Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new Soleus Air Micathermic heater For your own records please attach a copy of your sales receipt to this manual Also write the store name location date purchased and serial number below Store Name Location Date Purchased Serial Number located on back of unit O ee ey IMPORTANT INSTRUCTIONS Before using your Soleus Air personal heater please read this owner s manual carefully Store this manual in a safe place for future reference 1 Read ALL instructions before using this unit 2 CAUTION Risk of Electric Shock DO NOT open or try to repair the heater yourself 3 This heater is hot when in use To avoid burns DO NOT let bare skin touch hot surfaces If provided use handles when moving this heater 4 Keep combustible materials such as furniture pillows bedding paper clothes and curtains at least 3 ft from the front of the heater and keep them away from the sides and rear DO NOT place towels or other objects on the heater 5 Extreme caution is necessary when any heater is used by or near c
5. erse the heater in water Wait until the unit is completely dry before use STORAGE Store the heater in a cool dry location when not in use If available use the retail packaging and pack up the heater to prevent dust from collecting on and inside the heater TROUBLESHOOTING If the heater will not operate please check the following before seeking repair of service 1 2 3 Check if the power cord is plugged into an electrical outlet if not plug in Check if electricity to the main fuse is working Check if the heater is set to ON by confirming the light on the control panel is lit If not turn the POWER SELECT dial to LOW or HIGH to turn on the unit Check if the heater is on a level surface If the tip over safety mechanism inside the heater is engaged the heater will not run The room temperature has reached the temperature on the manual thermostat Increase the temperature on the thermostat so the heater will continue operation or wait for the room temperature to drop below the set temperature on the heater D WARRANTY One Year Limited Warranty Soleus International Inc warrants the accompanying Soleus Air heater to be free of defects in material and workman ship for the applications specified in its operation instruction for a period of ONE 1 year from the date of original re tail purchase in the United States If the unit exhibits a defect in normal use Soleus International Inc will at its option
6. hildren or the disabled or when the heater is left operating and unattended 6 DO NOT operate any heater with a damaged cord or after the heater malfunctions has been dropped or damaged in any manner Return heater to authorized service facility for examination electrical or mechanical adjustment or repair 7 This heater is not intended for use in bathrooms laundry areas and similar indoor locations NEVER locate heater where it may fall into a bathtub or other water container To protect against electrical hazards DO NOT immerse in water or other liquids 8 DO NOT touch the control panel or plug with a wet hand DO NOT run cord under carpeting DO NOT cover cord with throw rugs runners or similar coverings Arrange cord away from traffic area and where it will not be tripped over 10 DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater 11 To prevent a possible fire DO NOT block air intakes or exhaust in any manner DO NOT use on soft surfaces like a bed where openings may become blocked 12 A heater has hot and arcing or sparking parts inside DO NOT use in areas where gasoline paint explosive and or flammble liquids are used or stored Keep unit away from heated surfaces and open flames 13 Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire However if you have to use an exte
7. hints 1 All electric heaters are limited to maximum of 1500 watts per UL and ETL requirements Due to this limitation all electric heaters can heat approximately 150 square feet Micathermic heaters fit in this category but they are able to provide a more comfortable and consistent heat than other heating technologies 2 For optimal performance place the heater in a room and close all windows and doors This will confine the heat to the area that needs it most 3 To save energy and in turn save money in the winter place the heater in a room or area that needs extra heat instead of raising the thermostat on your central heating system This heater will function very well as an additional heating source and can easily maintain the temperature in most rooms and attached bathrooms There is no need to increase the heat in the entire house when you only need comfort in the room in which you are currently located The HM1 10 01 amp HM1 10 32 produce 1000 watts maximum el MAINTENANCE 1 2 Unplug the unit and let it cool completely To keep the heater clean the outer shell may be cleaned with a soft damp cloth You may use a mild detergent if necessary After cleaning dry the unit with a soft cloth CAUTION DO NOT let liquid enter the heater DO NOT use alcohol gasoline abrasive powders furniture polish or rough brushes to clean the heater This may cause damage or deterioration to the surface of the heater DO NOT imm
8. ian Do not attempt to mod ify the plug in any way DO NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED PLUG WARNING It is normal for the power cord to feel warm to the touch however a loose fit between the outlet and the plug may cause overheating of the plug If this occurs try inserting the plug into a different outlet Contact a qualified electrician to inspect the original outlet for damage IN THE BOX e MICATHERMIC HEATER e 2 LARGE SPRING WASHERS e INSTRUCTION BOOKLET e 2 STANDARD SCREWS e 2 WHEEL BASE e 4 WHEEL SCREWS e 4 WHEELS e 4 SMALL SPRING WASHERS e 2 LARGE WASHERS e 4 SMALL WASHERS E E PRODUCT DIAGRAM CARRYING HANDLE CONTROL DIALS WHEEL BASE WHEELS Deel ASSEMBLY 1 Remove the heater body two wheelbases wheels screws and washers from the box Remove the pack aging materials and keep for future storage 2 Attach the wheels to each wheelbase with the supplied wheel screws small spring washers and small washers WHEEL SCREW f WHEEL SMALL SPRING WASHER o SMALL WASHER WHEEL BASE 3 Be certain the heater is unplugged and the controls are set to off Set the heater on the floor upside down 4 Attach a wheel base with wheels attached to each end of the heater body using the supplied standard screws large spring washers and large washers STANDARD SCREW a LARGE SPRING WASHER _ lt LARG
9. nsion cord the cord shall be Nol6 AWG minimum size and rated not less than 1500W 14 To avoid fire or shock hazard plug the unit directly into a 120 V AC electrical outlet 15 To disconnect heater turn controls to OFF then remove plug from outlet Pull firmly on the plug DO NOT unplug by pulling on the cord 16 Always unplug the unit before moving or cleaning or whenever the heater is not in use 17 Use only for intended household use as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons The use of attachments not rec ommended or sold by unauthorized dealers may cause hazards 18 Always use on a dry level surface 19 DO NOT use outdoors 20 WARNING To reduce the risk of fire or electric shock DO NOT use this unit with any solid state speed control device 21 DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit Doing so will void your warranty The inside of the unit contains no user serviceable parts Qualified personnel should perform all servicing only 22 Connect to properly grounded outlets only 23 SAVE THESE INSTRUCTIONS PRODUCT INFORMATION amp SPECIFICATIONS Micathermic heating technology combines two popular heating technologies to create the ideal room heater Using radiant and convection heat Micathermic heaters are able to achieve full power within minutes and provide a consistent and c
10. omfortable silent heat without causing dry spots Voltage Rating 120 V 60Hz 8 5 8 inches W x 18 inches D x 26 inches H Unit Weight 8 8 lbs DISCLAIMER ALL INFORMATION AND THE TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER S MANUAL ARE THE PRESENTATION OF THE MANUFACTURER SOLEUS INTERNATIONAL HAS NOT CONDUCTED INDEPENDENT TEST TO THE INFORMATION AND THE SPECIFICATIONS PRESENTED HEREWITHIN i SAFETY FEATURES Tip Over Safety Feature This heater is equipped with a tip over safety feature Once the heater is tipped over an internal switch will automatically shut the heater off Once the heater is restored to an upright position the heater will reset To continue operation turn on the heater using the control panel on the heater Overheat Safety Feature This heater is equipped with a overheat safety feature When the heaters internal components reach a certain temperature that could cause overheat and possible fire the heater will automatically shut off The heater will automatically reset itself once the internal temperature decreases to acceptable levels POLARIZED Polarized Plug POLARIZED PLUG OUTLET Warning This appliance has a polarized plug one blade is wider than the other To reduce the risk of electric shock this plug is intended to fit into a polar 1 ized outlet only one way If the plug does not fit fully into the outlet reverse the plug If it still does not fit o contact a qualified electric
Download Pdf Manuals
Related Search