yakima whispbar roof racks k546 fit kit installation instructions help
Contents
1. K546 CELLS Fitting Kit GB Fitting Instruction for Accessory i a p zd p 2 ia x B X 1 p X 2 i d d X 11 04 257 Revision No 1 0 Fitting Kit 546 First Time Installation 8 Remove parts from packaging and check contents Contact your Prorack dealer if parts are missing or damaged EI i E his kit fits type A B C and D These instructions show type A crossbar fitted They also apply to type B C and D uw D NOTE Clamp images in these instructions may not be representative of the clamps in this kit Fitting Kit 546 Use keys to remove covers pc Use hex screwdriver to reverse adjusting screw 10 turns Press adjusting screw and pull crossbar legs out Refer to the crossbar instructions for crossbar adjustment Ensure each end of the crossbar is adjusted equally Fitting Kit 546 Remove locking screw Apply protective strip as shown Trim if required It is important to put the clamps in the correct position on the vehicle Letters refer to the part numbers stamped on clamps rv E ums UN i o 0o Clamp Part Number 734A 9 B 735A VY 0 at C 736A Fitting Kit 546 Attach clamp to each leg NOTE clamps may have labels showing their positions on the vehicle For example Front Right Refit loc2. king screw so that it goes through the hole in the clamp Do not begin to tighten the locking screw Refer to the underside of the pad for the part number Fitting Kit CB K546 It is important to put the pads in the correct position on the vehicle Letters refer to the pad part numbers and position Pad Part Number A 11 04 256 11 04 257 11 04 244 Fit rubber pads supplied with fitting kit to foot Pad may vary in shape to that shown Make sure the pad fits into the holes underneath the foot Fitting Kit 546 n s AQ Fitment Clamps directly to edge of roof under the doors Please check the rear of this manual for information relating specifically to your vehicle Place crossbar on vehicle Minimum recommended spacing between the bars is 700mm unless otherwise stated Adjust the legs on the crossbar so that they are positioned equally from the ends of the crossbar and the clamps engage firmly on the body work of the vehicle Tighten adjusting screw to 5 Nm Fitting Kit 546 Tighten locking screw on both legs evenly Check crossbar is securely attached to the vehicle Use keys to fit and lock covers
Download Pdf Manuals
Related Search