600 Amp Battery Jumper
Contents
1. owner s manual before attempting to start the vehicle to determine if external starting assistance can be used Failure to follow these instructions may cause damage or explosion Use safety glasses to protect eyes while jump starting a battery l Turn off the vehicle ignition and all accessories e g radios lights air conditioners and cellular phones Set the emergency brake and put vehicles with automatic transmission in park position Determine the polarity of the vehicle s battery terminals The positive POS P battery terminal usually is larger in diameter than the negative NEG N terminal If you are unsure you should refer to the vehicle owner s manual fA WAGAN www wagan com User s Manual Read before using this equipment 4 Determine whether your vehicle uses a negative or positive grounded system Negative ground system negative battery terminal is grounded to chassis Most vehicles use this system Positive grounded battery terminal is grounded to chassis or any other part of the vehicle IF YOU ARE UNSURE YOU SHOULD REFER TO VEHICLE OWNER S MANUAL Remove clamps from the holders Never allow clamps positive amp negative terminals to touch together or contact the same piece of metal to prevent short circuits and arcing Follow instructions for a negative grounded system or positive grounded system as indicated below Negative Grounded System a Securely connect2. J WAG AN ltem 2509 T E C H 600 Amp Battery Jumper with Air Compressor User s manual Read these instructions before using the unit 600 Amp Battery Jumpstarter by Wagan Tech Features Front LED Worklight Worklight Switch USB Power Ports and on off Switch 12V DC Port LED Status Indicators Battery Check Button Air Hose Charging Jack Jumper Cable Back Air Compressor Switch Air Compressor Gauge Safety Switch Air Hose Compartment fA WAGAN www wagan com User s Manual Read before using this equipment Thank you for purchasing 600 Amp Battery Jumpstarter by Wagan Tech With normal care and proper treatment it will provide years of reliable service Please read all operating instructions carefully before use IMPORTANT Before using this unit read and understand all instructions included in this manual also those published by your vehicle s battery manufacturer and the manual of any other device intended to be used with this unit Failure to follow all listed instructions may result in electric shock fire and or serious personal injury Save these instructions for future reference GENERAL SAFETY RULES e This product is not a toy Keep out of the reach of children e Wear complete eye and clothing protection Do not touch eyes while working near battery e Do not operate this unit in or around water Water can damage the unit e Remove metal personal j
3. TION Excessive engine cranking can damage vehicle starter motor If the engine turns but fails to start after several attempts other technical problems might be involved Discontinue cranking the engine until the other problems have been determined and corrected 9 When finished turn OFF the safety switch stand as far away from the vehicle battery as possible and disconnect the clamps in reverse sequence to connecting procedure e For negative grounded systems first disconnect negative black then positive red clamps e For positive grounded systems first disconnect positive red then negative black clamps DC Power Port The DC Power Port accessory socket is located to the right front side of the unit The port can power a DC load of up to 11 Amps Overloading the port may result in tripping a self resetting circuit breaker Removing the overload automatically restores power to the DC Power Port 1 Uncover the dust cover from the Power Port Insert the 12V DC accessory plug into the Power Port Set On Off safety switch to the ON position Operate the appliance as usual After use turn OFF the safety switch Oo On KR W N Disconnect the accessory plug from the DC Power Port and store the accessory fA WAGAN www wagan com User s Manual Read before using this equipment 7 Replace the Power Port s dust cover 8 Recharge the Jumper as soon as convenient USB Power Port Two
4. USB power ports located underneath the LED work light can power charge devices that require 5V at up to 2 1 Amps through the use of a user supplied cable 1 To use the USB ports connect the USB device to one of the USB ports and press down the USB ON OFF switch once to power ON the USB port The USB power indicator LED will light up 2 When finished disconnect the device from the USB port on the jumper and press down the USB ON OFF switch once to power OFF the USB port The USB power indicator LED will turn off 3 Recharge the jumper as soon as convenient Storage This unit may be stored in any position Make sure the clamps are secure inside the booster cable storage covers Store at room temperature If not used for a prolonged period of time recharge every 2 months in the winter and every month in the summer Specifications 15AH sealed lead acid Power Supply DC Output 12 volts nominal Power Supply Battery Power Supply Charging Time 38 hours for the first time charging with AC charger e 34 hours to recharge with AC charger e 14 hours to recharge with 12 volt DC charger Storage Store in a cool dry area 2011 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation WAGAN Corp Limited Warranty All WAGAN Corporation products are warranted to the original purchaser of this product Warranty Duration This product is warranted to the ori
5. epairs by unauthorized personnel or other causes not arising out of defects in materials or workmanship This warranty is effective only if the product is purchased and operated in the USA and does not extend to any units which have been used in violation of written instructions furnished Warranty Disclaimers This warranty is in lieu of all warranties expressed or implied and no representative or person is authorized to assume any other liability in connection with the sale of our products There shall be no claims for defects or failure of performance or product failure under any theory of tort contract or commercial law including but not limited to negligence gross negligence strict liability breach of warranty and breach of contract Warranty Performance During the above one 1 Year warranty period a product with a defect will be replaced with a comparable model when the product is returned to WAGAN Corporation with an original store receipt The replacement product will be in warranty for the balance of the one 1 Year warranty period REV2008 pe WAGAN www wagan com customerservice wagan com U S amp Canada Toll Free 1 800 231 5806 Tel 1 510 471 9221 31088 San Clemente Street Hayward CA 94544 U S A 2011 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation REV20110629
6. ewelry such as rings bracelets necklaces and watches while working with a lead acid battery these items could produce a short circuit that may cause severe burns e Do not operate this device while wearing vinyl clothing Static electricity may be generated when vinyl clothing is rubbed e Keep battery terminals clean Be careful to keep corrosion from coming in contact with eyes Service e This product has no consumer serviceable parts e Do not attempt to remove or replace the battery used in this device When the battery has reached the end of its useful lifetime take the entire unit to a battery recycling facility 2011 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation 600 Amp Battery Jumpstarter by Wagan Tech SPECIFIC SAFETY RULES e This product is not intended for use in the rain or temperatures above 130 F e Do not let the cords of the jumpstarter or attached appliances get wet e Never allow clamps positive amp negative terminals to touch together or to connect the same piece of metal to prevent short circuits and arcing e Never work alone with this product Make sure that someone is available to give assistance if needed e Use only the provided chargers cables and clamps Unauthorized parts may damage the unit e For proper and safe operation of the 12 Volt DC power accessory outlets do not place anything into it except the plug of the acces
7. ginal purchaser for a period of one 1 Year from the original purchase date to be free of defects in material and workmanship WAGAN Corporation disclaims any liability for consequential damages In no event will WAGAN Corporation be responsible for any amount of damages beyond the amount paid for the product at retail In the event of a defective item please contact WAGAN Corporation at 800 231 5806 to obtain a Returned Merchandise Authorization number RMA and return instructions Each item returned will require a separate RMA After you have received the RMA and the return instructions from WAGAN Corporation please follow the instructions and send the item with PREPAID SHIPPING along with all of the required documentation a complete explanation of the problem your name address and daytime phone number WAGAN Corporation will at its option replace or repair the defective part A Returned Merchandise Authorization number RMA is REQUIRED when sending in any defective item WAGAN Corporation is not responsible for any item s returned without an official Returned Merchandise Authorization number The item s must be returned with prepaid shipping WAGAN Corporation is not responsible for any shipping charges incurred in returning the item s back to the company for repair or replacement This warranty is void if the product has been damaged by accident in shipment unreasonable use misuse neglect improper service commercial use r
8. ramp or dock since the electrical cords and outlets used for charging could cause severe electrical shock if they get wet e t is recommended that the unit be in an upright position while charging NOTE Make sure both cable clamps positive and negative are placed in their storage holsters when not in use Charging with the AC Charger 1 Insert AC charger plug into charging jack of the unit 2 Insert AC charger receptacle plug into AC receptacle 2011 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation 600 Amp Battery Jumpstarter by Wagan Tech 3 Fully charges the unit to the following e Initial and first time charge 38 hours continuously e Recharge or between use around 34 hours continuously 4 When charging is complete unplug the AC charger receptacle plug then the AC charger from the charging jack on the unit Charging with the 12 Volt DC Charger l 2 3 Insert DC charger plug into charging jack of the unit Insert DC charger accessory plug into vehicle cigarette lighter socket Fully charge the unit for around 14 hours continuously while the engine is running When charging is completed unplug the DC charger accessory plug first and then the DC charger from the charging jack on the unit Jumpstarting a Vehicle WARNING Vehicles equipped with on board computers may be affected if the engine battery is jump started Read your vehicle
9. sory to be used Description of Functions Jump Starter e 600 peak amps auto jump starter e Powerful rechargeable 15AH sealed lead acid battery e Heavy duty booster clamps e Extra long 28 6 gauge booster cables DC Power Source e 1 DC power outlet with overload protection for 12V appliances e 110 Volt charger for home use USB Power Source e 2 USB power ports with 2 1 Amp output to power and recharge most USB devices such as tablets MP3 players cell phones and more fA WAGAN www wagan com User s Manual Read before using this equipment Other Features e 30 LED built in work light e Battery status indicator lights e Built in safety features to prevent sparking e Ideal for cars vans SUVs trucks boats and more Charging and Recharging WARNING Do not overcharge this unit Prior to charging unit read and understand all instructions on this manual Overcharging may result in damage to the unit e This product may arrive partially charged from the manufacturer It is recommended to fully charge the unit immediately after purchase and before using for the first time e The red charging LED indicator will be illuminated while the unit is charging After charging period is completed push the Battery Indicator Button and thethree LED battery lights should light up The battery is now fully charged e Do not charge the unit for more than 48 continuous hours e Do not charge the unit on a boat boat
10. the positive red clamp to the positive POS P terminal of the vehicle battery or the remote positive terminal if equipped b Securely connect the negative black clamp to the vehicle chassis engine block or a non moving metal part of the vehicle which is verified to be grounded Do not clamp directly to negative battery terminal carburetor tuel lines or sheet metal body parts c See jump starting step 7 to continue Positive Grounded System a Securely connect the negative black clamp to the negative Neg N ungrounded terminal of the vehicle battery b Securely connect the positive red clamp to the vehicle chassis engine block or a non moving metal part of the vehicle which is veritied to be grounded Do not clamp directly to positive battery terminal carburetor fuel lines or sheet metal body parts c See jump starting step 7 to continue 2011 Wagan Corporation All Rights Reserved Wagan Tech and wagan com are trademarks used by Wagan Corporation 600 Amp Battery Jumpstarter by Wagan Tech 7 Turn on the safety switch and allow 2 to 3 minutes of charging time It is recommended to have a second person to assist holding the unit securely in place during the next steps 8 Turn on the vehicle to attempt to start the engine Stop if the vehicle does not start after 4 to 5 seconds of engine cranking Wait 3 to 4 minutes then try again Repeat several times until the vehicle starts CAU
Download Pdf Manuals
Related Search