SK5 user manual inside _110610
Contents
1. 01 low or 02 loud and then press to confirm Press again to exit system Care amp Maintenance other chemical agents Use Alkaline batteries only 5 beeps in a row il 2 3 User PIN Setup Press the reset button twice to enter setup mode Input administrator code and then press Await for a beep sound and then press 01 or 02 to 09 Press the intended PIN consists of 4 6 digits and then press to confirm Press again to exit system Passage mode Enter the pin press gt gt o then press to cancel Temporary PIN Setup Press the reset button twice to enter setup mode Input administrator code and then press Await for a beep sound and then press 10 Press the intended temporary PIN consists of 4 6 digits and then press to confirm Press again to exit system Default Setup Press and hold the reset button for up to 3 seconds until you hear a long beep which indicates that all users have been deleted Low Battery Alert Normal operation accompanied with 5 beeps in a row Please change batteries Pin code memory function No need to set up pin codes after battery replacement Administrator code user pin codes or temporary pin cannot be set as 000000 111111 or 123456 To preserve the appearance of the product wipe down using a clean cloth Do not use alcohol or Exterior Plate Interior Plate Battery Cover Key Hole2. Reset Button 7777777 Emergency Mechanical Key Installation If the door is not bored use the attached template and follow instructions on it If the door is borned skip Step A and proceed to Step B Insert latch a into the door Use a Phillips screwdriver to tighten the screws b x 2 being careful not to overtighten Insert the square spindle c through the door and latch a Connect the wires f x 2 Connect the two plates and tighten screws g x 2 into pipes d x 2 Remove battery cover h and install 4 AA batteries Place strike plate k on door frame and tighten screws b x 2 with screwdriver
3. SK5 User Instructions 1 Unlock Methods Unlock by PIN 2 Unlock by Mechanical key Remove the key hole cover and then unlock by key Three types of pin codes 1 The default administrator pin code 1 set required before any type of code change 2 User PIN 10 sets 3 Temporary PIN 1 set expires aftr 1 time use Door Lock Status Status Status sounds Operation Success 1 2 O1 PON Rh Operation Failure Sounds 1 beep Low Battery Enter Exit Setup 3 beeps Administrator code Setup Press the reset button twice to enter setup mode Input factory default administrator code 111111 and then press Await for a beep sound and then press 00 Press the intended new administrator code consists of 4 6 digits and then press to confirm Press again to exit system It is strongly advised that setting up the administrator code immediately upon receiving this product is important Code Deletion Press the reset button twice to enter setup mode Input administrator code and then press Await for a beep sound and then press the code you intend to delete twice 01 01 or 02 02 to 09 09 then press to confirm Press again to exit system Volume Setup Press the reset button twice to enter setup mode Input administrator code and then press Await for a beep sound and then press 99 Press 00 mute
Download Pdf Manuals
Related Search